In this thesis, the circuits are designing with TSMC.18£gm CMOS process and 1.8V of supply voltage. The speed and resolution of ADC are 150MS/s and 12-bits individually. In order to achieve a high speed, low power consumption pipelined ADC. The proposed pipelined stage is replaced Flash ADC by SAR ADC and add an extra comparator to determine one additional bit in sampling phase of pipelined stage. This technique reduces large number of pipelined stage and opamp which is energy-hungry in the pipelined ADC. Second, the SAR ADC provides inherent sample-and-hold mechanism so that the front-end sample-and-hold amplifier circuit is non-need. Third, the SAR ADC can achieve rail-to-rail input signal swing and improve the conversion accuracy rather than Flash ADC. The dynamic comparator is used for lower power consumption for whole circuit. Furthermore, this pipelined ADC implement under a supply voltage as low as 1.8V. The bootstrapped switch is used for controlling the sampling in the front-end. It can reduce the impacts of linearity for operating under low supply voltage. The operation amplifier implement by the partially switched-opamp technique to reduce more power consumption. Finally, the output codes are translated by digital correction circuit, it enhance the comparators input offset error tolerance.

Broadband wireless communication systems demand power-efficient analog-to-digital converters (ADCs) in the GHz and medium resolution regime. While high-speed architectures such as the flash and pipelined ADCs are capable of GHz operations, their high-power consumption reduces their attractiveness for mobile applications. On the other hand, the successive-approximation-register (SAR) ADC has an excellent power efficiency, but its slow speed has traditionally limited it to MHz applications. This dissertation puts forth several novel techniques to significantly increase the speed and power efficiency of the SAR architecture and demonstrates them in a low-power 10-GHz SAR ADC suitable for broadband wireless communications. The proposed 8-bit, 10-GHz, 8× time-interleaved SAR ADC utilizes a constant-matching DAC with symmetrically grouped unit finger capacitors to maximize speed by reducing the total DAC capacitance to 32 fF and minimizing the bottom plate parasitic capacitance. The capacitance reduction also saves power as both the DAC size and the driving logic size are reduced. An optimized asynchronous comparator loop and smaller driver logic push the single channel speed of the SAR ADC to 1.25 GHz, thus minimizing the total number of timeinterleaved channels to 8 to reach 10 GHz. A dual-path bootstrapped switch improves the spurious-free dynamic range (SFDR) of the sampling by creating an auxiliary path to drive the non-linear N-well capacitance apart from the main signal path. Using these techniques, the ADC achieves a measured signal-to-noise-and-distortion ratio (SNDR) and SFDR of 36.9 dB and 59 dB, respectively with a Nyquist input while consuming 21 mW of power. The ADC demonstrates a record-breaking figure-of-merit of 37 fJ/conv.-step, which is more than 2× better than the next best published design, among reported ADCs of similar speeds and resolutions.