Signalized Intersections on the State Roads in Hillsborough and Pinellas County, Florida with observed left turn lane overflow (spill) were selected for a safety and operational study. The study analyzed the crash data for safety hazards that the situation presents. Crashes within 100 feet from the center line of the crossroad of intersections under study to distances 200 feet beyond the end of the turn lane were chosen for the analysis. Left turn overflow is the situation at the approach of an intersection where left turning vehicles back up from the turn lane into the through traffic lane. Crashes within the intersection legs with the left turn lane overflow problems resulted in more crashes than the intersection legs without the spill problem at 95 percent confidence level. However the result was not overwhelming when 3 leg intersections are combined with 4 leg intersections. The rush periods within the leg of the intersection where left turn overflow occurred did not seem to have any correlation at all using paired t test.

With rapidly increasing e-scooter usage in the United States [1], a growing number of studies aim to understand the safety aspect of these emerging modes. The existing literature has a limited understanding of time-of-day and seasonal patterns of e-scooter crashes. While many e-scooter safety policies are based on the number of crashes [2, 3], accounting for exposure provides a measure of risk to inform effective preventive strategies [4]. This study focuses on motor-vehicle involved crashes since they constitute the most severe and fatal injuries. We compared daytime and nighttime motor-vehicle involved e-scooter crashes and combined them with micromobility trip data to generate exposure variables and estimate crash risk. The key research question of this paper is as follows: 1. Are crashes or crash rates disproportionately higher at night than in the day? [From: Introduction]

The purpose of this thesis is to explore how the installations of traffic signals affect crash experience at intersections, to identify those factors which help predict crashes after a signal is installed, and to develop a crash prediction model. It is the intent of this thesis to supplement the Manual on Uniform Traffic Control Devices Signal Warrant procedure and aid the traffic engineer in the signal installation decision making process. Crash data, as well as operational and geometric factors were examined for 32 state road intersections in the northeast Florida area before and after signal installation. Signal warrant studies were used as sources for traffic volumes, geometric information and crash history, before signal installation. The Florida Department of Transportation's Crash Analysis Reporting System (CARS) was used to gather crash data for the time period after signal installation. On average, the 32 intersections experienced a 12% increase in the total number of crashes and a 26% reduction in crash rate after signals were installed. The change in the number of crashes was not significant, but the rate change was significant with 90% confidence. Angle crash frequency dropped by 60% and the angle crash rate dropped by 66%, both are significant. Left-turn crashes dropped by 8% and their rate by 16%, although neither was significant. Rear-end crashes increased by 86% and the rear-end crash rate decreased by 5%. Neither of these changes was statistically significant. When crash severity was examined, it was found that the number of injury crashes increased by 64.8% and the rate by only 0.02%. Neither change was significant. Both the number of fatal crashes and the rate decreased by 100% and were significant. Property Damage Only (PDO) crashes increased by 96%, after signalization, but this change was not significant. The PDO rate, however, decreased by 46.5% and is significant. Operational factors such as AADT, turning movement counts, and speed limits; and geometric factors such as medians, turn lanes and numbers of lanes were considered to determine their effect on crashes at signalized intersections. Smaller roads, with low AADT, fewer lanes, and a rural character were found to benefit from signalization more than busier urbanized roads, in terms of crash rate reduction. The AADT, roadway cross section, number of lanes, medians, speed limit and left turn volume were all found to be important factors influencing crash rates. This thesis recommends: 1) the use of crash prediction models to supplement the MUTCD Crash Warrant, 2) the addition of a left-turn warrant to the MUTCD signal warranting procedure, and 3) development of an intersection database containing crash data as well as operational and geometric information to aid in future research.

The goal of this research was to examine the potential predictive ability of socioeconomic and demographic data for drivers on Kentucky crash occurrence. Identifying unique background characteristics of at-fault drivers that contribute to crash rates and crash severity may lead to improved and more specific interventions to reduce the negative impacts of motor vehicle crashes. The driver-residence zip code was used as a spatial unit to connect five years of Kentucky crash data with socioeconomic factors from the U.S. Census, such as income, employment, education, age, and others, along with terrain and vehicle age. At-fault driver crash counts, normalized over the driving population, were used as the dependent variable in a multivariate linear regression to model socioeconomic variables and their relationship with motor vehicle crashes. The final model consisted of nine socioeconomic and demographic variables and resulted in a R-square of 0.279, which indicates linear correlation but a lack of strong predicting power. The model resulted in both positive and negative correlations of socioeconomic variables with crash rates. Positive associations were found with the terrain index (a composite measure of road curviness), travel time, high school graduation and vehicle age. Negative associations were found with younger drivers, unemployment, college education, and terrain difference, which considers the terrain index at the driver residence and crash location. Further research seems to be warranted to fully understand the role that socioeconomic and demographic characteristics play in driving behavior and crash risk.

