1 |
The Hydrodynamics of Pool-Riffle Sequences with Changing Bedform LengthObach, Lana M. January 2011 (has links)
Previous research has demonstrated that pool-riffle bedforms play a critical role in channel stability and ecosystem health in many natural gravel-bed channels. Although the bedform length is known to scale with channel width, no experimental research has yet isolated the effect of bedform length on pool-riffle hydrodynamics. To improve the understanding of the hydrodynamics of these bedforms so that they can be better incorporated in restoration practices, flume experiments were conducted testing the flow at seven different bedform lengths.
Velocity profiles are measured in a 17 m flume with movable PVC bedforms using ultrasonic velocity profilers (UVPs). Smooth two-dimensional (no sinuosity) bedforms are used in order to isolate the key dynamics in convective acceleration and deceleration. The angle of transition between pool and riffle heights was 7°, so that permanent flow separation did not occur. Parameters calculated from the velocity and turbulence profiles include the Coles’ wake parameter (a measure of the deviation from the log law), shear stress estimated from the velocity profile, shear stress estimated from the Reynolds shear stress, and vertical velocity. From the individual velocity time series, the integral length scale and the integral time scales are also calculated.
Overall, the length of riffles and pools exert a fundamental control on the distribution of flow and turbulence within a channel. In the pool, energy is dissipated both through turbulence and as the flow is redistributed to uniform flow conditions. In the riffle, kinetic energy increases as the flow velocity increases, and as the length increases, the flow moves towards a new uniform flow condition. The results start to explain the reasons behind the persistent scaling relation between width and bedform length. It can be concluded that uniform flow conditions exist at the end of the pool when the bedform length ratio is greater than approximately 1:5.0 when the riffle length is held constant, and that uniform flow conditions are no longer observed at the end of the pool when the bedform length ratio exceeds 1:7.0 when the pool length is held constant.
Future research should concentrate on extending the results to include three-dimensional pool-riffle configurations, repeating bedform configurations, internal scaling parameters, and sediment transport. Ultimately, as the hydrodynamics of pool-riffle sequences are better understood, better bedform designs can be implemented in restoration projects.
|
2 |
The Hydrodynamics of Pool-Riffle Sequences with Changing Bedform LengthObach, Lana M. January 2011 (has links)
Previous research has demonstrated that pool-riffle bedforms play a critical role in channel stability and ecosystem health in many natural gravel-bed channels. Although the bedform length is known to scale with channel width, no experimental research has yet isolated the effect of bedform length on pool-riffle hydrodynamics. To improve the understanding of the hydrodynamics of these bedforms so that they can be better incorporated in restoration practices, flume experiments were conducted testing the flow at seven different bedform lengths.
Velocity profiles are measured in a 17 m flume with movable PVC bedforms using ultrasonic velocity profilers (UVPs). Smooth two-dimensional (no sinuosity) bedforms are used in order to isolate the key dynamics in convective acceleration and deceleration. The angle of transition between pool and riffle heights was 7°, so that permanent flow separation did not occur. Parameters calculated from the velocity and turbulence profiles include the Coles’ wake parameter (a measure of the deviation from the log law), shear stress estimated from the velocity profile, shear stress estimated from the Reynolds shear stress, and vertical velocity. From the individual velocity time series, the integral length scale and the integral time scales are also calculated.
Overall, the length of riffles and pools exert a fundamental control on the distribution of flow and turbulence within a channel. In the pool, energy is dissipated both through turbulence and as the flow is redistributed to uniform flow conditions. In the riffle, kinetic energy increases as the flow velocity increases, and as the length increases, the flow moves towards a new uniform flow condition. The results start to explain the reasons behind the persistent scaling relation between width and bedform length. It can be concluded that uniform flow conditions exist at the end of the pool when the bedform length ratio is greater than approximately 1:5.0 when the riffle length is held constant, and that uniform flow conditions are no longer observed at the end of the pool when the bedform length ratio exceeds 1:7.0 when the pool length is held constant.
Future research should concentrate on extending the results to include three-dimensional pool-riffle configurations, repeating bedform configurations, internal scaling parameters, and sediment transport. Ultimately, as the hydrodynamics of pool-riffle sequences are better understood, better bedform designs can be implemented in restoration projects.
|
3 |
The Spatial Heterogeneity of Periphyton in Eight Southeastern Ohio Streams: How Far Can One Sample Take You?Hollingsworth, Emily K. January 2007 (has links)
No description available.
|
4 |
The food and feeding interrelationships of five sympatric darter species (Pisces: Percidae) in Salt Creek, Hocking County, OhioWehnes, Richard Eric January 1973 (has links)
No description available.
