Hydro One, a major distribution of electricity in Ontario, has reported that approximately 16,000 of the wood utility poles in its network of two million poles have been damaged by woodpeckers. With a cost of replacement of approximately $4000 per pole, replacing all affected poles is an expensive enterprise. Previous research conducted at UW attempted to quantify how different levels of woodpecker damage affected the pole strength. In the course of this research, some shear failures were observed. Utility poles being slender cantilevered structures, failures in shear are not expected. The objectives of this study were to determine the effective shear strength of wood utility poles and to determine the reliability of wood utility poles under different configurations, including poles that had been damaged by woodpeckers. An experimental programme was developed and conducted to determine the effective shear strength of wood poles. Red Pine wood pole stubs were used for this purpose. The stubs were slotted with two transverse half-depth cuts parallel to one another but with openings in opposite directions. A shear plane was formed between these two slots. The specimens were loaded longitudinally and the failure load was recorded and divided by the failure plane area to determine the shear strength. The moisture content of each specimen was recorded and used to normalize each data point to 12 % moisture content. The experimental study showed that the mean shear strength of the Red Pine specimens adjusted to 12 % moisture content was 2014 kPa (COV 47.5 %) when calculated using gross shear area, and 2113 kPa (COV 40.5 %) when calculated using net area. The shear strength of full-size pole specimens can be represented using a log-normal distribution with a scale parameter of λ = 0.5909 and a shape parameter of ζ = 0.5265. iii The reliability of Red Pine wood utility poles was determined analytically. A structural analysis model was developed using Visual Basic for Applications in Excel and used in conjunction with Monte Carlo simulation. Statistical distribution parameters for wind loads and ice accretion for the Thunder Bay, Ontario region were obtained from literature. Similarly, statistical data were obtained for the modulus of rupture and shear strength from previous research conducted at UW as well as the experimental programme conducted in this research. The effects of various properties on reliability were tested parametrically. Tested parameters included the height of poles above ground, construction grade, end- of-life criterion, and various levels of woodpecker damage. To evaluate the results of the analysis, the calculated reliability levels were compared to the annual reliability level of 98 % suggested in CAN/CSA-C22.3 No. 60826. Results of this reliability study showed that taller poles tend to have lower reliability than shorter ones, likely due to second-order effects having a greater influence on taller poles. The Construction Grade, a factor which dictates the load factors used during design, has a significant impact on the reliability of wood utility pole, with poles designed using Construction Grade 3 having a reliability level below the 98 % threshold. Poles designed based on Construction Grade 2 and 3 having reached the end-of-life criterion (60 % remaining strength) had reliability below this threshold whilst CG1-designed pole reliability remained above it. Wood poles with exploratory- and feeding-level woodpecker damage were found to have an acceptable level of reliability. Those with nesting-level damage had reliability below the suggested limits. Poles with feeding and nesting damage showed an increase in shear failure. The number of observed shear failure depended on the orientation of the damage. Woodpecker damage with the opening oriented with the neutral axis (i.e., the opening perpendicular to the direction of loading) produced a greater number of shear failure compared to woodpecker damage oriented with the extreme bending fibres.

