Spelling suggestions: "subject:"ultrafiltration (UF)"" "subject:"ultratfiltration (UF)""
1 |
Management model to optimise the use of reverse osmosis brine to backwash ultra-filtration systems at Medupi power station / Frederik Jacobus FourieFourie, Frederik Jacobus January 2014 (has links)
According to the Department of Water Affairs (DWAF, 2004 p.15), South Africa’s water
resources are scarce and extremely limited and much of this precious resource is utilised and
consumed in our industries. Treatment and re-use of effluent generated is, in some cases,
preferred over use of alternate water resources (Du Plessis, 2008 p.3).
The volume of effluent generated in treatment processes like ultra-filtration (UF) and reverse
osmosis (RO) units is determined by the feed water quality, with high water loss through effluent
generation at poor feed water quality. Current UF and RO applications require an increased UF
production capacity due to the use of UF filtrate for periodic backwashing of the UF membrane
units. This results in loss of water and decreases overall recovery.
The need therefore exists to increase the overall recovery of product water from the raw water
stream by reducing the amount of effluent generated. This would be possible to achieve by
using RO brine to backwash the UF unit.
The study was conducted to provide a modelling tool, assisting management to optimise the
use of RO brine as backwash water on the UF system at the Medupi power station. The
secondary objective of this study was the development of a modelling tool that can be used for
other projects, new or existing, as a measure and indication of the usability of RO brine as
backwash water on UF systems.
By successfully applying this newly developed model, the viability of utilising the RO brine as
backwash water for the UF was investigated. This modification would lead to utilizing smaller UF
units than previously envisioned, which in turn leads to reducing capital cost with 11.07% and
operating expenditure with 9.98% at the Medupi power station. This also has a positive
environmental impact by reducing the amount of raw water used monthly by 10.34% (108 000
m3/month). / MIng (Development and Management Engineering), North-West University, Potchefstroom Campus, 2014
|
2 |
Recycling of Back Grinding Wastewater from Semi-Conductor Industry: a Feasibility StudyChen, Ya-hsin 28 January 2010 (has links)
Back grinding (BG) wastewater consists mainly of high-purity water and high concentrations of inorganic particles. If the BG wastewater could be treated and recycled efficiently, it should be sort of economic benefit. In this study, appropriate pre-treatment technologies are evaluated to obtain the feasible recycle system. From the chemical coagulation experiment, the addition of PAC or FeCl3, both of them can obviously reduce the turbidity and suspended solid concentrations (SS). In addition, polymer can advance the sedimentation process. Considering the cost of practical operation, the turbidity of BG waste water could be removed up to 97% by using polyaluminum chloride as the coagulant (2.2 mg/L) and polymer as the coagulant aid (0.5 mg/L) in the pH=7 condition . In sand filtration experiment, the turbidity and SS can¡¦t be effectively removed if the coagulation isn¡¦t used on BG wastewater. It demonstrates that BG wastewater contains high concentration of nano-scale particles. The rate of removable turbidity can reach 99% under applying coagulation, sedimentation, and sand filtration. In ultra-filtration experiment, both of spiral-wound (SW) and hollow-fiber (HF) can remove more than 99.9% of turbidity. For the flux of behavior, the performance of pre-treatment water is better than non-treatment water. Thus, it reveals that appropriate pre-treatment can lower the load of membrane filtration system. For the obtained recycle water, the grade of standard can achieve the grade of the cooling tower required.
However, due to its high particle-containing characteristics, the commonly used reverse-osmoses (RO) membrane filtration technology can not be directly applied for purification process because the fouling/clogging problem would cause the frequent membrane replacement. In this lab-scale feasibility study, pre-treatment technologies (e.g., sand filtration, chemical coagulation, ultra-filtration) were applied to reduce the turbidity and particle concentrations of the BG wastewater (collected from a semiconductor manufacturing plant) before RO filtration unit. The BG wastewater contained turbidity and suspended solid concentrations of 3,200 NTU and 96 mg/L, respectively. The measured pH and conductivity of the BG wastewater were in the ranges of 6.8 to 7.2 and 14 to 18 £gS/cm, respectively. Moreover, the particle sizes of the solids varied from 300 to 700 nm. Thus, applying conventional sand filtration along could not effectively remove the nano-scale particles. Results from the chemical coagulation experiment reveal that the turbidity and particles of the BG wastewater could be significantly removed (up to 95% of turbidity and particle removal) by the coagulation/sedimentation process using polyaluminum chloride as the coagulant (2.2 mg/L) and polymer as the coagulant aid (0.5 mg/L). Results also indicate that up to 99% of turbidity and particle removal could be obtained with the application of ultra-filtration unit after the coagulation/sedimentation process. Results from this study indicate that applying appropriate pre-treatment technologies (coagulation and ultra-filtration) would lower the fouling rate and extend the life of RO membrane used for BG wastewater purification.
|
3 |
Management model to optimise the use of reverse osmosis brine to backwash ultra-filtration systems at Medupi power station / Frederik Jacobus FourieFourie, Frederik Jacobus January 2014 (has links)
According to the Department of Water Affairs (DWAF, 2004 p.15), South Africa’s water
resources are scarce and extremely limited and much of this precious resource is utilised and
consumed in our industries. Treatment and re-use of effluent generated is, in some cases,
preferred over use of alternate water resources (Du Plessis, 2008 p.3).
The volume of effluent generated in treatment processes like ultra-filtration (UF) and reverse
osmosis (RO) units is determined by the feed water quality, with high water loss through effluent
generation at poor feed water quality. Current UF and RO applications require an increased UF
production capacity due to the use of UF filtrate for periodic backwashing of the UF membrane
units. This results in loss of water and decreases overall recovery.
The need therefore exists to increase the overall recovery of product water from the raw water
stream by reducing the amount of effluent generated. This would be possible to achieve by
using RO brine to backwash the UF unit.
The study was conducted to provide a modelling tool, assisting management to optimise the
use of RO brine as backwash water on the UF system at the Medupi power station. The
secondary objective of this study was the development of a modelling tool that can be used for
other projects, new or existing, as a measure and indication of the usability of RO brine as
backwash water on UF systems.
By successfully applying this newly developed model, the viability of utilising the RO brine as
backwash water for the UF was investigated. This modification would lead to utilizing smaller UF
units than previously envisioned, which in turn leads to reducing capital cost with 11.07% and
operating expenditure with 9.98% at the Medupi power station. This also has a positive
environmental impact by reducing the amount of raw water used monthly by 10.34% (108 000
m3/month). / MIng (Development and Management Engineering), North-West University, Potchefstroom Campus, 2014
|
Page generated in 0.1098 seconds