The aims and objectives: The aims and objectives of this study were to characterize and compare the airborne particulate matter in the tankhouse and crusher areas of a base metal refinery sampled with two separate methods, in terms of mass concentration, nickel content, and particle size distribution. Methods: Area sampling was conducted in the two areas. Two methods were applied to collect particulate samples. The first is a multi–stage virtual impactor, the Respicon, which was used to determine the three critical particle fractions (inhalable, thoracic and respirable). The NIOSH 7300 method determined the particle concentration and nickel percentage present in each fraction. Using formulas provided by the manufacturers two additional particle–size fractions (extra–thoracic and trachea–bronchial) could be calculated. The second was based on the standard NIOSH 0500 method, which determined particle size distribution depicted as cumulative percentages. The samples were analyzed using laser scattering instrumentation. Results: In the tankhouse the highest level of exposure was to particles bigger than 10 um, with the highest nickel percentage also falling into this range. However, high nickel percentages were present in all three cut–off sizes (4 um, 10 um and > 10 um). The particle concentration for the crusher area was the highest for particulates bigger than 10 um, with the highest nickel percentage present in this fraction. After comparing the tankhouse and crusher areas, it is clear that the particle concentration is much higher in the crusher area according to all sampling methods used. The nickel content present in the analysis of these areas is of great concern. Conclusion: With the knowledge obtained through this research one hopes to establish a basis for particle size sampling in the platinum mining industry. This may lead to the development of health based OEL's and reflect a more accurate evaluation of workers particulate exposure. This information will give a greater understanding of health risks workers are exposed to. / Thesis (M.Sc. (Occupational Hygiene))--North-West University, Potchefstroom Campus, 2011.

The aims and objectives: The aims and objectives of this study were to characterize and compare the airborne particulate matter in the tankhouse and crusher areas of a base metal refinery sampled with two separate methods, in terms of mass concentration, nickel content, and particle size distribution. Methods: Area sampling was conducted in the two areas. Two methods were applied to collect particulate samples. The first is a multi–stage virtual impactor, the Respicon, which was used to determine the three critical particle fractions (inhalable, thoracic and respirable). The NIOSH 7300 method determined the particle concentration and nickel percentage present in each fraction. Using formulas provided by the manufacturers two additional particle–size fractions (extra–thoracic and trachea–bronchial) could be calculated. The second was based on the standard NIOSH 0500 method, which determined particle size distribution depicted as cumulative percentages. The samples were analyzed using laser scattering instrumentation. Results: In the tankhouse the highest level of exposure was to particles bigger than 10 um, with the highest nickel percentage also falling into this range. However, high nickel percentages were present in all three cut–off sizes (4 um, 10 um and > 10 um). The particle concentration for the crusher area was the highest for particulates bigger than 10 um, with the highest nickel percentage present in this fraction. After comparing the tankhouse and crusher areas, it is clear that the particle concentration is much higher in the crusher area according to all sampling methods used. The nickel content present in the analysis of these areas is of great concern. Conclusion: With the knowledge obtained through this research one hopes to establish a basis for particle size sampling in the platinum mining industry. This may lead to the development of health based OEL's and reflect a more accurate evaluation of workers particulate exposure. This information will give a greater understanding of health risks workers are exposed to. / Thesis (M.Sc. (Occupational Hygiene))--North-West University, Potchefstroom Campus, 2011.