In many regions of North America, Europe, and Australia, wood utility poles are used as main and secondary structural members for the support of electrical distribution and transmission lines. In the province of Ontario alone there are over 40000 H-frame, 6000 Gulfport, and thousands of single pole structures constructed of over 2 million wood utility poles (Pandey et al. 2010b). Currently, utility companies report an increasing number of woodpecker damage incidents on in-service utility poles (HONI 2010). In addition, many aging poles have woodpecker damage in combination with wood decay. Both these forms of degradation cause strength reductions in utility poles, making their structural integrity questionable. This has raised concerns regarding the safety of utility maintenance workers and the public, and the dependability of the electrical network. In response to these concerns, Hydro One Networks Incorporated (HONI) initiated a research project on the effect of woodpecker damage and wood decay on wood utility pole strength. The objective of the research was to develop methods of quantifying the strength reduction caused by woodpecker damage and wood decay. This information was then used to develop in-service assessment methods for determination of whether pole replacement is necessary when specific levels of woodpecker damage and wood decay are present. By developing better assessment methods, in-service utility poles will not be unnecessarily replaced, reducing maintenance costs. In this study, three analytical models were developed that predicted the theoretical cross-sectional strength reduction caused by the presence of woodpecker damage. A bending failure model was developed since, in the structural design of utility poles, bending moment stresses are known to be the critical design parameter. It was decided that the significance of shear stress in a cross-section should also be considered since the presence of woodpecker damage could cause shear stresses to be a significant parameter. As a result, a shear-bending and a shear failure model was developed to determine the significance of shear stress on cross-section behaviour. These models were developed for analysis purposes and were verified by the subsequent experimental program. A total of 28 new and in-service utility poles were received from HONI for experimental testing. The new poles were received in as-new condition, while the in-service poles received had varying levels of woodpecker damage and wood decay. The poles received were cut into 4.25 m lengths for beam testing. A single new pole and in-service specimen from each pole was tested as a control specimen without woodpecker damage to obtain reference utility pole bending strengths. The remainder of the new pole specimens were mechanically introduced with woodpecker damage, while the remainder of the in-service specimens were tested with natural woodpecker damage. The tested specimens were analyzed and the results were compared with the woodpecker damage analytical model predictions. Results indicated that the effect of woodpecker damage is well modelled by the woodpecker damage analytical models. Overall, the bending failure analytical model was preferable for cross-section analysis due to the accuracy of the model predictions and the simplicity of required calculations. It was evident from the experimental program that the presence of woodpecker damage can severely reduce the strength of utility poles, making replacement necessary according to CSA C22.3 No. 1 Cl. 8.3.1.3 (2006a). In-service specimen experimental results indicated that if wood decay is detected in wood utility poles, severe reduction in wood strength has occurred and the utility pole should be replaced. Analytical and experimental results were used to develop three application methods for determining whether utility pole replacement is necessary due to the presence of woodpecker damage. These three methods include the simplified method, the chart method, and the case-specific method. The simplified method allows determination of whether a utility pole should be replaced based only on knowledge of the most severe level of woodpecker damage present in a pole. The chart method takes into account additional factors such as the diameter of the pole at the location of the woodpecker damage and the width of the hole opening. The case-specific method is advantageous since it accounts for the parameters used in the chart method and allows the location of woodpecker damage along the length of a pole to be accounted for. The simplified and chart methods are preferable since they are relatively simple and easy to implement in the field. The case-specific method requires a full structural analysis of the utility pole in question to be undertaken and is useful for more accurately assessing whether replacement is necessary. These three methods show how the research completed can be used for improved assessment of in-service utility poles resulting in reduced unnecessary pole replacement and maintenance costs.

Thesis (Ph.D.)--Tufts University, 2005. / Adviser: J. Michael Reed. Submitted to the Dept. of Biology. Includes bibliographical references (leaves 126-135). Access restricted to members of the Tufts University community. Also available via the World Wide Web;

Thesis (MS)--Montana State University--Bozeman, 2009. / Typescript. Chairperson, Graduate Committee: Jay J. Rotella. Includes bibliographical references.

Due to heavily managed forests in Sweden, there has been a rapid decline of deadwood and deciduous-rich areas since the 1950s. As a result of this, 2000 forest species are now red-listed of which 700 is in heavy need of deadwood. The white-backed woodpecker Dendrocopos leucotos, an umbrella species whose food choice consists of insects living in dead and decaying wood, has become critically endangered due to the lack of food and nesting areas. Preservation actions aimed towards saving the white-backed woodpecker are not only essential for itself but for 200 other species dependent on the same environmental requirements. The purpose of this study was to determine if the restoration for deciduous trees has favoured the white-backed woodpecker in four different areas: Ängsbacka, Degersjön, Ålidberget, and Kvillträsk in Västerbotten. By placing two different kinds of insect traps (window traps, and malaise traps) to analyze the different insects in restoration areas compared with control areas, I could investigate if there had been an increase in the number of insects preferred by the white-backed woodpecker. I could also investigate if there was a higher diversity of these preferred insects. There was no sign of an increase in numbers of preferred insects nor in numbers of preferred species. A higher diversity could neither be proven, however all four forests were deciduous-rich with high amount of dead-wood and has proven to show good potential for a future increase in saproxylic insects if restoration continues.

Identifying species occurrence in ecosystems of high conservation concern is especially important in the context of modern landscapes. This study investigated how stand-scale and landscape-scale factors affect priority birds associated with longleaf pine (Pinus palutris) ecosystems. Herein, I compared priority bird occupancy among 12 stand types throughout the historic range of longleaf pine. I found open pine stands positively influenced red-cockaded woodpecker (Picoides borealis) and Bachman’s sparrow (Peucaea aestivalis) occupancy, but were not significantly linked to northern bobwhite (Colinus virginianus) and brown-headed nuthatch (Sitta pusilla) occurrence. Landscape- and stand-scale factors affected red-cockaded woodpecker, Bachman’s sparrow, and brown-headed nuthatch occupancy. Northern bobwhite occupancy was influenced solely by landscape-scale factors. Red-cockaded woodpecker and Bachman’s sparrow were positively influenced by metrics associated with longleaf pine ecosystems suggesting they are effective indicator species. My analysis indicates that using this multi-scale approach is valuable to identifying areas on the landscape of conservation and restoration priority.

