1 |
Arsenic (V) and Phosphate sorption to Swedish clay soils - Freundlich sorption modelling.Mwamila, Luhuvilo January 2011 (has links)
This thesis is an attempt to analyze and interpret the behavior of the two elements arsenic and phosphorus when released into the environment. Both of them may occur naturally in the environment but also may be added to the environment for certain purposes e.g. as pesticides and fertilizers respectively or through anthropogenic sources. When in excess, arsenic can be toxic to plants and organisms in the soil and some of it when leaches to groundwater or transported to surface water bodies through runoffs may pose a threat to aquatic organisms. Likewise, phosphorus when in excess result into eutrophication of surface water bodies and groundwater as well which has been a major problem in the Baltic Sea. In order to be able to predict their mobility a study on their chemical and physical characteristics under different conditions is important. The soil composition is an important aspect of nutrient management because some of the minerals present i.e. hydr(oxides) of aluminium and iron tend to hold and store both arsenic and phosphorus in the soil, while plant uptake and harvest may remove them (especially phosphorus) from the soil. This study was focused on Swedish agricultural soils and the samples for investigation were collected from two locations, one is Broknäs from which samples were collected from different horizons i.e. A 0-30 cm, C 60-90 cm and C 47-67 cm samples from an area known as Bogesundslandet, NE of Stockholm (59°24’N, 18°18’E) and E21:2 was collected from the county of Östergötland (58°27’N,14°57’E), southern Sweden not far from Lake Vättern, from where the A horizon was collected. Batch experiments were performed to check pH and concentration dependence of the sorption/desorption of As and P. Two varieties of the Freundlich equation (Basic and Competitive) were used to model the results obtained. It was observed that the dependence of arsenate and phosphate sorption/desorption on pH show a similar but not identical trend for both anions. At low pH, the dependence of dissolved P and As did not agree, for unknown reasons. Possibly, the low pH value may mobilize otherwise un-reactive P that at higher pH are blocked by some aluminium/iron precipitate. The Freundlich modeling results showed that there is direct competitive adsorption between As and P ions, at least in the A horizon. However use of the competitive Freundlich equation did not result in meaningful results in the C horizon, which may indicate different As and P sorption mechanisms. However, further studies on this are recommended.
|
2 |
Chitosan biopolymer as an adsorbent for drinking water treatment : Investigation on Arsenic and UraniumAnnaduzzaman, Md January 2015 (has links)
In many countries over the world (including Sweden), metal toxicity in freshwater resources causes a severe drinking water quality problem and poses a threat to the environment and human health. Among the different toxic metals in the water resources of Sweden, arsenic and uranium are the biggest threats to health. These elements, over long time consumption, may even lead to cancer and/or neurological disorder. Most of the wells are installed in crystalline and sedimentary bedrock and the received water comes from water bearing fractures in the bedrock. The handling of such water is an issue and there is a need to reduce the arsenic and uranium exposure by improving processes and technologies. It is a very serious problem demanding a safe, sustainable and eco-friendly arsenic and uranium removal technology prior to drinking water supply. Different treatment systems are available, but many of them are not suitable due to their high cost, operation complexity and waste management issues. Through this study, chitosan biopolymer the second largest abundant polysaccharide on earth after cellulose, was verified as a potential adsorbent for arsenic(V) and uranium(VI) removal from water solution. Adsorbent characterizations were also conducted by XRD, FTIR, SEM, UV-visible spectrum and TGA/DTA investigations. Bench-scale batch experiments were conducted using chitosan biopolymer (DDA-85%) as an adsorbent to determine the arsenic(V) and uranium(VI) removal efficiency, by allowing four important effective parameters e.g. chitosan