Doctor of Philosophy / Department of Civil Engineering / Mustaque Hossain / The engineers from the Kansas Department of Transportation (KDOT) often have to decide whether or not to accept non-conforming Superpave mixtures during construction. The first part of this study focused on estimating lives of deficient Superpave pavements incorporating nonconforming Superpave mixtures. These criteria were based on the Hamburg Wheel-Tracking Device (HWTD) test results and analysis. The second part of this study focused on developing accelerated mix testing models to considerably reduce test duration. To accomplish the first objective, nine fine-graded Superpave mixes of 12.5-mm nominal maximum aggregate size (NMAS) with asphalt grade PG 64-22 from six administrative districts of KDOT were selected. Specimens were prepared at three different target air void levels @ N[subscript]design gyrations and four target simulated in-place density levels with the Superpave gyratory compactor. Average number of wheel passes to 20-mm rut depth, creep slope, stripping slope, and stripping inflection point in HWTD tests were recorded and then used in the statistical analysis. Results showed that, in general, higher simulated in-place density up to a certain limit of 91% to 93%, results in a higher number of wheel passes until 20-mm rut depth in HWTD tests. A Superpave mixture with very low air voids @ N[subscript]design (2%) level performed very poorly in the HWTD test. HWTD tests were also performed on six 12.5-mm NMAS mixtures with air voids @ N[subscript]design of 4% for six projects, simulated in-place density of 93%, two temperature levels and five load levels with binder grades of PG 64-22, PG 64-28, and PG 70-22. Field cores of 150-mm in diameter from three projects in three KDOT districts with 12.5-mm NMAS and asphalt grade of PG 64-22 were also obtained and tested in HWTD for model evaluation. HWTD test results indicated as expected. Statistical analysis was performed and accelerated mix testing models were developed to determine the effect of increased temperature and load on the duration of the HWTD test. Good consistency between predicted and observed test results was obtained when higher temperature and standard load level were used. Test duration of the HWTD can thus be reduced to two hours or less using accelerated mix testing (statistical) models.

The primary objective of this research was to quantify the improvement in service life of a flexible pavement constructed using full-depth reclamation (FDR) in conjunction with cement stabilization when specified reductions in the spatial variability of specific construction-related parameters are achieved. This study analyzed pavement data obtained through field and laboratory testing of a reconstruction project in northern Utah. Data analyses included multivariate regression, Monte Carlo simulation, and mechanistic-empirical analyses of a model pavement structure. The results of the research show a steadily increasing trend in 28-day unconfined compressive strength of the cement-treated base (CTB) layer with increasing reductions in variability for cement content, moisture content, and reclaimed asphalt pavement (RAP) content across each of five different reliability levels. The most significant increases in CTB strength occurred with reductions in the standard deviations of moisture content and RAP content. Decreasing the variability of cement content did not provide significant additional strength to the CTB layer. Therefore, when involved on FDR projects, members of the pavement industry should focus energy on reducing the variability of both moisture content and RAP content, which both significantly impact pavement life, to achieve high-quality, long-lasting pavements.

Master‘s thesis deals with pavement management system applied on roads of 2nd and 3rd class in region of Hradec Králové. Its task is to collect failures of pavement, evaluate pavement condition and make plans of pavement maintenance and rehabilitation in variants. One of tasks is also to evaluate attitude of pavement management system in regional level, but also to evaluate the contributions and weaknesses of systematic steps and attitude of access of stakeholders.