In Florida, the increased installation of non-traversable medians and directional median opening has produced an increased number of U-turns on multilane highways. Arguments have been advanced by some opponents of median modification projects that the increased numbers of U-turns may result in safety and operational problems on multilane highways. The primary objective of this study is to evaluate the operational effects of U-turn movement on multilane roadways. To achieve this research objective, extensive data were collected. Field measurements were conducted at 40 sites in the Tampa Bay area of Florida to collect traffic operations data. Besides, the crash histories of 179 selected roadway segments in central Florida were investigated. Statistical analysis was conducted based on the collected traffic operations data and crash data to quantitatively evaluate the operational performance of U-turn movement. Delay and travel time were compared for different driveway left- turn alternatives that are widely used in Florida and nationally. Crash rate models were developed to evaluate how the separation distance between a driveway exit and the downstream U-turn bay impacts the safety performance of vehicles making right-turns followed by U-turns (RTUT). With the crash data analysis results, the minimum separation distances under different roadway conditions were determined to facilitate driver use of RTUTs. The capacity of U-turn movement was analyzed under two different situations: (1) U-turns are provided at a signalized intersection; and (2) U-turns are provided at an unsignalized intersection. Adjustment factors were developed to quantify the impacts of the presence of U-turning vehicles on the capacity of a signalized intersection. The critical gaps and follow-up time for U-turn movement at unsignalized intersections were estimated. With the estimated critical gaps and follow-up time, the Harders model was used to determine the capacity of U-turn movem ent at an unsignalized intersection. This study also looks extensively at the minimum roadway width and median width required by vehicles to perform U-turn maneuvers on 4-lane divided roadways. It was found that a roadway width of 46 ft is generally sufficient for most types of design vehicles (except heavy vehicles) to perform a continuous U-turn maneuver without impedance.

