We consider single-source single-sink (ss-ss) multi-hop relay networks, with slow-fading links and single-antenna half-duplex relay nodes. While two-hop cooperative relay networks have been studied in great detail in terms of the diversity-multiplexing tradeoff (DMT), few results are available for more general networks. In this paper, we identify two families of networks that are multi-hop generalizations of the two-hop network: K-Parallel-Path (KPP) networks and layered networks. KPP networks can be viewed as the union of K node-disjoint parallel relaying paths, each of length greater than one. KPP networks are then generalized to KPP(I) networks, which permit interference between paths and to KPP(D) networks, which possess a direct link from source to sink. We characterize the DMT of these families of networks completely for K > 3. Layered networks are networks comprising of layers of relays with edges existing only between adjacent layers, with more than one relay in each layer. We prove that a linear DMT between the maximum diversity dmax and the maximum multiplexing gain of 1 is achievable for single-antenna fully-connected layered networks. This is shown to be equal to the optimal DMT if the number of relaying layers is less than 4. For multiple-antenna KPP and layered networks, we provide an achievable DMT, which is significantly better than known lower bounds for half duplex networks. For arbitrary multi-terminal wireless networks with multiple source-sink pairs, the maximum achievable diversity is shown to be equal to the min-cut between the corresponding source and the sink, irrespective of whether the network has half-duplex or full-duplex relays. For arbitrary ss-ss single-antenna directed acyclic networks with full-duplex relays, we prove that a linear tradeoff between maximum diversity and maximum multiplexing gain is achievable. Along the way, we derive the optimal DMT of a generalized parallel channel and derive lower bounds for the DMT of triangular channel matrices, which are useful in DMT computation of various protocols. All protocols in this paper are explicit and use only amplify-and-forward (AF) relaying. We also construct codes with short block-lengths based on cyclic division algebras that achieve the optimal DMT for all the proposed schemes. Two key implications of the results in the paper are that the half-duplex constraint does not entail any rate loss for a large class of cooperative networks and that simple AF protocols are often sufficient to attain the optimal DMT.

This dissertation studies the diversity multiplexing tradeoff and the capacity of wireless multiple-relay network. In part 1, we study the setup of the parallel Multi-Input Multi-Output (MIMO) relay network. An amplify-and-forward relaying scheme, Incremental Cooperative Beamforming, is introduced and shown to achieve the capacity of the network in the asymptotic case of either the number of relays or the power of each relay goes to infinity. In part 2, we study the general setup of multi-antenna multi-hop multiple- relay network. We propose a new scheme, which we call random sequential (RS), based on the amplify-and-forward relaying. Furthermore, we derive diversity- multiplexing tradeoff (DMT) of the proposed RS scheme for general single-antenna multiple-relay networks. It is shown that for single-antenna two-hop multiple- access multiple-relay (K > 1) networks (without direct link between the source(s) and the destination), the proposed RS scheme achieves the optimum DMT. In part 3, we characterize the maximum achievable diversity gain of the multi- antenna multi-hop relay network and we show that the proposed RS scheme achieves the maximum diversity gain. In part 4, RS scheme is utilized to investigate DMT of the general multi-antenna multiple-relay networks. First, we study the case of a multi-antenna full-duplex single-relay two-hop network, for which we show that the RS achieves the optimum DMT. Applying this result, we derive a new achievable DMT for the case of multi-antenna half-duplex parallel relay network. Interestingly, it turns out that the DMT of the RS scheme is optimum for the case of multi-antenna two parallel non-interfering half-duplex relays. Furthermore, we show that random unitary matrix multiplication also improves the DMT of the Non-Orthogonal AF relaying scheme in the case of a multi-antenna single relay channel. Finally, we study the general case of multi-antenna full-duplex relay networks and derive a new lower-bound on its DMT using the RS scheme. Finally, in part 5, we study the multiplexing gain of the general multi-antenna multiple-relay networks. We prove that the traditional amplify-forward relaying achieves the maximum multiplexing gain of the network. Furthermore, we show that the maximum multiplexing gain of the network is equal to the minimum vertex cut-set of the underlying graph of the network, which can be computed in polynomial time in terms of the number of network nodes. Finally, the argument is extended to the multicast and multi-access scenarios.

The evolution to ultra-dense next generation networks requires a massive increase in throughput and deployment flexibility. Therefore, novel wireless backhaul solutions that can support these demands are needed. In this work we present an approach for a millimeter wave line-of-sight MIMO backhaul design, targeting transmission rates in the order of 100 Gbit/s. We provide theoretical foundations for the concept showcasing its potential, which are confirmed through channel measurements. Furthermore, we provide insights into the system design with respect to antenna array setup, baseband processing, synchronization, and channel equalization. Implementation in a 60 GHz demonstrator setup proves the feasibility of the system concept for high throughput backhauling in next generation networks.

Reconfigurable field effect transistors (RFET) have the ability to toggle polarity between n- and p- conductance at runtime [1], [2]. The here presented multiple independent gate (MIG) RFET expands the device functionality by offering additional logical inputs, valuable for e.g. efficient XOR or majority gate implementations [3], [4] or the here originally presented multiplexer circuit. Moreover,https://inspec.iet.org/ideas/#controlled-terms for the first time with a top-down RFET approach equal ON-currents are obtained for every configuration while requiring only one supply voltage (VDD).

