京都大学 / 新制・課程博士 / 博士(エネルギー科学) / 甲第24253号 / エネ博第451号 / 新制||エネ||84(附属図書館) / 京都大学大学院エネルギー科学研究科エネルギー変換科学専攻 / (主査)教授 川那辺 洋, 教授 林 潤, 教授 澄川 貴志 / 学位規則第4条第1項該当 / Doctor of Energy Science / Kyoto University / DFAM

The natural unsteadiness in the post-breakdown flowfield of a 75° sweep delta wing at 40° angle of attack was studied with dual and single point hot-wire anemometry in the Engineering Science and Mechanics (ESM) Wind Tunnel at a Reynolds number Re = 210,000. Data were taken in five crossflow planes surrounding the wing's trailing edge. Results showed a dominant narrowband Strouhal frequency of St = 1.5 covering approximately 80% of the area with lower-intensity broadband secondary frequencies over 15% of that region. Cross-correlations between a fixed and traversing wire were calculated and phase and coherences mapped to determine the convection speed and trajectory of the helical mode instability. High-speed Particle Image Velocimetry (PIV) was conducted over a 75° sweep delta wing at 40° angle of attack in the ESM Water Tunnel II at Re = 45,000. Data were taken along the axis of the vortex in the breakdown flowfield at a speed of 0.1% of the convective time scale of the flow. Animations of instantaneous streamlines and velocity vectors revealed the impression of a helically spiralling vortex core on the measurement plane. Spectral analysis of the PIV data showed reduced frequencies which confirmed those found with the single-point measurements made in the ESM Wind Tunnel. The effect of four novel control surfaces on the breakdown flowfield of the delta wing was studied with surface pressure measurements along the axis of the vortex in the ESM Wind Tunnel. The apex flap was found effective and delayed vortex breakdown by 8° for a fixed wing. The flowfield was characterized over the delta wing executing a pitch-up maneuver at a reduced frequency of 0.06. Surface pressure measurements were taken in the ESM Wind Tunnel and Laser Doppler Velocimetry (LDV) was employed in the ESM Water Tunnel I as both the unmodified wing and then the wing with an apex flap deployed at an optimal angle <font face="Symbol">b</font> = 15° executed the pitch-up. Both sets of data confirmed the hysteresis of the flowfield. The LDV data, taken in two crossflow planes throughout the maneuver, showed an asymmetric breakdown development. As a practical extension of the study of the breakdown wake flowfield, hot-wire measurements were made over an F/A-18 model to determine the spectral characteristics of the flowfield. Three-dimensional vortex interactions were investigated with helium bubble flow visualization in the VPI Stability Tunnel. / Ph. D.

Understanding the physics of mixing for two fluids is a complicated problem and has always been an interesting phenomenon to study. Surface discharge is the oldest, least expensive and simplest way of discharging industrial or domestic wastewater into rivers and estuaries. Because of the lower degree of dilution in surface discharges, critical conditions are more likely to occur. Having a better understanding of the mixing phenomenon in these cases will help to predict the environmental effects more accurately. In this study, surface discharges of jets into waterbodies with or without crossflows were investigated numerically and experimentally. Three-dimensional (3-D) Computational Fluid Dynamics (CFD) models were developed for studying the surface discharge of jets into water bodies using different turbulence models. Reynolds stress turbulence models and spatially filtered Large Eddy Simulation (LES) were used in the numerical models. The effects of inclusion of free surface water in the CFD models on the performance of the numerical model results were investigated. Numerical model results were compared with the experimental data in the literature as well as the experimental works performed in this study. Experimental works for buoyant and non-buoyant surface discharge of jets into crossflow and stagnant water were conducted in this study. A new setup was designed and built in the Civil Engineering Hydraulics Laboratory at the University of Ottawa to perform the desired experiments. Stereoscopic Particle Image Velocimetry (Stereo-PIV) was used to measure the instantaneous spatial and temporal 3-D velocity distribution on several planes of measurement downstream of the jet with the frequency of 40 Hz. Averaged 3-D velocity distribution was extracted on different planes of measurement to show the transformation of the velocity vectors from a “jet-like” to a “plume-like” flow regime. Averaged 3-D velocity distribution and streamlines illustrated the flow transformation of the surface jets. Experimental results detected the formation and evolution of vortices in the surface jet’s flow structure over the measurement zone. Additional turbulent flow characteristics such as the turbulent kinetic energy (k), turbulent kinetic energy dissipation rate (ϵ), and turbulent eddy viscosity (υt) were calculated using the measured time history of the 3-D velocity field.