Abstract: Road traffic accidents claim more than 1,500 lives each year in Canada and affect society adversely, so transport authorities must reduce their impact. This is a major concern in Quebec, where the traffic-accident risks increase year by year proportionally to provincial population growth. In reality, the occurrence of traffic crashes is rarely random in space-time; they tend to cluster in specific areas such as intersections, ramps, and work zones. Moreover, weather stands out as an environmental risk factor that affects the crash rate. Therefore, traffic-safety engineers need to accurately identify the location and time of traffic accidents. The occurrence of such accidents actually is determined by some important factors, including traffic volume, weather conditions, and geometric design. This study aimed at identifying hotspot locations based on a historical crash data set and spatiotemporal patterns of traffic accidents with a view to improving road safety. This thesis proposes two new methods for identifying hotspot locations on a road network. The first method could be used to identify and rank hotspot locations in cases in which the value of traffic volume is available, while the second method is useful in cases in which the value of traffic volume is not. These methods were examined with three years of traffic-accident data (2011–2013) in Sherbrooke. The first method proposes a two-step integrated approach for identifying traffic-accident hotspots on a road network. The first step included a spatial-analysis method called network kernel-density estimation. The second step involved a network-screening method using the critical crash rate, which is described in the Highway Safety Manual. Once the traffic-accident density had been estimated using the network kernel-density estimation method, the selected potential hotspot locations were then tested with the critical-crash-rate method. The second method offers an integrated approach to analyzing spatial and temporal (spatiotemporal) patterns of traffic accidents and organizes them according to their level of significance. The spatiotemporal seasonal patterns of traffic accidents were analyzed using the kernel-density estimation; it was then applied as the attribute for a significance test using the local Moran’s I index value. The results of the first method demonstrated that over 90% of hotspot locations in Sherbrooke were located at intersections and in a downtown area with significant conflicts between road users. It also showed that signalized intersections were more dangerous than unsignalized ones; over half (58%) of the hotspot locations were located at four-leg signalized intersections. The results of the second method show that crash patterns varied according to season and during certain time periods. Total seasonal patterns revealed denser trends and patterns during the summer, fall, and winter, then a steady trend and pattern during the spring. Our findings also illustrated that crash patterns that applied accident severity were denser than the results that only involved the observed crash counts. The results clearly show that the proposed methods could assist transport authorities in quickly identifying the most hazardous sites in a road network, prioritizing hotspot locations in a decreasing order more efficiently, and assessing the relationship between traffic accidents and seasons. / Les accidents de la route sont responsables de plus de 1500 décès par année au Canada et ont des effets néfastes sur la société. Aux yeux des autorités en transport, il devient impératif d’en réduire les impacts. Il s’agit d’une préoccupation majeure au Québec depuis que les risques d’accidents augmentent chaque année au rythme de la population. En réalité, les accidents routiers se produisent rarement de façon aléatoire dans l’espace-temps. Ils surviennent généralement à des endroits spécifiques notamment aux intersections, dans les bretelles d’accès, sur les chantiers routiers, etc. De plus, les conditions climatiques associées aux saisons constituent l’un des facteurs environnementaux à risque affectant les taux d’accidents. Par conséquent, il devient impératif pour les ingénieurs en sécurité routière de localiser ces accidents de façon plus précise dans le temps (moment) et dans l’espace (endroit). Cependant, les accidents routiers sont influencés par d’importants facteurs comme le volume de circulation, les conditions climatiques, la géométrie de la route, etc. Le but de cette étude consiste donc à identifier les points chauds au moyen d’un historique des données d’accidents et de leurs répartitions spatiotemporelles en vue d’améliorer la sécurité routière. Cette thèse propose deux nouvelles méthodes permettant d’identifier les points chauds à l’intérieur d’un réseau routier. La première méthode peut être utilisée afin d’identifier et de prioriser les points chauds dans les cas où les données sur le volume de circulation sont disponibles alors que la deuxième méthode est utile dans les cas où ces informations sont absentes. Ces méthodes ont été conçues en utilisant des données d’accidents sur trois ans (2011-2013) survenus à Sherbrooke. La première méthode propose une approche intégrée en deux étapes afin d’identifier les points chauds au sein du réseau routier. La première étape s’appuie sur une méthode d’analyse spatiale connue sous le nom d’estimation par noyau. La deuxième étape repose sur une méthode de balayage du réseau routier en utilisant les taux critiques d’accidents, une démarche éprouvée et décrite dans le manuel de sécurité routière. Lorsque la densité des accidents routiers a été calculée au moyen de l’estimation par noyau, les points chauds potentiels sont ensuite testés à l’aide des taux critiques. La seconde méthode propose une approche intégrée destinée à analyser les distributions spatiales et temporelles des accidents et à les classer selon leur niveau de signification. La répartition des accidents selon les saisons a été analysée à l’aide de l’estimation par noyau, puis ces valeurs ont été assignées comme attributs dans le test de signification de Moran. Les résultats de la première méthode démontrent que plus de 90 % des points chauds à Sherbrooke sont concentrés aux intersections et au centre-ville où les conflits entre les usagers de la route sont élevés. Ils révèlent aussi que les intersections contrôlées sont plus à risque par comparaison aux intersections non contrôlées et que plus de la moitié des points chauds (58 %) sont situés aux intersections à quatre branches (en croix). Les résultats de la deuxième méthode montrent que les distributions d’accidents varient selon les saisons et à certains moments de l’année. Les répartitions saisonnières montrent des tendances à la densification durant l’été, l’automne et l’hiver alors que les distributions sont plus dispersées au cours du printemps. Nos observations indiquent aussi que les répartitions ayant considéré la sévérité des accidents sont plus denses que les résultats ayant recours au simple cumul des accidents. Les résultats démontrent clairement que les méthodes proposées peuvent: premièrement, aider les autorités en transport en identifiant rapidement les sites les plus à risque à l’intérieur du réseau routier; deuxièmement, prioriser les points chauds en ordre décroissant plus efficacement et de manière significative; troisièmement, estimer l’interrelation entre les accidents routiers et les saisons.