No description available.

No description available.

Thesis (M.S. in Engineering Science)--Naval Postgraduate School, December 2003. / Thesis advisor(s): David C. Jenn, Roberto Cristi. Includes bibliographical references (p. 95). Also available online.

The work described in this thesis was carried out at the Institut Laue Langevin, Grenoble, France as a member of the group searching for the electric dipole moment (EDM) of the neutron. The first chapter is an introduction to ultra-cold neutrons (UCN) and their use in the search for an EDM. In chapter two a description is given of the data acquisition procedure and the data analysis method as well as a discussion of the various sources of spurious EDM signals. The data taken by the author yielded the result I-fe/e = ( -3.7 ± 5.4 )xl0-25 cm, which together' with all the other data previously and subsequently collected on PN5 gives I-fe/e = ( -3.7 ± 5.4 )xlO- 25 cm. The third chapter contains some calculations, based on a simple model of the polarizer's properties, of the time dependence of the polarized UCN density in the apparatus during a data ~cquisition cycle. It. also includes the results of the experiments made in an attempt to determine experimentally the model's parameters. The other two chapters are concerned with the problem of transferring efficiently UCN from the 0.6 K volume of the 4He superthermal source to thf! 300 K EDM apparatus without allowing the heat transfer by radiation to overload the source's refrigerator. The possibility of using metal coated polypropylene windows to achieve this aim is investigated in the fourth chapter. In chapter five the infra-red transmission of the stainless steel neutron guides is estimated by calculation and then determined experimentally with a view to using lengths of cold guides to attenuate the radiation heat transfer from the apparatus to the source.

No description available.

Effective dipole moment method has been widely accepted as the de facto technique in predicting the dielectrophoretic force due to the non-uniform electric field. In this method, a finite-particle is modeled as an equivalent point-dipole that would induce a same electric field under the external electric field. This approach is only valid when the particle size is significantly smaller than the characteristic length of interest. This assumption is often violated in a microfluidic device, where the thickness or width of the microchannel can be as small as the particle. It is shown in this numerical study that when the dimensions of the particle were in the same order of magnitude as the characteristic length of the device, dielectrophoretic force can be induced even in a uniform electric field. This force arises due to the disturbance of the particle and the bounding wall. / Singapore-MIT Alliance (SMA)

<p> Using a Q-spoiled Nd-glass laser, an experimental investigation of frequency doubling in NiSO4•6 H2O was carried out. The frequency doubling was observed to occur at a phase matching angle of 56° ± 1°. Experimentally, it is shown that the fundamental frequency at λ = 1.06 μm is an O-ray while the doubled frequency at λ = .53μm is an E-ray. Since the amplitude for electric dipole frequency doubling in NiSO4•6 H2O is zero, these observations are unusual. The observations are attributed to magnetic dipole and/or electric quadrupole frequency doubling. Evidence to support this view comes from the magnitude of the effect and from its azimuthal dependence. The electric quadrupole type frequency doubling is consistent with the data only if the susceptibility coefficients satisfy the relation QאEE =1/2 (QאEE - QאEE ) 1212 1111 1122 </p> / Thesis / Doctor of Philosophy (PhD)

No description available.

It is the purpose of this paper to present experimental data for the determination of the dielectric constant and the dipole moments for a series of olefenic diesters of the cis and trans configurations.

Submitted in fulfilment of the academic requirements for the Degree Master of Engineering: Electrical Engineering, Durban University of Technology. Durban. South Africa, 2015. / This dissertation describes the development and construction of the Multi-frequency Interferometer Telescope for Radio Astronomy (MITRA) at the Durban University of Technology. The MITRA station consists of 2 antenna arrays separated by a baseline distance of 8 m. Each array consists of 8 Log-Periodic Dipole Antennas (LPDAs) operating from 200 MHz to 800 MHz. The design and construction of the LPDA antenna and receiver system is described. The receiver topology provides an equivalent noise temperature of 113.1 K and 55.1 dB of gain. The Intermediate Frequency (IF) stage was designed to produce a fixed IF frequency of 800 MHz. The digital Back-End and correlator were implemented using a low cost Software Defined Radio (SDR) platform and Gnu-Radio software. Gnu-Octave was used for data analysis to generate the relevant received signal parameters including total power, real, and imaginary, magnitude and phase components. Measured results show that interference fringes were successfully detected within the bandwidth of the receiver using a Radio Frequency (RF) generator as a simulated source. This research was presented at the IEEE Africon 2013 / URSI Session Mauritius, and published in the proceedings.