Recent research has shown that incorporating roadway safety in transportation planning has been considered one of the active approaches to improve safety. Aggregate level analysis for predicting crash frequencies had been contemplated to be an important step in this process. As seen from the previous studies various categories of predictors at macro level (census blocks, traffic analysis zones, census tracts, wards, counties and states) have been exhausted to find appropriate correlation with crashes. This study contributes to this ongoing macro level road safety research by investigating various trip productions and attractions along with roadway characteristics within traffic analysis zones (TAZs) of four counties in the state of Florida. Crashes occurring in one thousand three hundred and forty-nine TAZs in Hillsborough, Citrus, Pasco, and Hernando counties during the years 2005 and 2006 were examined in this study. Selected counties were representative from both urban and rural environments. To understand the prevalence of various trip attraction and production rates per TAZ the Euclidian distances between the centroid of a TAZ containing a particular crash and the centroid of the ZIP area containing the at fault driver's home address for that particular crash was calculated. It was found that almost all crashes in Hernando and Citrus County for the years 2005-2006 took place in about 27 miles radius centering at the at-fault drivers' home. Also about sixty-two percent of crashes occurred approximately at a distance of between 2 and 10 miles from the homes of drivers who were at fault in those crashes. These results gave an indication that home based trips may be more associated with crashes and later trip related model estimates which were found significant at 95% confidence level complied with this hypothesized idea. Previous aggregate level road safety studies widely addressed negative binomial distribution of crashes. Properties like non-negative integer counts, non-normal distribution, over-dispersion in the data have increased suitability of applying the negative binomial technique and has been selected to build crash prediction models in this research. Four response variables which were aggregated at TAZ-level were total number of crashes, severe (fatal and severe injury) crashes, total crashes during peak hours, and pedestrian and bicycle related crashes. For each response separate models were estimated using four different sets of predictors which are i) various trip variables, ii) total trip production and total trip attraction, iii) road characteristics, and iv) finally considering all predictors into the model. It was found that the total crash model and peak hour crash model were best estimated by the total trip productions and total trip attractions. On the basis of log-likelihoods, deviance value/degree of freedom, and Pearson Chi-square value/degree of freedom, the severe crash model was best fit by the trip related variables only and pedestrian and bicycle related crash model was best fit by the road related variables only. The significant trip related variables in the severe crash models were home-based work attractions, home-based shop attractions, light truck productions, heavy truck productions, and external-internal attractions. Only two variables- sum of roadway segment lengths with 35 mph speed limit and number of intersections per TAZ were found significant for pedestrian and bicycle related crash model developed using road characteristics only. The 1349 TAZs were grouped into three different clusters based on the quartile distribution of the trip generations and were termed as less-tripped, moderately-tripped, and highly-tripped TAZs. It was hypothesized that separate models developed for these clusters would provide a better fit as the clustering process increases the homogeneity within a cluster. The cluster models were re-run using the significant predictors attained from the joint models and were compared with the previous sets of models. However, the differences in the model fits (in terms of Alkaike's Information Criterion values) were not significant. This study points to different approaches when predicting crashes at the zonal level. This research is thought to add to the literature on macro level crash modeling research by considering various trip related data into account as previous studies in zone level safety have not explicitly considered trip data as explanatory covariates.

This paper aims to develop and validate an efficient method for delineation of public transit analysis zones (PTTAZ), particularly for origin-destination (OD) matrix prediction for transit operation planning. Existing methods have a problem in reflecting the level of spatial precision, travel characteristics, travel demand growth, access to transit stations, and most importantly, the direction of transit routes. This study proposes a new methodology to redelineate existing traffic analysis zones (TAZ) to create PTTAZ in order to allocate travel demand to transit stops. We aim to achieve an accurate prediction of the OD matrix for public transportation (PT). The matrix should reflect the passenger accessibility in the socioeconomic and socio-spatial characterization of PTTAZ and minimize intrazonal trips. The proposed methodology transforms TAZ-based to PTTAZ-based data with sequential steps through multiple statistical methods. In short, the generation of PTTAZ establishes homogeneous sub-zones representing the relationship between passenger flow, network structure, land use, population, socio-economic characteristics, and, most importantly, existing bus transit infrastructure. To validate the proposed scheme, we implement the framework for India’s Vishakhapatnam bus network and compare the results with the household survey. The results show that the PTTAZ-based OD matrix represents a realistic scenario for PT demand.

Traffic safety has been considered one of the most important issues in the transportation field. With consistent efforts of transportation engineers, Federal, State and local government officials, both fatalities and fatality rates from road traffic crashes in the United States have steadily declined from 2006 to 2011.Nevertheless, fatalities from traffic crashes slightly increased in 2012 (NHTSA, 2013). We lost 33,561 lives from road traffic crashes in the year 2012, and the road traffic crashes are still one of the leading causes of deaths, according to the Centers for Disease Control and Prevention (CDC). In recent years, efforts to incorporate traffic safety into transportation planning has been made, which is termed as transportation safety planning (TSP). The Safe, Affordable, Flexible Efficient, Transportation Equity Act - A Legacy for Users (SAFETEA-LU), which is compliant with the United States Code, compels the United States Department of Transportation to consider traffic safety in the long-term transportation planning process. Although considerable macro-level studies have been conducted to facilitate the implementation of TSP, still there are critical limitations in macroscopic safety studies are required to be investigated and remedied. First, TAZ (Traffic Analysis Zone), which is most widely used in travel demand forecasting, has crucial shortcomings for macro-level safety modeling. Moreover, macro-level safety models have accuracy problem. The low prediction power of the model may be caused by crashes that occur near the boundaries of zones, high-level aggregation, and neglecting spatial autocorrelation. In this dissertation, several methodologies are proposed to alleviate these limitations in the macro-level safety research. TSAZ (Traffic Safety Analysis Zone) is developed as a new zonal system for the macroscopic safety analysis and nested structured modeling method is suggested to improve the model performance. Also, a multivariate statistical modeling method for multiple crash types is proposed in this dissertation. Besides, a novel screening methodology for integrating two levels is suggested. The integrated screening method is suggested to overcome shortcomings of zonal-level screening, since the zonal-level screening cannot take specific sites with high risks into consideration. It is expected that the integrated screening approach can provide a comprehensive perspective by balancing two aspects: macroscopic and microscopic approaches.