The subject of my thesis is the project of Gallery aviation technology and traditions of aviation at the airport Medlánky in Brno. The project also includes urban solution of area airport in Medlánky and linking urban areas Medlánky and Komín by newly designed roads and walking paths. The area of airport consists of the two historic hangars and newly designed buildings for the servise and maintenance of aircraft, for the laboratories and the test room of aviation technology, from the control tower and the gallery aviation technology, in which there is also bistro-cafe. The building with gallery aviation technology formed a compact space for visitors with the other buildings, but at the same time the building is separated from the private area, where the planes are moving freely. In the building with gallery, there are besides the exhibition space designed also the bistro-cafe, areas for management and operation of gallery, technical and sanitary facilities, restoration workshop of historic aircraft, conference halls, meeting and training rooms, clubhouse and accommodation. The building serves as a curtural - public building, wheelchair accessible is available throughout the object.

The subject of the diploma thesis is processing of the technical part of the project documentation for the new three-storey home for elderly with partial basement, which is located in the village Ořechov. The object is situated on a flat terrain, which is situated little bit higher than local road. That was used for an architectonic conception of the house –basement is open and accessible by local road from the north side, the rest is under ground. The detached building is partly roofed by a flat green roof and partly roofed by flat roof covered with gravel. The object is divided into individual areas. In the second and third floor is living and social area. 11 dwelling units of different sizes are designed. First floor is also accessible to the public and together with entrance hall and reception, which is situated in the middle of the object with the main entrance on the east side, there are another two separate areas. The left wing serves as a medical department, in the right wing is cofé with his own staff facilities. In the basement is a utility room and storage areas.

The aim of the thesis was to design a building named Hotel Aztec. The building will serve for accommodation and recreation. The restaurant is also part of the hotel. There is a car park near the hotel building. The hotel has four floors and basement. There are 26 suites, 2 of them are three bed rooms, 20 double or twin rooms and 4 single rooms. The south-facing orientation of the suites ensures sufficient insolation. In ground floor there is one twin room for disabled persons. In ground floor there is restaurant with kitchen connected with bar in basement. There is also wellness centre, mechanical rooms and storages. On the northeast side of the hotel there are offices and rooms for employees and training room. The loadbearing masonry is from sand-lime blocks and there are cast-in-place reinforced concrete slabs and concrete foundations. The external wall is insulated with ETICS. All roofs are warm flat, over the restaurant there is intensive green roof, The roof over the 2nd floor is walkable - roof terrace. Over the 3rd floor there is non-walkable flat roof. The building is heated by heat pumps and there is mechanical ventilation with heat recovery.

The diploma thesis processes project documentation for the construction of a hotel building with a restaurant facility, which is situated on the outskirts of the western undeveloped part of the regional town Jihlava. The building has three floors and is covered by flat roofs. The hotel meets the conditions of a four-star (****) economic standard. It is designed with 24 accommodation units with a capacity of total 52 persons (4 persons with reduced mobility on the 3rd floor) and restaurant service for 92 guests, social facilities and kitchens. The apartments and guest rooms are located on the 2nd and 3rd floor. On the ground floor there is a representative space of the hotel composed of the entrance hall with reception , space for hotel management, space for technical facilities of the building and restaurant with its own kitchen. The building meets the requirements for zero-energy buildings with a combination of a high-quality construction solution with thermal insulation of building and other technological solutions such as photovoltaic power plants or deep boreholes for stepping pump heating The overall character of the building is emphasized by its architectural design in the light of modern lining of the ventilated facade using cement-fiber boards, whose two-color articulation emphasizes both simplicity and shape function of the building. This solution is combined with large glazed areas that give the building a feeling of spaciousness and evocative cleanliness.

Nowadays, oil resources start to decrease, therefore it is necessary to think about alternative sources of energy. The result of this semester project is a basic overview of the current development of electric and hybrid cars, with potential application in normal operation and the proximity of their main characteristics, such as mileage, price and service when traveling. The energy required to operate the electric stored in batteries are recharged using the power stations, which is also devoted part of the work. The thesis focuses on the design and calculation of power consumption for a defined route of four-wheel electric wheelchair. The conclusion of the thesis deals with the future development of hybrid and electric vehicles, and with the expected trends in the field of power electronics and motors and with the propagation of hybrid vehicles to the customers.

