1 |
Magneto-optical effects in atomic vapoursKersey, A. D. January 1984 (has links)
No description available.
|
2 |
Theoretical and experimental studies of spectroscopically observed relaxation processesBurnett, K. January 1978 (has links)
No description available.
|
3 |
Photoelectron spectroscopy studies on group IV semiconductor clusters and novel binary clustersCui, Lifeng, January 2007 (has links) (PDF)
Thesis (Ph. D.)--Washington State University, May 2007. / Includes bibliographical references (p. 234-257).
|
4 |
Multichannel partial-wave analysis of KN scatteringZhang, Hongyu. January 2008 (has links)
Thesis (Ph.D.)--Kent State University, 2008. / Title from PDF t.p. (viewed Oct. 5, 2009). Advisor: D. Mark Manley. Keywords: partial-wave analysis; multichannel; KN scattering; crystal ball. Includes bibliographical references (p. 125-127).
|
5 |
Highly sensitive elemental analysis of ArF laser excited atomic fluorescence of laser plumesHo, Sut Kam 01 January 2007 (has links)
No description available.
|
6 |
Argon fluoride laser induced plume fluorescence for multi-element analysis: sensitivity and universalityChu, Po Chun 17 June 2013 (has links)
In 2005, our group first reported a two-pulse multi-element analysis technique that was both sensitive and minimally destructive. The first laser pulse ablated a thin layer of the sample over a hundred m spot; the second laser pulse at 193 nm induced multi-analytes in the desorbed plume to fluoresce. Since then, this technique of laser-excited atomic fluorescence (LEAF) of ablated plumes, or PLEAF for short, had been applied to the analysis of aqueous lead colloids and metals. Sub ng/g and tens of atto-mole detection limits were demonstrated. The non-selective photoexcitation in PLEAF was believed to be due to smeared energy levels of species in dense plumes. Smearing was especially severe for highly excited states such as those reached by 193 nm excitation. As the plumes subsequently expanded, the electronic structure of the plume species evolved adiabatically from a dense gas to that of an isolated atom with the electrons still in the excited states. Signature fluorescence from multi-analytes was therefore possible. The suggested mechanism implied that ArF laser-induced PLEAF should be applicable to any sample matrix and any analyte as long as the species were imbedded in dense plumes and whose excited states could be reached by 193 nm photoexcitation. We therefore investigated the universality of PLEAF in this study by extending the analysis to ceramics, polymers, and their composites. We showed that these matrices could be successfully sampled and emissions from practically all analyte elements were observed. The detection sensitivity was orders of magnitude better than alternative laser spectrochemical probes such as laser-induced breakdown spectroscopy (LIBS). Under minimally destructive conditions, emissions from Al, Ca, Co, Cr, Cu, Fe, In, Mg, Mn, Na, Pb, Sn, and Si were observed. We also applied the technique to four practical problems: The analysis of dried paint for trace lead when g/g detection limits were achieved; the analysis of valuable potteries when two look-alike specimens were differentiated based on practically non-destructive single-shot analysis; the elemental analysis of ink when lines written with different pens could be discriminated yet without discernable sample destruction even under the microscope; and the analysis of electrode-plastic interfaces when the detection sensitivity was comparable to SIMS. In some of these applications, we found that the fluorescence intensity varied with the fluence and the timing of the ArF laser pulse in ways suggestive of particulates in the plume. Because nearly all analyte elements were excited in PLEAF, multi-analyte spectra were generated even in single-shot analysis. We showed that the rich spectral information contents could be fully exploited by chemometric techniques such as principal component analysis, SIMCA and K-means clustering. In sum, the combination of PLEAF and chemometrics paved way for ultra-sensitive and minimally destructive multi-element analysis of complex samples. The analysis was all-optical and therefore could be done in air with no restriction on sample size. No sample preparation was needed. The analysis was fast, with a turn-around time of minutes. At the end, the sample was not visibly damaged even when examined under the microscope. If the ablation could be congruent, 3-dimensional chemical profiling at tens to hundreds of m lateral resolution and tens of nm depth resolution would be possible.
|
7 |
FUNDAMENTAL INVESTIGATIONS OF A 148 MEGAHERTZ INDUCTIVELY COUPLED PLASMA DISCHARGE.WEBB, BRYAN DOUGLAS. January 1985 (has links)
Fundamental investigations have been carried out on an Inductively Coupled Plasma (ICP) operated at 148 MHz, a frequency which is nearly three times higher than any previously reported for analytical ICPs used in spectrochemical analysis. High frequency operation is expected to provide easier sample introduction into the discharge, with a consequence of less energetic conditions in the central channel. Several plasma diagnostic techniques were employed in order to determine the conditions experienced by the analyte species in this source for spectrochemical analysis. Three different torch systems were investigated at 148 MHz and compared to the "standard" 27 MHz configuration. The highest excitation temperatures and electron densities were obtained in the 27 MHz configuration, and the lowest values in the largest torch at 148 MHz. Intermediate values were obtained in the intermediate-size torches at 148 MHz. These observations correlate reasonably well with the ratio of the plasma radius to the skin depth (r/s). The skin depth defines the region in which the majority of the electrical energy is deposited into the discharge, and is smaller at 148 MHz than at 27 MHz. The measurement of electron densities also allows the estimation of how closely a particular discharge approaches Local Thermal Equilibrium (LTE). As may be expected, LTE is most closely approached in the 27 MHz arrangement. The less energetic conditions characterized by lower temperatures and electron densities result in less intense analyte emission from the high frequency ICPs. Signal-to-Background ratios and detection limits reflect this trend, but the linearity of the calibration curves and freedom from vaporization interferences are not degraded. Finally, the introduction of organic solvents is much easier, and better detection limits in an organic matrix are obtained at 148 MHz. These investigations have shown the utility of classifying the effects of changing torch sizes and operating frequencies by means of the r/s ratio. This provides the analyst with a means of selecting the general range of conditions to be employed in a particular analysis.
|
8 |
The application of a linear photodiode array as a multichannel detector for inductively coupled plasma atomic emission spectroscopy /McGeorge, Scott W. (Scott Wilson) January 1985 (has links)
No description available.
|
9 |
Electrochemical preconcentration and separation for elemental analysis using an inductively coupled plasma for atomic emission spectrometry with a direct sample insertion deviceHabib, Magdi Maurice. January 1985 (has links)
No description available.
|
10 |
Characterization of aerosols with laser doppler velocimetry for LC/ICPMSMaeda, Shigenori 08 1900 (has links)
No description available.
|
Page generated in 0.0745 seconds