|
5 |
Heat transport and tracing within the hyporheic zone of a pool-riffle-pool sequenceSwanson, Travis Eric 26 October 2010 (has links)
Hyporheic water is thought to infiltrate at the head of a riffle which in turn is complemented by upwelling back to the stream at the tail of the riffle in a pool-riffle-pool (PRP) sequence. Heat tracing is a potentially useful method to characterize these hyporheic flow paths and quantify associated fluxes. Temperature was monitored within a PRP sequence for several days. Temperature in the hyporheic zone reflected the diel temperature change in the river but not uniformly. The observed thermal pattern exhibited deeper penetration of thermal oscillations below the head pool and shallower penetration below the tail pool. This pattern is consistent with the conceptual model of hyporheic exchange over a PRP sequence. One-dimensional analytical heat transport models were used at different points below the PRP sequence to estimate distributed vertical fluid fluxes. The calculated fluxes exhibit a trend that follows the expected distribution for a PRP sequence but modified for a losing stream. Deviation of both magnitude and distribution of fluxes from the conceptual ‘downwelling-to-upwelling’ model is partly due to the dominantly losing conditions at the study site but the trends are consistent with a losing stream undergoing hyporheic exchange. Violation of the assumptions in the analytical models most likely adds error to flux estimates. For this study, flux estimation methods using a temperature time series amplitude analysis more closely matched field measurements than phase methods. / text
|
6 |
A comparative study of the behavior and ecology of two sympatric darters (<i>Etheostoma zonale</i>(Cope) and <i>Etheostoma blennioides</i> (Rafinesque)) in Ohio with special reference to competitionAlbin, Howard Thomas January 1972 (has links)
No description available.
|
7 |
Effekt av biotopvård på öringpopulationen i två vattendragSahlberg, Tony January 2010 (has links)
<p>I have done a follow up study of the restoration of two rivers, Röälven and Grundan, in order to evaluate the effects of the restoration on the endemic population of trout. Both rivers have been used for timber floating during many years throughout the 20<sup>th</sup> century, and because of this, had all obstacles such as rocks and wood parts removed. In 2004-2005 both rivers were restored, and rocks and wood were put back into the rivers. Spawning grounds were created and boulder dams were constructed to promote the streaming water. The result showed that the trout population of both rivers increased after the restoration, but also that the trout population of Röälven increased more than that of Grundan. My conclusion is that the way the restoration is of a river contributes to the result.</p>
|
8 |
河床攪乱頻度を指標とした生息場評価による瀬・淵構造の変質に関する考察田代, 喬, TASHIRO, Takashi, 辻本, 哲郎, TSUJIMOTO, Tetsuro 02 1900 (has links)
No description available.
|
9 |
Effekt av biotopvård på öringpopulationen i två vattendragSahlberg, Tony January 2010 (has links)
I have done a follow up study of the restoration of two rivers, Röälven and Grundan, in order to evaluate the effects of the restoration on the endemic population of trout. Both rivers have been used for timber floating during many years throughout the 20th century, and because of this, had all obstacles such as rocks and wood parts removed. In 2004-2005 both rivers were restored, and rocks and wood were put back into the rivers. Spawning grounds were created and boulder dams were constructed to promote the streaming water. The result showed that the trout population of both rivers increased after the restoration, but also that the trout population of Röälven increased more than that of Grundan. My conclusion is that the way the restoration is of a river contributes to the result.
|
10 |
On the Design of Instream Structures in the Mid-Atlantic United States: An Investigation of the Design, Project, and Watershed Factors that Affect Structure SuccessSmith, Benjamin Servais 19 May 2021 (has links)
Instream structures are used to reinforce channel margins, redirect flows, and create habitat, but there is little consensus about their design or whether they function as intended. In this study, 536 instream structures in the state of Maryland were assessed to determine the effect of structure-, project-, and watershed-scale factors on performance. Structures were assessed using a 19 point scoring system based on structural stability, sediment transport, and overall function. Structure-scale variables related to the construction, geometry, and placement, and differed for six structure families: bank protection (BP), full and partial span vanes (FSV), constructed riffles (RF), regenerative stream conveyances, and step pools. Project- and watershed-scale variables related to flow, erosion resistance, and design approach. Relationships between structure scores and explanatory variables were evaluated using regression analysis. Structure performance was strongly influenced by the individual project, suggesting that design quality, construction, and maintenance are as important as specific design features. Structure durability decreased if there was additional urban development following construction. Results also indicated that restoration activities have a "protective effect" on nearby structures. For rock BP, imbricated rock walls performed better than stone toe, due to increased structure height and boulder size. Rock FSVs that were keyed into the bank at angles between 35° and 90° were more durable, while RFs performed best when constructed using downstream grade control and increased substrate depth. The results of this study provide insight into design and project features that contribute to structure success. / Master of Science / Stream restoration aims to rehabilitate streams that have been impacted by humans, and log or rock structures in the channel are utilized to protect the bed and banks, redirect water away from the banks, and create habitat for aquatic organisms. However, there are few design standards for these structures. In this study, 536 instream structures in the state of Maryland were assessed to determine the effect of design and site characteristics on performance. Structures were scored for performance based on structural stability, sedimentation, erosion, and function. Design characteristics related to structure construction and placement, while site conditions related to the project and watershed characteristics. Statistical analyses were used to determine the relationship between structure performance and design and site characteristics. Structure performance was strongly influenced by the restoration project, indicating that design quality, construction, and maintenance are as important as specific design features. Structure durability decreased if there was additional urban development in the watershed following construction. Results also indicated that when structures were used in series, there was a "protective effect" on other nearby structures. Rock walls performed better as height increased, while rock weirs that were constructed into the streambank between 35° and 90° were more durable. These results provide insight into design and project features that contribute to structure success.
|
Page generated in 0.0207 seconds