Hydrogen can be an unlimited source of clean energy for future because of its very high energy density compared to the conventional fuels like gasoline. An efficient and safer way of storing hydrogen is in metals and alloys as hydrides. Light metal hydrides, alanates and borohydrides have very good hydrogen storage capacity, but high operation temperatures hinder their application. Improvement of thermodynamic properties of these hydrides is important for their commercial use as a source of energy. Application of pressure on materials can have influence on their properties favoring hydrogen storage. Hydrogen desorption in many complex hydrides occurs above the transition temperature. Therefore, it is important to study the physical properties of the hydride compounds at ambient and high pressure and/or high temperature conditions, which can assist in the design of suitable storage materials with desired thermodynamic properties. The high pressure-temperature phase diagram, thermal expansion and compressibility have only been evaluated for a limited number of hydrides so far. This situation serves as a main motivation for studying such properties of a number of technologically important hydrides. Focus of this dissertation was on X-ray diffraction and Raman spectroscopy studies of Mg2FeH6, Ca(BH4)2, Mg(BH4)2, NaBH4, NaAlH4, LiAlH4, LiNH2BH3 and mixture of MgH2 with AlH3 or Si, at different conditions of pressure and temperature, to obtain their bulk modulus and thermal expansion coefficient. These data are potential source of information regarding inter-atomic forces and also serve as a basis for developing theoretical models. Some high pressure phases were identified for the complex hydrides in this study which may have better hydrogen storage properties than the ambient phase. The results showed that the highly compressible B-H or Al-H bonds and the associated bond disordering under pressure is responsible for phase transitions observed in brorohydrides or alanates. Complex hydrides exhibited very high compressibility suggesting possibility to destabilize them with pressure. With high capacity and favorable thermodynamics, complex hydrides are suitable for reversible storage. Further studies are required to overcome the kinetic barriers in complex hydrides by catalytic addition. A comparative study of the hydride properties with that of the constituting metal, and their inter relationships were carried out with many interesting features.

This work focuses on the physical properties and crystallization of theophyline co-crystals. Co-crystals of theophylline with oxalic acid, glutaric acid and maleic acid have been investigated. The DSC curves of these co-crystals show that their first endothermic peaks are all lower than the melting temperature of theophylline. The decomposition temperature of theophylline – oxalic acid co-crystal is at about 230 °C, determined by DSC together with TGA. After decomposition, the remaining theophylline melts at about 279 °C, which is higher than the known melting temperature of theophylline, suggesting a structure difference, ie. a new polymorph may have been formed. The formation of hydrogen bonds in theophylline – oxalic acid co-crystal was investigated by FTIR. Changes of FTIR peaks around 3120 cm-1 reflects the hydrogen bond of basic N of theophylline and hydroxyl H of oxalic acid. The solubility of theophylline – oxalic acid co-crystal and theophylline – glutaric acid co-crystal was determined in 4:1 chlroform – methanol and in pure chloroform respectively. At equilibrium with the solid theophylline – oxalic acid co-crystal, the theophylline concentration is only 60 % of the corresponding value for the pure solid theophylline. At equilibrium with the solid theophylline – glutaric acid co-crystal, the theophylline concentration is at least 5 times higher than the corresponding value for the pure solid theophylline. Two phases of theophylline were found during the solubility determination. In the chloroform – methanol mixture (4:1 in volume ratio) the solubility of the stable polymorph of theophylline is found to be about 14 % lower than that of the metastable phase. Various aspects of the phase diagram of theophylline – oxalic acid co-crystal was explored. Theophylline – oxalic acid co-crystal has been successfully prepared via primary nucleation from a stoichiometric solution mixture of the two components in chloroform – methanol mixture. By slurry conversion crystallization, the co-crystal can be prepared in several solvents, and yield and productivity can be significantly increased. Theophylline – glutaric acid can be successfully prepared via both co-grinding of the two components and slow evaporation with seeding. / QC20100608

<p>This work focuses on the physical properties and crystallization of theophyline co-crystals. Co-crystals of theophylline with oxalic acid, glutaric acid and maleic acid have been investigated.</p><p>The DSC curves of these co-crystals show that their first endothermic peaks are all lower than the melting temperature of theophylline. The decomposition temperature of theophylline – oxalic acid co-crystal is at about 230 °C, determined by DSC together with TGA. After decomposition, the remaining theophylline melts at about 279 °C, which is higher than the known melting temperature of theophylline, suggesting a structure difference, ie. a new polymorph may have been formed. The formation of hydrogen bonds in theophylline – oxalic acid co-crystal was investigated by FTIR. Changes of FTIR peaks around 3120 cm^-1 reflects the hydrogen bond of basic N of theophylline and hydroxyl H of oxalic acid. The solubility of theophylline – oxalic acid co-crystal and theophylline – glutaric acid co-crystal was determined in 4:1 chlroform – methanol and in pure chloroform respectively. At equilibrium with the solid theophylline – oxalic acid co-crystal, the theophylline concentration is only 60 % of the corresponding value for the pure solid theophylline. At equilibrium with the solid theophylline – glutaric acid co-crystal, the theophylline concentration is at least 5 times higher than the corresponding value for the pure solid theophylline. Two phases of theophylline were found during the solubility determination. In the chloroform – methanol mixture (4:1 in volume ratio) the solubility of the stable polymorph of theophylline is found to be about 14 % lower than that of the metastable phase. Various aspects of the phase diagram of theophylline – oxalic acid co-crystal was explored.</p><p>Theophylline – oxalic acid co-crystal has been successfully prepared via primary nucleation from a stoichiometric solution mixture of the two components in chloroform – methanol mixture. By slurry conversion crystallization, the co-crystal can be prepared in several solvents, and yield and productivity can be significantly increased. Theophylline – glutaric acid can be successfully prepared via both co-grinding of the two components and slow evaporation with seeding.</p> / QC20100608

The decrease in thermal decomposition temperature led to the amorphization of RuO2, and nano RuO2 particles were uniformly dispersed in amorphous Ta2O5 matrix. Such nano particles induced the increase in effective surface area for oxygen evolution and change in rate determining step, resulting in a significant decrease in oxygen overpotential. This excellent achievement induced a significant decrease in cell voltage of 0.7 V compared to lead alloy anodes and a voltage reduction of 37 % was achieved for copper electrowinning. Another distinct feature of the amorphous anodes is that nano RuO2 particles increase the overpotential of the unwanted side reaction on the anode, so that the anodic deposition of PbO2 can be completely inhibited. Therefore, the amorphous RuO2-Ta2O5/Ti anodes developed in this thesis have a high possibility to improve the purity of electrowon metal, reduce the maintenance of electrolysis process, prolong the lifetime of the anode, and make a low impact to environment. / 博士(工学) / Doctor of Philosophy in Engineering / 同志社大学 / Doshisha University