This master’s thesis deals with design of intake port for turbocharged Mazda 13B-T engine with Wankel-type rotating piston motion aiming for possible modifications leading to increase of performance parameters. The main objective of this thesis is to propose appropriate modifications in order to achieve increased torque in widest possible engine speed range.

Diploma thesis deals with use of combustion chamber to drive the electric bus charging unit. Based on the research and analysis of operation economy, a turboexpander with an air pressure tank is selected to drive the charging unit. A thermodynamic design is created for this variant. Based on this design a unit layout is proposed. Layout drawings are created for the proposed layout.

This thesis deals with the design and implementation of the Internet service, which allows to objectively assess and verify the reliability and diligence of Czech lawyers based on publicly available data of several courts. The aim of the thesis is to create and put into operation this service. The result of the work are the programs that provide partial actions in the realization of this intention.

The master thesis summaries the findings results of a study focused on the spread of noise vibrating flat plates. Part of this thesis is measurements of flat plate noise in the anechoic chamber and finally their processing and evaluation. The next part of the thesis is focused on FEM acoustic simulation and comparing results with measurements.

This master thesis deals with the importance of testing of plastic parts in the automotive industry. It defines the basic principles and concepts of project management within product validation, specifies the principles in the corporate environment of ATEK s.r.o. Part of the thesis is the creation of a validation plan and a schedule of labory tests for the selected product from the BMW AG G20 project. The work defines the conditions and the execution of selected tests, eg the climate change test according to the BMW standard PR303.5. The tests are then evaluated. The output from the evaluation is a product optimization proposal.

The master's thesis describes the design of the steam boiler, which burns biomass with heat output of 6 MW. The required parameters of the steam are a temperature of 300 °C and a pressure of 2,5 MPa. The thesis is gradually devoted to stoichiometric calculations through heat losses and boiler efficiency, to the design of the combustion chambre, heat exchangers and pressure losses. Part of the thesis is drawing documentation of the boiler.

This thesis focuses on the methodology of determining the parameters of Peltier batteries and the theory of construction of a cooling block on the basis of obtained parameters. Gathered information is then used for design and construction of a small test chamber for laboratory purposes.

This document deals with issues of testing semiconductor inertial sensors like gyroscopes and accelerometers, but also other sensors like magnetometers, inclinometers and others for aviation navigation purposes where strict requirements cover every system. The goal of this thesis is to create modular test platform for testing wide variety of sensors in different combinations under variable circumstances. The development covers mechanical design, electrical design – hardware and also control algorithm – software.

This thesis seeks to analyze the impact of a range of projects of Chamber of Commerce Brno on the entrepreneurs from the respective region. The thesis describes the structure and the overall operation of the Chamber of Commerce Brno as well as its several projects. In order to evaluate, there are three marketing researches that need to be taken into a consideration. Those marketing researches had been realised during the period of 2005 – 2007. Baring the results risen from the abovementioned marketing researchs in mind, the created situation has been assessed, and based on the personal experience the recommendations dedicated to the management have been created.

This thesis examines the influence of the intensity of pressure strain of structures printed on the value of air permeability. The measurement is carried out using Blower Door Test on six variants using OSB boards as airtightening layers in the building. Part of the research was to verify the suitability of the test chamber and measuring devices for similar purposes and adjustment chamber