Background: The Platinum mining operations in South Africa mining platinum containing ore from areas where variable amounts of uranium are found, leading to the possibility of occupational exposure to the radioactive disintegration products of Uranium-238 and in particular the gas Radon-222. No scientific data is available for occupational exposure to Radon-222 in South African platinum mining operations. Objective: To determine the risk of occupational exposure to the radioactive disintegration products of naturally occurring Radon-222 gas in a South African platinum mine. Design: Quantitative sampling (personal and static) to establish baseline data on exposure to radioactive disintegration products of naturally occurring Radon-222 gas in a underground South African platinum mine. Setting: The Bafokeng Rasimone platinum mine located 30 km North West of Rustenburg in the Bushveld complex in the North West Province of South Africa. Study subjects: One hundred and seventy four potentially highest exposed underground employees and one hundred and twelve static underground samples were sampled. Method: Personal and area samples were taken on selected employees and in locations using RGM samplers using CR-39 plastic as a detection medium. Employees were selected to sample the highest exposed occupations and static samples were located to sample returning air from levels underneath the sampling point before it is exhausted to the above ground atmosphere. After analysis by an accredited laboratory, the results were converted to exposure following the National Council on Radiation Protection-78 methodology. Main outcome measures: Quantify the relative risks of potentially highest exposed employee`s exposure to the radioactive disintegration products of naturally occurring Radon-222 gas in underground working areas in milliSievert per year. Results: The mean reference background exposure averaged 0.6168 mSv/a with underground personal exposure averaging 0.6808 mSv/a, and underground static exposure averaging 0.8726 mSv/a. These values are substantially below the 50 mSv/a Occupational Exposure Limit, and only pose a slightly elevated risk for the development of lung cancer above the normal back-ground exposure. Mining Team leaders and rock drill operators were identified as the potentially highest exposed employees due to the close proximity to the working face, large amounts of time spent close to the working face and the lower ventilation volumes at the working face, with Team leaders having the highest exposure of the sampled occupations with a average of 1.16 mSv/a. Conclusions: Occupational exposure to radioactive disintegration products of naturally occurring Radon-222 gas in the underground air of a South African platinum mine does not pose a significant risk to the health of employees working in the platinum mine. / Thesis (MSc (Occupational Hygiene))--North-West University, Potchefstroom Campus, 2013.

Background: The Platinum mining operations in South Africa mining platinum containing ore from areas where variable amounts of uranium are found, leading to the possibility of occupational exposure to the radioactive disintegration products of Uranium-238 and in particular the gas Radon-222. No scientific data is available for occupational exposure to Radon-222 in South African platinum mining operations. Objective: To determine the risk of occupational exposure to the radioactive disintegration products of naturally occurring Radon-222 gas in a South African platinum mine. Design: Quantitative sampling (personal and static) to establish baseline data on exposure to radioactive disintegration products of naturally occurring Radon-222 gas in a underground South African platinum mine. Setting: The Bafokeng Rasimone platinum mine located 30 km North West of Rustenburg in the Bushveld complex in the North West Province of South Africa. Study subjects: One hundred and seventy four potentially highest exposed underground employees and one hundred and twelve static underground samples were sampled. Method: Personal and area samples were taken on selected employees and in locations using RGM samplers using CR-39 plastic as a detection medium. Employees were selected to sample the highest exposed occupations and static samples were located to sample returning air from levels underneath the sampling point before it is exhausted to the above ground atmosphere. After analysis by an accredited laboratory, the results were converted to exposure following the National Council on Radiation Protection-78 methodology. Main outcome measures: Quantify the relative risks of potentially highest exposed employee`s exposure to the radioactive disintegration products of naturally occurring Radon-222 gas in underground working areas in milliSievert per year. Results: The mean reference background exposure averaged 0.6168 mSv/a with underground personal exposure averaging 0.6808 mSv/a, and underground static exposure averaging 0.8726 mSv/a. These values are substantially below the 50 mSv/a Occupational Exposure Limit, and only pose a slightly elevated risk for the development of lung cancer above the normal back-ground exposure. Mining Team leaders and rock drill operators were identified as the potentially highest exposed employees due to the close proximity to the working face, large amounts of time spent close to the working face and the lower ventilation volumes at the working face, with Team leaders having the highest exposure of the sampled occupations with a average of 1.16 mSv/a. Conclusions: Occupational exposure to radioactive disintegration products of naturally occurring Radon-222 gas in the underground air of a South African platinum mine does not pose a significant risk to the health of employees working in the platinum mine. / Thesis (MSc (Occupational Hygiene))--North-West University, Potchefstroom Campus, 2013.