A combination of factors including land use change and fire suppression has resulted in the loss of pine savanna habitats across the southeastern U.S., affecting many avian species dependent on these habitats. However, due to the ephemeral nature of the habitat requirements of many pine savanna species (e.g., habitat is only present for a couple of years after a fire), targeted management of such habitats can be challenging. Moreover, the growing numbers of imperiled pine savanna species can make prioritizing management difficult. One potential tool to better inform management of pine savanna species is satellite imagery. Sentinel-2 satellite imagery data provides an instantaneous snapshot of habitat quality at a high resolution and across a large geographic area, which may make it more efficient than traditional, ground-based vegetation surveying. Thus, the objectives of my research were to 1) evaluate the use of remote sensing technology to predict habitat occupancy for pine savanna species, and 2) use satellite imagery-based models to inform multispecies management in a pine savanna habitat. To meet my objectives, I conducted point count surveys and built predictive models for three pine savanna bird species: Bachman's Sparrow (BACS; Peuacea aestivalis), Northern Bobwhite (NOBO; Colinus virginianus), and Red-Cockaded Woodpecker (RCW; Dryobates borealis) across Georgia. I assessed the performance of satellite imagery in predicting habitat occupancy of these pine savanna species and its potential for multispecies management. I found that models created using satellite imagery habitat metric data performed well at predicting the occupancy of all three species as measured by the Area Under the Receiver Operating Characteristic Curve: BACS=0.84, NOBO=0.87, RCW=0.76 (with values between 0.7-1 defined as acceptable or good predictive capacity). For BACS and NOBO, I was able to compare these satellite imagery models to field-based models, and satellite models performed better than those using traditional vegetation survey data (BACS=0.80, NOBO=0.79). Moreover, I found that satellite imagery data provided useful insights into the potential for multispecies management within the pine savanna habitats of Georgia. Finally, I found differences in the habitat selected by BACS, NOBO, and RCW, and that BACS may exhibit spatial variations in habitat use. The results of this study have significant implications for the conservation of pine savanna species, demonstrating that satellite imagery can allow users to build reliable occupancy models and inform multispecies management without intensive vegetation surveying. / Master of Science / Land-use changes have resulted in the disruption of natural disturbances such as fires, resulting in the loss of pine savanna habitats throughout the southeastern U.S. Although many of the species that occupy these habitats are experiencing rapid population declines, habitat for pine savanna species can be challenging to manage. Without reoccurring fire, pine savanna habitat can become unsuitable for obligate species within short periods of time, forcing these species to disperse to newly disturbed habitats. The transient nature of the preferred habitat of pine savanna species makes targeting management for these species difficult, as it can be challenging to locate exactly where occupied habitats exist. Furthermore, as the number of pine savanna species that are declining is large, prioritizing management of these species can be difficult especially given limited conservation funding. One potential tool to better inform the management of pine savanna species is satellite imagery. Satellite imagery can capture habitat information across broad areas, at fine resolutions, and at frequent intervals, potentially making satellite imagery more efficient than conducting field vegetation surveys on the ground for gaining information on habitat suitability. Thus, the objectives of my research were to 1) determine if satellite imagery can effectively predict the habitats occupied by pine savanna species (habitat occupancy), and 2) use satellite imagery-based models to inform the simultaneous management of multiple species (multispecies management) in a pine savanna habitat. To meet these objectives, I conducted surveys and built predictive models for three pine savanna bird species: Bachman's sparrow (BACS; Peuacea aestivalis), Northern Bobwhite (NOBO; Colinus virginianus), and Red-Cockaded Woodpecker (RCW; Dryobates borealis) in Georgia. I found models informed by satellite imagery performed well at predicting habitats occupied for all three species. Furthermore, models developed using satellite imagery performed better at predicting the habitats occupied by pine savanna species than models developed using on the ground vegetation surveys. I also found that satellite imagery data provided useful insights into strategies to manage pine savanna species simultaneously. I found evidence that BACS, NOBO, and RCW may have contrasting habitat needs and that BACS may use habitat differently between sites in Georgia. The results of this study demonstrate that satellite imagery can be used to predict the habitats occupied by pine savanna species and inform multispecies management without surveying vegetation on the ground, which is a more efficient use of time and funding.

No description available.

No description available.

No description available.