This thesis describes the design of a low-cost Accommodation for Young people. It is an apartment building on 5 floors above ground, designed primarily as a starter housing for young people. The first floor is completely wheelchair friendly and there are 3 apartments for for wheelchair users (1x2+KK, 2x1+ KK) . In the second and third floors is a total of 20 flats (1 bedroom apartment). The fourth and fifth floor consists of 5 maisonette flats (2+KK) with access to the terrace. The house is based on the foundation walls and footings. The structural system consists of load-bearing walls POROTHERM and internal reinforced concrete columns and beams. Ceiling construction consists of of panels SPIROLL and a reinforced concrete slab. The house has two roof construction, flat monotube roof (terrace) and a sloped gable roof formed by wooden rafters. The house is situated on a large grassy area, which forms the park for rest and relaxation. On the property is a parking lot along access roads with a total of 32 parking spaces.

The diploma thesis deals with a project design documentation of a multifunctional house in Považská Bystrica. The object is designed as a detached four-storey building. Its ground plan is rectangle-shaped. The building´s first floor is split into an administrative section and housing section with shared premises. The other floors are fully designed and meant for housing consisting of housing units with shared premises. A construction system is designed as a transversal wall system with reinforced concrete continuous slabs roofed with a warm flat duo roof.

Diploma thesis describes the design and processing of project documentation of the apartment building. The apartment building is located in the central part of the city of Brno, in the district of Štýřice. The building has 5 floors. Its basementless with flat roof and it is based on the footings of plain concrete. Load-bearing, peripheral walls and partitions are designed from ceramic blocks POROTHERM. Ceiling construction is designed to be assembled of ceramic ceiling fittings MIAKO built on POT supports. Peripheral walls of all floors are insulated with external thermal insulation composite system ETICS with thermal insulation of mineral wool. In the place of the plinth is wool replaced by XPS polystyrene. In the facade there are anchored wooden lattice constructions using ProPasiv anchors. These constructions are covered by façade cladding sheets CEMBRIT METRO and they devide whole building into separate units. There is housing and communal part of the building. On the first floor there are storage areas, the main service room, utility room and two barrier-free apartments. In the second to the fifth floor there are 9 residential units, one of which is designed as duplex apartment . All floors are connected by staircase and wheelchair lift. Parking for 17 cars is designed in front of the building . Two parking spaces are wheelchair accessible.

The diploma thesis called ,,Sports center with restaurant in Holesov” is written in form of implementing project documentation and contains all requirements according to current laws. Proposed object is located on a plot 461/1 in Partyzanska street, Holesov. The object is separate building situated into north part of the plot. The designed building has two floors, no basement and is covered with flat roof. Foundations of the building are design as foundations strips with concrete slabs under column. Vertical carrier system, non-carrier constructions and separating constructions of the building contain ceramic clay block Porotherm. The carrier system is supported by reinforced concrete. Ceiling construction is made of ceiling panels Spiroll. The flat roof contains heat-insulation wedges and roof drains and overflows insurance for drainage. Main walls are covered with contact insulation system and the visual part of facade is made of facade blocks Cembrit Solid mounted to wooden grate which are attached to metal anchors. The object is divided into two main parts with shared entrance. First part is located in the ground floor and is designated for restaurant, bowling centre and back office including kitchen and bar. The other part of the building is designated for sports use. The ground floor contains two squash courts with facilities and first floor is divided into parts prepared for a gym and group lessons like spinning. This separate part has its own changing rooms and toilets with showers. The designed object is barrier-free. There is also a parking with 65 lots for vehicles. Four of them are designated for disabled visitors.

The aim of my diploma thesis is to elaborate project documentation for the execution of a new building home for elderly people. The intention is to construct a new apartment building for pensioners who are able to do activities of daily living. There can be found 24 lease flats for a maximum of 30 accommodated people. The home offers 12 hours care service and has rooms for carers, dining rooms, places for rehabilitation, outpatient care and stores for keeping accommodated people’s things. The whole area has wheelchair access and counts with the movement of people with reduced mobility. The building is designed as brick, using clay blocks which are put on concrete foundation strips. Thermal insulation is a combination of contact thermal insulation system and ventilated facade with hanging plates. The roofing is designed partly as a float double-shell roof with timber truss girder, and partly as a single-shell roof with concrete load-bearing structure. The drawing documentation has been created using computer programs AutoCAD, ArchiCAD, and the programs by doc. Dr. Ing. Zbyněk Svoboda (Teplo, Area, Stabilita, Simulace) and another simple computer programs like Excel were used for the thermal assessment.