Back to search

West Virginia University

Investigation of Particle Measurement in Different Dilution Ratios with Gasoline Direct Injection and Port Fuel Injection

Abstract

dc:description.abstract

Ambient air quality has been a concern in the United States since the mid-1900’s, forcing legislations like the Air Pollution Control Act and Clean Air Act necessary to bring focus on air pollution and quality. The Environmental Protection Agency (EPA) continues to update the requirements for more efficient vehicles and emissions sampling methods. Today the EPA has implemented regulations on modern spark ignited engines without any major focus on the type of injection technologies being used. While particle matter (PM) is a requirement to measure for a vehicle certification, more research should focus on the particle number (PN) measurements that are required for vehicle certification in the European Union. This study explores the results of an experimental setup that measures particle data within multiple simultaneous dilution ratio sampling environments. In addition to different dilution ratios, two types of injection strategies were examined and included gasoline direct injected (GDI) and port fuel injected (PFI). The emphasis of the study was the comparison of real time particle number and mass concentration to highlight injection technologies effect on particles. Furthermore, this research analyzed and compared the results in separate dilutions environments to evaluate sampling from a high dilution ratio and determine whether this was an acceptable sampling method. As engine technology, such as GDI, becomes the prominent method of injection and PFI continues to be utilized, methods of soot measurement should be improved to measure near 0.01 mg/m3. The PN measurements should be considered in addition to current PM regulation with PN concentrations measured above 1x107 cm-3 during transient test conditions.

Degree

thesis:*
Name thesis:degree_name
MS
Level thesis:degree_level
Thesis
Discipline thesis:degree_discipline
Mechanical and Aerospace Engineering

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Phillips, John Adam
Contributors dc:contributor
  • Gregory Thompson
  • Derek Johnson
  • Arvind Thiruvengadam

Subjects

dc:subject × 4

Identifiers

dc:identifier.*

Chain of custody

source
Harvested from
West Virginia University
Base URL
researchrepository.wvu.edu/do/oai/
Last updated
2026-11-19
Source record
OAI-PMH GetRecord
citation

Phillips, John Adam. Investigation of Particle Measurement in Different Dilution Ratios with Gasoline Direct Injection and Port Fuel Injection. Thesis thesis, https://doi.org/10.33915/etd.7815