In our modern society, we are surrounded by numerous sensors, constantly feeding us information about our physical environment. From small, wearable sensors that monitor our physiological status to large satellites orbiting around the earth, detecting global changes. Although, the performance of these sensors have been significantly improved during the last decades there is still a demand for faster and more reliable sensing systems with improved sensitivity and selectivity. The rapid progress in nanofabrication techniques has made a profound impact for the development of small, novel sensors that enables miniaturization and integration. A specific area where nanostructures are especially attractive is biochemical sensing, where the exceptional properties of nanomaterials can be utilized in order to detect and analyze biomolecular interactions.  The focus of this thesis is to investigate plasmonic nanoparticles composed of gold or silver and optimize their performance as signal transducers in optical biosensors. Metal nanoparticles exhibit unique optical properties due to excitation of localized surface plasmons, which makes them highly sensitive probes for detecting small, local changes in their surrounding environment, for instance the binding of a biomolecule to the nanoparticle surface. This is the basic principle behind nanoplasmonic sensing based on refractometric detection, a sensing scheme that offers real-time and label-free detection of molecular interactions.  This thesis shows that the sensitivity for detecting local refractive index changes is highly dependent on the geometry of the metal nanoparticles, their interaction with neighboring particles and their chemical composition and functionalization. An increased knowledge about how these parameters affects the sensitivity is essential when developing nanoplasmonic sensing devices with high performance based on metal nanoparticles.

Cavity enhanced spectroscopies (CES) are currently amongst the most sensitive spectroscopic techniques available for probing gas-phase samples, however their application to the liquid-phase has been more limited. Sensitive analysis of submicrolitre liquid samples is highly desirable, as miniaturisation allows for the reaction and analysis of scarce or expensive reagents, produces less waste, and can increase the speed of separations and reactions, whilst having a small footprint and high throughput. Absorption spectroscopy is a particularly desirable technique due to its universal, label-free nature, however its application to small volume liquid samples is hampered by the associated short absorption pathlengths, which limit sensitivity. CES improve sensitivity by trapping light within a confined region, increasing the effective pathlength through the sample. Three distinct types of optical cavity were constructed and evaluated for the purposes of making optical absorption measurements on liquid samples. The first incorporated a high optical quality flow cell into a "macrocavity" formed from two dielectric mirrors separated by 51.3 cm. Cavity losses were minimised by positioning the flow cell at Brewster's angle to the optical axis, and the setup was used to perform a single-wavelength cavity ringdown spectroscopy experiment to detect and quantify nitrite within aqueous samples. The detection limit was determined to be 8.83 nM nitrite in an illuminated volume of only 74.6 nL. Scattering and reflective losses from the flow cell surfaces were found to be the largest barrier to increased sensitivity, leading us to focus on the integration of cavity mirrors within a microfluidic flow system in the work that followed. In the second set of experiments, cavity enhanced absorption spectroscopy (CEAS) measurements were performed on Thymol Blue using custom-made microfluidic chips with integrated cavity mirrors. Unfortunately, due to the plane-parallel configuration of the mirrors and the corresponding difficulty in sustaining stable cavity modes, the results were underwhelming, with a maximum cavity enhancement factor (CEF) of only 2.68. At this point, attention was focussed toward a more well-defined cavity geometry: open-access plano-concave microcavities. The microcavities consist of an array of micron-scale concave mirrors opposed by a planar mirror, with a pathlength that is tunable to sub-nanometer precision using piezoelectric actuators. In contrast to the other experimental setups described, themicrocavities allow for optical measurements to be performed in which we monitor the change of wavelength and/or amplitude of a single well-defined cavity mode in response to a liquid sample introduced between the mirrors. In the first microcavity experiment, we used 10 μm diameter mirrors with cavity lengths from 2.238 μm to 10.318 μm to demonstrate refractive index sensing in glucose solutions with a limit of detection of 3.5 x 10^-4 RIU. The total volume of detection in our setup was 54 fL. Thus, at the limit of detection, the setup can detect the change of refractive index that results from the introduction of 900 zeptomoles (500,000 molecules) of glucose into the device. The microcavity sensor was then adapted to enable broadband absorption measurements of methylene blue via CEAS. By recording data simultaneously from multiple cavities of differing lengths, absorption data is obtained at a number of wavelengths. Using 10 μm diameter mirrors with cavity pathlengths from 476 nm to 728 nm, a limit of detection, expressed as minimum detectable absorption per unit pathlength, of 1.71 cm^-1 was achieved within a volume of 580 attolitres, corresponding to less than 2000 molecules within the mode volume of the cavity. Finally, a new prototype was developed with improved cavity finesse, a much more intense and stable light source, and improved flow design. Using a single plano-concave microcavity within the array with a cavity pathlength of 839.7 nm, and 4 μm radius of curvature mirror, absorption measurements were performed on Methylene Blue. Analysis of this data indicated a CEF of around 9270, and a limit of detection based on the measured signal-to-noise ratio of 0.0146 cm^-1. This corresponds to a minimum detectable concentration of 104 nM Methylene Blue, which given the mode volume of 219 aL, suggests a theoretical minimum detectable number of molecules of 14.

In this thesis devices for controlling the flow of surface plasmon polaritons are described. Dielectric and metallic nanostructures were designed for this purpose, and characterized by leakage radiation microscopy in real and in reciprocal spaces. Manipulation of surface plasmons by dielectric lenses and gradient index elements is presented, and negative refraction, steering and self-collimation of surface plasmons in one- and two-dimensional plasmonic crystals is demonstrated. The achieved degree of control was applied for routing of nanoparticles by optical forces, as well as for two methods of enhancing the figures of merit of plasmonic refractive index sensors, based on the one hand on Fano resonances natural to leakage radiation microscopy, and on the other hand on anisotropie plasmonic bandstructures.

Ce manuscrit s'inscrit dans le contexte du contrôle de la propagation des plasmons de surface. A cet effet, des nanostructures diélectriques et métalliques ont été conçues et caractérisées par microscopie à champ de fuite dans les espaces réels et réciproques. La manipulation des plasmons de surface à l'aide de lentilles diélectriques et d' éléments à gradient d'indice est présentée, et la réfraction négative, la direction et l'auto-collimation des plasmons de surface dans des cristaux plasmoniques à une ou deux dimensions sont démontrées. Ces résultats ont été utilisés pour le guidage de nanoparticules à l'aide de forces optiques, ainsi que pour deux méthodes permettant de renforcer le facteur de mérite de sondes plasmoniques de variation d'indice de réfraction, basées l' une sur les résonances de Fano naturelles de la microscopie à champ de fuite, et pour la seconde sur les structures des bandes plasmoniques anisotropes. / In this thesis devices for controlling the flow of surface plasmon polaritons are described. Dielectric and metallic nanostructures were designed for this purpose, and characterized by leakage radiation microscopy in real and in reciprocal spaces. Manipulation of surface plasmons by dielectric lenses and gradient index elements is presented, and negative refraction, steering and self-collimation of surface plasmons in one- and two-dimensional plasmonic crystals is demonstrated. The achieved degree of control was applied for routing of nanoparticles by optical forces, as well as for two methods of enhancing the figures of merit of plasmonic refractive index sensors, based on the one hand on Fano resonances natural to leakage radiation microscopy, and on the other hand on anisotropie plasmonic bandstructures.