M.Ing. (Mechanical Engineering) / The purpose of this study was to investigate the accuracy of SOAP84-simulations of delay and percentage stops at isolated signalized intersections. In the application, capacity was distinguished in terms of lane configuration only. Results at the intersections showed SOAP overestimating both delay and percentage stops by as much as 100%. It is recommended that the same investigations be repeated with more accurate information on the capacity of the intersections.

Exclusive bus lanes and the Transit Signal Priority are often not effective in saturated peak-traffic conditions. An alternative way of providing priority for transit can be queue jumpers, which allows buses to bypass and then cut out in front of waiting queue by getting an early green signal. Utah Transit authority deployed Bus Rapid Transit system at Salt Lake County, Utah along W 3500 S. This research evaluates the impacts of queue jumpers with TSP on Bus Rapid Transit (BRT) and private vehicular traffic. Four VISSIM models were developed for analysis : Basic scenario, no TSP with queue jumpers, TSP with no queue jumbers, and TSP with queue jumpers. In TQ scenario travel time was reduced between 13.2-19.82% with respect to basic scenario. At the same time, travel time of private traffic increased very little 0.38-3.28%. Two TSP strategies : green extension and red truncation are implemented in this research work. / by R.M. Zahid Reza. / Thesis (M.S.C.S.)--Florida Atlantic University, 2012. / Includes bibliography. / Mode of access: World Wide Web. / System requirements: Adobe Reader.

Traditional intersections have always caused congestion, delay, and accidents. There are numerous geometric intersection designs that best fit each situation. This study performed an operational and safety comparison with unsignalized/signalized offset, Tintersections, a two-lane roundabout, and a modified roundabout to decrease the overall travel delay and increase the safety using a case study. Using data from a government source, all designs were tested in a calibrated micro simulation model and traffic signals were optimized using a signal optimization platform. Each design was tested with various balancing schemes, left turn percentages, and hourly volumes to determine the failure point. The unsignalized/signalized offset T-intersections, two-lane roundabout, and modified roundabout were compared by throughputs, travel delay, and travel time. After analysis, it was determined that the modified roundabout performed the best out of any design. All approaches had minimum travel delay while reducing the number of conflict points considerably with the modified roundabout. / Includes bibliography. / Thesis (M.S.)--Florida Atlantic University, 2014. / FAU Electronic Theses and Dissertations Collection

The rapidly and significantly growth of the population in the United States has caused expansion of the urban areas to accommodate more residential facilities.. Thus, the demand for more efficient intersection designs is a high priority, as wasted fuel and travel time increases each year. A new method to solve the congestion issue is the creation of unconventional arterial intersection designs (UAID). The objective of this study is to compare the operational and environmental performance of three UAIDs called Left-turn Bypass, Diverging Flow, and Displaced Left-turn intersections. This study will evaluate the UAIDs in the isolated manner and then compare the intersections in a network using an existing corridor in the state of Florida. The microscopic simulation platform VISSIM v. 5.10 will be used to test different scenarios. The results indicated that the Displaced Left-turn consistently reports better results for average delay of less than 20 seconds per vehicle. / by Claudia Olarte. / Thesis (M.S.C.S.)--Florida Atlantic University, 2011. / Includes bibliography. / Electronic reproduction. Boca Raton, Fla., 2011. Mode of access: World Wide Web.

Traffic simulation and signal timing optimization are classified in structure into two main categories: (i) Macroscopic or Microscopic; (ii) Deterministic or Stochastic. Performance of the optimized signal timing derived by any tool is influenced by the methodology used in how calculations are executed in a particular tool. In this study, the performance of the optimal signal timing plans developed by two of the most popular traffic analysis tools, HCS and Tru-Traffic, each of them has its inbuilt objective function(s) to optimize signal timing for intersection, is compared with an ideal and an existing timing plans (base case) for the area of study using the microsimulation software VISSIM. An urban arterial with 29 intersections and high traffic in Fort Lauderdale, Florida serves as the test bed. To eliminate unfair superiority in the results, all experiments were performed under identical geometry and traffic conditions in each tool. Comparison of the optimized plans is conducted on the basis of average delay, average stopped delay, average number of stops, number of vehicles completed trips, latent delay, and latent demand from the simulated vehicle network performance evaluation results in VISSIM. The results indicate that, overall, HCS with its overall delay objective and the Tru-Traffic programs produce signal timing with comparable quality that performed similar to the un-optimized base case for most of the performance measures. / Includes bibliography. / Thesis (M.S.)--Florida Atlantic University, 2019. / FAU Electronic Theses and Dissertations Collection

When a traffic signals malfunction monitoring unit detects a problem with a traffic signal such as the simultaneous display of green indications to conflicting movements or loss of power to some signal heads, the signal is automatically placed into flash mode as a safety precaution. Signals can have either red/red malfunction flash mode or yellow/red malfunction flash mode, and the mode cannot change by time of day or day of week. This study analyzed traffic operation at 34 instances of yellow/red malfunction flash and 9 instances of red/red malfunction flash in the Atlanta, Georgia area. Many of these instances were during high volume periods. A high level of driver confusion exists at malfunction flash intersections. The rate at which through major street drivers (i.e. those facing a flashing yellow signal) stopped exceeded 75 percent at some yellow/red flash intersections. This creates a safety hazard for other major street drivers who are not expecting vehicles to stop, and for minor street drivers who cannot tell what type of control is being presented to cross traffic or do not understand that vehicles are not required to stop when approaching a flashing yellow indication. Furthermore, high stopping rates at a flashing yellow signal eliminate many of the operational benefits that yellow/red flash is assumed to have over red/red flash. Based on the findings of this study, the use of red/red flash should be the primary flash mode and possibly used exclusively. Requiring all vehicles to stop will improve safety conditions and not have large operational impacts at intersections where a majority of major street vehicles are already stopping at a flashing yellow signal. Yellow/red flash may be an acceptable malfunction flash mode at the intersection of a very large street and a very small street, but additional measures would be required at these intersections to address potential driver confusion.

No description available.

Drivers are expected to traverse through an intersection in malfunctioning flash mode in the same manner as a stop-sign controlled intersection. Red/red flash corresponds to four-way stop control and yellow/red flash corresponds to two-way stop control. However, at a red flashing signal there is no assurance that a driver can see the cross street indication (i.e., yellow or red flash) and therefore does not know if the intersection is operating as a two-way or four-way flash. In addition, some drivers appear unclear on the rules at a flashing signal. This confusion makes the intersection more accident prone. This study builds upon several previous studies, using data extracted from existing files. The objective of this study is to determine the level of drivers' understanding of the flash control through an analysis of violation rates and types at recorded intersection in malfunction flash. Comparing these violation rates to those at comparable stop-control intersections will help illustrate the difference in drivers' understanding of these similar intersection control devices.

Thesis (Ph.D.)--Edith Cowan University, 2007. / Submitted to the Faculty of Computing, Health and Science. Includes bibliographical references.

Thesis (M.S.)--Ohio University, June, 2003. / Title from PDF t.p. Includes bibliographical references (leaves 102-108).