Master’s thesis deals with solar gains in buildings. The thesis presents an overview of the theoretical knowledge to solve solar gain. The thesis deals possibilities of measuring the intensity of solar radiation and evaluation of data from the meteorological station in the experimental part. Application of topic is then used for polyfunctional building. This part aims to show possibilities of design of air conditioning systems for the purpose of making indoor microclimate and their subsequent evaluation.

The main aim of this thesis is optimization of energy demands in a new administrative high-rise building Vienna Point II located in Brno. Experimental part of the thesis deals with determination of real energy consumption during winter season and preparation of a set of climate data for theoretical simulations. Theoretical part is based on data obtained by experimental methods and is aimed on optimization of energy demands. The effect of suggested solution is analysed by software solutions which simulate building operation. Resulting energy demands obtained by simulations are compared with real energy consumption.

This diploma thesis investigate the question of combined production of heat and power by the gasification of biomass. The introduction describes basic dilemma energy conversion from biomass. Further, special attention at the gasification technology and it´s usage at combined heat and power production is paid. The main section includes schematic proposal cycle with use of microturbine 80 [kWe] as well as basic calculation, which serves as a base for folowing project optimization. For discussed optimization is made concept of configuration, thermal and aerodynamics calculation for both heat exchangers B1 and B2. Last but not least these heat exangers were compared by different aspects such as influence of deposits on power transfer and pressure loss. At the end of the work calculated numeric values are discussed and the project of heat exchanger with it´s advantages for practise are summarised.

This diploma thesis investigates the combined production of power and heat from biomass. The main aim is to compare suggested energy circles in the light of their electric, general and economic efficiency. Introduction describes the basic terms and principles of energy utilization of biomass, combustion and gasification technology are described thoroughly. The main part contains suggestions and thermal calculations of energy circles. The thermal cycle with gasification chamber, combustion chamber and hot air turbine is proposed, than thermal cycle with gasification generator and cogeneration unit and finally Rankine-Clausius circle. In conclusion calculated results are recapitulated and the usability of proposed thermal cycles is assessed.

This master thesis designes the calculation of fluid boiler with specific part - the circular fluid bed. The heat is given by combustion of wood biomass. The thesis is devided into several parts. All necessary elementary results are going to be reached within these parts: an analysis of solid fuel, stechiometry calculation, discussion on output limits and the environmental point of view, definition of elemental heat losses and general heat efficiency, calculation and design of a combustion part and its heat loads and calculation of enthalpies with different ash concentrations. All these phases get to a successful design of the fluid boiler heat balance and sizes of heat-flow surfaces. The composition of the boiler shows the added drawing.

Turbogenerator unit 100B TGU, produced in the First Brno Engineering Velká Bíteš a.s., works in Brayton indirect circulation. The aim of this work is the proposal to increase performance levels of technological unit in which the micro-turbine is applied. The work presents various ways to increase performance and efficiency of circulation. The possible options are compared with each of the technological and economic terms. Based on these criteria was selected variant feeding additional water into the circulation. For this design was the work of a mathematical model based on, which was established as the economic balance of the selected variants. The thesis also proposes a technological scheme, which is already incorporated the selected variant and an outline of the verification tests.

The purpose of this thesis is to design a solution thermal power outlet of incinerator in hot water for the supply this town of heat. First and foremost are described problems landfill society and their implications on the environment. Next some alternatives of the waste and the burning in incinerators are described too. The thesis describes the history of the first incineration plant in the Czech Republic and its subsequent upgrading of the economical and environmentally friendly waste recovery and modernization of flue gas cleaning. Contribution of the work is then proposed as amendments to equipment and wiring for use of steam for the conversion heat output into hot water. This is essentially a calculation of steam water heaters at the end of the expansion of the steam and the related adjustments to the turbine blading. At the conclusion outlines the basic economic calculation and comparison of profits and investment associated with this implementation compared to implementation, which is now projected. It is a calculation of investment efficiency and its possible repayment due to higher profits from the sale of energy. This work serves only as a basis work for future technical realization and it outlines the appropriateness of this alteration.

This dissertation thesis deals with new progressive channel coding methods for data transmission using satellite transponder. The design of the system for SMS transmission, in which novel turbo coding methods are applied, is discussed too. An achievement of the lowest output power and the smallest user aperture is the principal aim of the new method applications. Design of system that would be able to the error free SMS transmission by very low signal to noise ratio is analyzed in this dissertation thesis. The work is focused on energy budget, modification and implementation of new turbo code types and using unique properties, development of new bit error rate estimation methods and methods for determination of final SMS form. The main contribution is the new type of turbo code development that have optimal properties for this usage, development of new bit error rate estimation method and development of method that is able to determine final form of SMS on the basis SMS frame structure and turbo decoding theory when the bit error rate is not zero.

The thesis contains a gas boiler room energy assessment in Lišov. In the mentioned boiler room, there are instaled gas condensing boilers and cogeneration units Theoretical part of the thesis lists a summary of generally used cogeneration equipment and ordinarily used gases. Calculation part includes four variants of the boiler room reconstruction. Energy assessment compares the chosen variant from the calculation part with the original condition of the boiler room.

This PhD thesis compares the water regime of reclaimed and unreclaimed spoil heaps after brown coal mining, with special regard to the development of hydrological properties of soils, which are determinant for the movement and retention of water in the soil. The basic influence on the supply of soil water has the technology of pouring the spoil heaps and aging, which co-regulates the development of vegetation. During the development of soil's spoil heaps increases field water capacity and water retention, but also increases the wilting point. These changes are related to the accumulation of organic matter in the soil and the degradation of claystones to particle size of physical clay. The development of the ability of the spoil heaps soils to bind water is greater in reclaimed areas, where the upper organomineral horizon develops more rapidly, but there is also a wilting point and water consumption. On unreclaimed area, the soil substrate develops more slowly. Overall, the differences in water regime between reclaimed and unreclaimed areas are small.