Back to search

West Virginia University

Computational modelling of tube production process for nickel-base alloys.

Abstract

dc:description.abstract

Numerical modelling simulations of two dimensional tube extrusion and three dimensional tube pilgering reduction of nickel-base alloys were conducted using a commercial finite element code, DEFORM{dollar}\\sp{lcub}\\rm TM{rcub}{dollar}. Accuracy of the finite element modelling results was verified quantitatively by comparing solid extrusion simulation results with experimental data. An interface frictional coefficient was also examined and the best fit was selected for the simulation. As expected, heat loss of the extruded material was found to be significant due to temperature-dependent material properties of the alloy. A sequence of selected FEM tube extrusion simulations using DEFORM{dollar}\\sp{lcub}\\rm TM{rcub}{dollar} were carried out and based on an isoparametric interpolation scheme, the numerical results were used to establish a predictive formula which can be used to predict extrusion load and exit temperature with given processing variables (tube dimensions, ram speed and initial billet temperature). Accuracy of the predictions was also verified. Based on the numerical simulation results and the predictive extrusion formula, limit diagrams of a specific alloy were then established. For the three dimensional tube pilgering reduction simulation, possible defect formation was inspected and adjustment of processing variables such as feed rate or side relief was suggested to avoid defect formation. Good correlation was observed between defect formation identified by the pilgering simulation and actual processing defect. Also, effect of material property and feed rate was examined and optimum choice of processing variables (geometry, tool setup or feed rate) was proposed. The methodology presented in this research provides a practical way to tube manufacturers to avoid costly trial and error runs of initial setup for tube production as well as optimize tube production process.

Degree

thesis:*
Level thesis:degree_level
Dissertation

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Kim, Young Ryul

Identifiers

dc:identifier.*

Chain of custody

source
Harvested from
West Virginia University
Base URL
researchrepository.wvu.edu/do/oai/
Last updated
2026-11-19
Source record
OAI-PMH GetRecord
related terms
citation

Kim, Young Ryul. Computational modelling of tube production process for nickel-base alloys.. Dissertation thesis, https://doi.org/10.33915/etd.9186