No description available.

No description available.

No description available.

No description available.

No description available.

No description available.

Thermoacoustic instabilities in modern high-performance, low-emission gas turbine engines are often observable as large amplitude pressure oscillations and can result in serious performance and structural degradations. These acoustic oscillations can cause oscillations in combustor through-flows and given the right phase conditions, can also drive unsteady heat release. This coupling has the potential to enhance the amplitude of pressure oscillations. To curb the potential harms caused by the existence of thermoacoustic instabilities, recent efforts have focused on the active suppression and even complete control of these instabilities. Intuitively, development of effective active combustion control methodologies is strongly dependent on the knowledge of the onset and sustenance of thermoacoustic instabilities. Specially, non-premixed spray combustion environment pose additional challenges due to the inherent unstable dynamics of sprays. The understanding of the manner in which the combustor acoustics affect the spray characteristics, which in turn result in heat release oscillation, is therefore, of paramount importance. The experimental investigations and the modeling studies conducted towards achieving this knowledge have been presented in this dissertation. Experimental efforts comprise both reacting and non-reacting flow studies. Reacting flow experiments were conducted on a overall lean direct injection, swirl-stabilized combustor rig. The investigations spanned combustor characterization and stability mapping over the operating regime. All experiments were performed under atmospheric pressure condition, which is considered as an obvious first step towards providing valuable insights into more intense processes in actual gas turbine combustors. The onset of thermoacoustic instability and the transition of the combustor to two unstable regimes were investigated via phase-locked chemiluminescence imaging and measurement and phase-locked acoustic characterization. It was found that the onset of the thermoacoustic instability is a function of the energy gain of the system, while the sustenance of instability is due to the in-phase relationship between combustor acoustics and unsteady heat release driven by acoustic oscillations. The presence of non-linearities in the system between combustor acoustic and heat release and also between combustor acoustics and air through-flow were found to exist. The impact of high amplitude limit-cycle pressure on droplet breakdown under very low mean airflow and the localized effects of forced primary fuel modulations on heat release were also investigated. The non-reacting flow experiments were conducted to study the spray behavior under the presence of an acoustic field. An isothermal acoustic rig was specially fabricated, where the pressure oscillations were generated using an acoustic driver. Phase Doppler Anemometry was used to measure the droplet velocities and sizes under varying acoustic forcing conditions and spray feed pressures. Measurements made at different locations in the spray were related to these variations in mean and unsteady inputs. The droplet velocities were found to show a second order response to acoustic forcing with the cut-off frequency equal to the relaxation time corresponding to mean droplet size. It was also found that under acoustic forcing the droplets migrate radially away from the spray centerline and show oscillatory excursions in their movement. Non-reacting flow experiments were also performed using Time-Resolved Digital Particle Image Velocimetry to characterize modulated sprays. Frequency response of droplet diameters were analyzed in the pulsed spray. These pilot experiments were conducted to assess the capability of the system to measure dynamic data. Modeling efforts were undertaken to gain physical insights of spray dynamics under the influence of acoustic forcing and to explain the experimental findings. The radial migration of droplets and their oscillatory movement were validated. The flame characteristics in the two unstable regimes and the transition between them were explained. It was found that under certain acoustic and mean air-flow condition, bands of high droplet densities were formed which resulted in diffusion type group burning of droplets. It was also shown that very high acoustic amplitudes cause secondary breakup of droplets. / Ph. D.