International Telemetering Conference Proceedings / October 18-21, 2004 / Town & Country Resort, San Diego, California / Powered by single-segment switched interconnection, Ethernet can be used in time-critical data acquisition applications. Unlike synchronous time division multiple access, asynchronous packet streams result in congestions and uncertain multiplexing delays. With the delay analysis in the worst case and probabilistic guaranteeing conditions, we restrict the packet-sizes, intervals or traffic burstiness a priori to regulate delay deviations within acceptable scales. Some methods of combinatorics and stochastic theory, e.g. Cumulant Generating Function and the Large Deviation Principle, are used and verified by some simulation-based computations. The influence of time varying delay for telemetry applications is also discussed in some sense.

ITC/USA 2006 Conference Proceedings / The Forty-Second Annual International Telemetering Conference and Technical Exhibition / October 23-26, 2006 / Town and Country Resort & Convention Center, San Diego, California / As the rates and numbers of serial telemetry data streams increase, the cost of timely, efficient and robust distribution of those streams increases faster. Without alternatives to traditional pointto- point serial distribution, the complexity of the infrastructure will soon overwhelm potential benefits of the increased stream counts and rates. Utilization of multiplexing algorithms in Field- Programmable Gate Arrays (FPGA), coupled with universally available Internet Protocol (IP) switching technology, provides a low-latency, time-data correlated multi-stream distribution solution. This implementation has yielded zero error IP transport and regeneration of multiple serial streams, maintaining stream to stream skew of less than 10 nsec, with end-to-end latency contribution of less than 15 msec. Adoption of this technique as a drop-in solution can greatly reduce the costs and complexities of maintaining pace with the changing serial telemetry community.

International Telemetering Conference Proceedings / October 25-28, 1999 / Riviera Hotel and Convention Center, Las Vegas, Nevada / This paper presents the future of optical networking via photonic switches as a potential replacement for the existing electronic cross-connects. Although optical amplifiers are now mainstream and wave division multiplexing (WDM) systems are a commercial reality, the industry’s long-term vision is one of the all-optical network. This will require optical switching equipment such as all-optical or “photonic” cross-connect switches that will provide packet switching at an optical layer. Currently, as voice calls or data traffic are routed throughout Range and commercial networks, the information can travel through many fiber-optic segments which are linked together using electronic cross-connects. However, this electronic portion of the network is the bottleneck that is preventing the ideal network from achieving optimal speeds. Information is converted from light into an electronic signal, routed to the next circuit pathway, then converted back into light as it travels to the next network destination. In an all-optical network, the electronics are removed from the equation, eliminating the need to convert the signals and thereby significantly improving network performance and throughput. Removing the electronics improves network reliability and restoration speeds in the event of an outage, provides greater flexibility in network provisioning, and provides a smooth transition when migrating to future optical transmission technologies. Despite the fact that photonic switching remains uncommercialized, it now seems apparent that the core switches in both the public networks and DoD Range networks of the early 21st century will probably carry ATM cells over a photonic switching fabric.

International Telemetering Conference Proceedings / October 25-28, 1999 / Riviera Hotel and Convention Center, Las Vegas, Nevada / This paper describes the design, configuration, testing, and performance of a Fiber Optic Link used to transmit the signals from a remotely located S-band telemetry system to the main facility at the Kwajalein Missile Range (KMR). This fiber optic system demonstrates for the first time the feasibility of linking RF data from multiple antennas via a single fiber and over a nearly 100-km distance. Measured data of key link parameters such as gain, bit-error-rate, crosstalk, phase and gain stability, dynamic range, and noise figure are presented.

International Telemetering Conference Proceedings / October 22-25, 2001 / Riviera Hotel and Convention Center, Las Vegas, Nevada / This paper presents initial results of an investigation on bandwidth efficient waveforms for telemetry, tracking and commands (TT&C). Included in the investigation are waveforms that are currently being considered by the International Consultative Committee for Space Data Systems (CCSDS) and American Institute of Aeronautics and Astronautics (AIAA) for standards, advanced waveforms and others that have the potential to become future standards. The goal of this investigation is to recommend a suite of bandwidth efficient modulation schemes for further investigation. This suite of modulation scheme should be suitable for various TT&C applications with data rates ranging from a few hundreds Bit Per Second (bps) to a few hundreds Mega bps (Mbps). First, the philosophy of waveform evaluation is described. The description includes a list of waveform attributes leading to quantitative and qualitative figures of merit for bandwidth efficient waveforms. Then quantitative results for the two most important waveform attributes (bandwidth efficiency and bit error rate performance) are presented. These results will be used by a follow-on study to significantly reduce the number of candidate waveforms, so that all attributes can be more thoroughly evaluated.

International Telemetering Conference Proceedings / October 23-26, 2000 / Town & Country Hotel and Conference Center, San Diego, California / Three Quadrature Phase Shift Keying (QPSK) mapped COFDM systems demonstrating a continuum of complexity levels are simulated over an evolving three ray model of the multipath fading channel with parameters interpolated from actual channel sounding experiments. The first COFDM system uses coherent QPSK and convolutional coding with interleaving in frequency, channel equalization and soft decision decoding; the second uses convolutional coding with interleaving in frequency, Differential Phase Shift Keying (DPSK) and soft decision decoding; the third system uses a quaternary BCH code with DPSK mapping and Error and Erasure Decoding (EED). All three systems are shown to be able to provide reliable data communication during frequency selective fade events. Simulations demonstrate QPSK mapped COFDM with reasonable complexity performs well in a multipath frequency selective fading environment under parameters typically encountered in aeronautical telemetry.