A stable dual-wavelength Tm:Ho co-doped fiber laser operating above 2 mu m based on cascaded single mode-multimode-single mode (SMS) all-fiber structures has been proposed and experimentally demonstrated for the first time.

This dissertation presents the fabrication and analysis of in-fiber devices based on elliptical core D-shaped optical fiber. Devices created inside optical fibers are attractive for a variety of reasons including low loss, high efficiency, self-alignment, light weight, multiplexibility, and resistance to electromagnetic interference. This work details how D-fiber can be used as a platform for a variety of devices and describes the creation and performance of two of these devices: an in-fiber polymer waveguide and a surface relief fiber Bragg grating. In D-fiber the core is very close to the flat side of the ‘D’ shape. This proximity allows access to the fields in the fiber core by removal of the cladding above the core. The D-fiber we use also has an elliptical core, allowing for the creation of polarimetric devices. This work describes two different etch processes using hydrofluoric acid (HF) to remove the fiber cladding and core. For the creation of devices in the fiber core, the core is partially removed and replaced with another material possessing the required optical properties. For devices which interact with the evanescent field, cladding removal is terminated before acid breaches the core. Etching fibers prepares them for use in the creation of in-fiber devices. Materials are placed into the groove left when the core of a fiber is partially removed to form a hybrid waveguide in which light is guided by both the leftover core and the inserted material. These in-fiber polymer waveguides have insertion loss less than 2 dB and can potentially be the basis for a number of electro-optic devices or sensors. A polarimetric temperature sensor demonstrates the feasibility of the core replacement method. This work also describes the creation of a surface relief fiber Bragg gratings (SR-FBGs) in the cladding above the core of the fiber. Because it is etched into the surface topography of the fiber, a SR-FBG can operate at much higher temperatures than a standard FBG, up to at least 1100 degrees Celsius. The performance of a SR-FBG is demonstrated in temperature sensing at high temperatures, and as a strain sensor.

This dissertation presents the novel creation of a hybrid D-fiber electro-optic polymer electric field sensor. The sensor is made by removing a portion of the cladding from a D-shaped optical fiber, thus exposing the core to interaction with external stimulus. Then, an electro-optic polymer is deposited, partially replacing the core of the fiber. Next, the polymer is poled to endow it with electro-optic properties. This sensor is packaged in order to restore its mechanical strength. Because D-fiber is not intrinsically compatible with standard optical equipment it is fusion spliced to standard polarization maintaining fiber. Finally the sensor is tested for electro-optic sensitivity. The hybrid D-fiber electric field sensors designed and fabricated in this work meet the requirements of mechanical strength, temporal stability, minimal perturbation of the electric field by the sensor, and a small and flexible cross-sectional area so that it can be embedded into the device under test. A fully packaged hybrid electro-optic polymer D-fiber electric field sensor which is capable of detecting electric fields of 50 V/m at a frequency of 6 GHz is produced. The sensor's electro-optic response is shown to be temporally stable. Additionally, the sensor is physically robust, and physically and electrically non-intrusive. This work also adds a thorough understanding of the design and fabrication of D-fiber waveguides with a polymer material deposited in the core. Several new fabrication techniques are developed and presented. A path to greater electric field sensitivity is outlined for future research.