dosages, pH, contact time and contaminant concentration. The adsorption data at optimum conditions were fitted with Langmuir, Freundlich and Dubinin-Radushkhevic (D-R) isotherm and Lagergren pseudo-first-order and pseudo-second-order kinetic model to investigate the adsorption process. The characterization of materials assured the presence of effective amino, hydroxyl, and carboxyl groups of chitosan. Another advanntage is that the materials are bio-degradable. The results show that the arsenic(V) and uranium(VI) removal efficiency was 100% and 97.45% after 300 minutes with optimum pH of 6.0 and 7.0 respectively. The optimum adsorbent dosages and initial concentration were 60 and 80g/L and 100 and 250 µg/L respectively. The adsorption process was suitably described by Freundlich isotherm (R2 = 0.9933) and Langmuir isotherm (R2 = 0.9858) correspondingly for arsenic(V) uranium(VI) compared to other isotherms. This is an important indicator of homogeneous monolayer adsorption of metals. For both of arsenic(V) and uranium(VI), pseudo-second-order explained the adsorption kinetics better than pseudo-first-order and the second-order kinetic regression coefficient (R2) were 0.9959 and 0.9672 correspondingly. Connecting to the above mentioned results, it can be summed up that the chitosan biopolymer (DDA 85%) can be used as an inexpensive, sustainable and environment-friendly treatment option for arsenic(V) and uranium(VI) contaminated drinking water. / I många länder världen runt (även i Sverige) orsakar metallers toxicitet besvärliga vattenkvalitetsproblem och utgör ett hot mot människors hälsa. Bland de toxiska metaller som finns i svenska vatten utgör arsenik och uran i dricksvatten allvarliga hälsorisker vid långvarig exposition då de kan orsaka cancer och neurologiska problem. Flertalet brunnar är installerade i kristallint berg och sedimentära bergarter och vattnet kommer vanligen från sprickor i berggrunden. Hanteringen av sådant vatten kan kräva reduktion av expositionen för arsenik- och uraninnehåll genom förbättrade processer och teknologier. Detta är ett angeläget problem som kräver en säker, pålitlig och ekovänlig teknologi att tillämpas innan vattnet distribueras. En rad olika behandlingssystem är tillgängliga men många av dem är inte lämpliga beroende på deras höga kostnad, den komplicerade tillämpningen och problem med hanteringen av restprodukter. I denna studie has biopolymeren chitosan, den näst vanligaste polymeren efter cellulosa, konstaterats vara en möjlig adsorbent för att avlägsna arsenik(V) och uran(VI) från vatten. Karakterisering av adsorbenten har också genomförts genom XRD, FTIR, SEM, UV och strålning i synligt ljus samt TGA/DTA undersökningar. Batch-tester i bänkskala har genomförts med användning av chitosan (DDA-85%) som adsorbent för att bestämma dess förmåga att avlägsna arsenik(V) och uran(VI)genom att variera fyra parametrar, nämligen kontakttid, pH, dos av chitosan och halt av föroreningen. Adsorptionsdata vid optimala förhållanden bestämdes genom tillämpning av Langmuir, Freundlich och Dubinin-Radushkhevic (D-R) isotermerna. Vidare tillämpades Lagergrens pseudo-first-order och pseudo-second-order kinetiska modell för att undersöka adsorptionsprocessen. Karakteriseringen av materialet visade förefintligheten av effektiva amino- (N-H), hydroxyl- (O-H) samt karboxylgrupper (C=O) i chitosan-polysackariden och att det är lätt nedbrytbart. Preliminära resultat visar att reduktionen av arsenik(V) och uran(VI) var 100 respektive 97,45 % efter 300 minuters kontakttid med optimalt pH på 6,0 respektive 7,0. De optimala doserna av adsorbent och den initiala koncentrationen var 60 och 80 g/L och 100 och 250 µg/L. Adsorptions process beskrevs bäst av Freundlich-isotermen för arsenik(V) (R2 = 0.9933) och med Langmuir-isotermen för uran(VI) (R2 = 0,9858) jämfört med andra isotermer vilket var en viktig indikation på en homogen monolager-adsorption. För både arsenik(V) och uran(VI) beskrev pseudo-second order adsorptionen bättre än pseudo-first-order. Second-order kinetiska regressionskoefficienten (R2) var 0.9959 och 0.9872 respektive. De ovanstående resultaten visar sammanfattningsvis att chitosan (DDA-85%) kan användas som en billig, pålitlig och miljövänlig behandlingsmetod av vatten för arsenik(V) och uran(VI). / <p>QC 20150526</p> / ChitoClean
|
Page generated in 0.0427 seconds