Back to search

West Virginia University

Multi-Sensor Fusion for Manual Wheelchair State Estimation

Abstract

dc:description.abstract

Kathylee Pinnock Branford Manual wheelchairs are essential to mobility and independence, yet accurately characterizing wheelchair motion in real-world environments remains challenging. Inertial measurement units (IMUs) provide a practical means of estimating wheelchair kinematics, but existing trajectory-reconstruction studies have largely been limited to short, controlled trials. This report developed and evaluated a four-IMU framework comprising one sensor on each rear wheel and two sensors on the wheelchair frame. Three orientation algorithms (VQF, Mahony AHRS, and Madgwick AHRS), two accelerometer ranges (±2 g and ± 4 g), and calibrated and uncalibrated sensor data were evaluated during indoor motion-capture trials and a outdoor campus route. Indoor trajectories were most accurately reconstructed using frame-based Madgwick AHRS, with two dimensional position RMSE as low as 0.116 m for the fused estimate in the repeated-turning trial. Outdoors, the ±2 g configuration produced substantially lower trajectory and slope errors than the ±4 g configuration. For the representative calibrated ±2 g trial, ChairL-VQF produced the lowest GPS-referenced two-dimensional position RMSE (8.67 m), while ChairR-VQF produced the lowest full-trial relative loop-closure error (0.29%). Terrain and ramp slope were estimated most accurately using ChairR-Madgwick AHRS, with RMSE values of 1.21° and 2.22°, respectively. Calibration had little effect on the ±2 g results but was essential for the ±4 g configuration, for which uncalibrated data produced implausible trajectory estimates. These findings support the use of calibrated ±2 g sensors, with VQF prioritized for long-duration trajectory reconstruction and Madgwick AHRS prioritized for slope estimation.

Degree

thesis:*
Name thesis:degree_name
MS
Level thesis:degree_level
Problem/Project Report
Discipline thesis:degree_discipline
Mechanical and Aerospace Engineering

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Pinnock Branford, Kathylee
Contributors dc:contributor
  • Stephen M. Cain
  • Nicholas Szczecinski
  • Natalia Schmid

Subjects

dc:subject × 10

Identifiers

dc:identifier.*
Identifier
<p><a href="https://orcid.org/0009-0002-2991-7384">https://orcid.org/0009-0002-2991-7384</a></p>
https://researchrepository.wvu.edu/etd/13492

Chain of custody

source
Harvested from
West Virginia University
Base URL
researchrepository.wvu.edu/do/oai/
Last updated
2026-11-19
Source record
OAI-PMH GetRecord
citation

Pinnock Branford, Kathylee. Multi-Sensor Fusion for Manual Wheelchair State Estimation. Problem/Project Report thesis, https://doi.org/10.33915/etd.13492