This thesis reports work extending the scope of a recently developed gas sensing technique, multi-mode absorption spectroscopy (MUMAS). The ability of MUMAS to simultaneously detect multiple species from a mixture is demonstrated for the first time. The technique is subsequently extended to mid-infrared wavelengths, realising large gains in sensitivity. A solid-state, multi-mode laser has been developed to provide a high-performance comb source for use with MUMAS. This in-house constructed, diode-pumped, Er/Yb:glass laser operates on 10 longitudinal modes, separated by 18 GHz and centred close to 1565 nm. The extensive development and prototyping work leading to this final laser design is described. Multi-species detection with MUMAS is reported for the first time, thus demonstrating the ability of this technique to perform multi-gas sensing using a single laser and simple detection scheme. The previously described Er/Yb multi-mode laser was used to record MUMAS signals from a sample containing CO, C₂H₂, and N₂O. The components of the mixture were detected simultaneously by identifying multiple transitions in each of the species. Temperature- and pressure-dependent modelled spectral fits to the data were used to determine the partial pressures of each species in the mixture with an uncertainty better than +/-2%. Multi-mode radiation has been successfully generated at 3.3 μm using quasi phase matched difference frequency generation (QPM-DFG). A mid-infrared laser comb was produced by optically mixing the near-infrared, multi-mode comb produced by the previously developed Er/Yb:glass laser with the single-mode output of a Nd:YAG laser operating at 1064 nm. This multi-frequency laser source was characterised to verify performance, and subsequently used to perform proof-of-principle MUMAS measurements on the strong transitions found in this spectral region. Spectra were recorded of NH₃ and CH₄ both individually and as components of a mixture. A minimum detection level for this system was determined to be 4.3 μbar m^-1 for CH₄, a sensitivity increase of 300 over similar measurements performed in the near-IR.

Bragg reflection waveguides (BRW) or one-dimensional photonic bandgap structures have been demonstrated for phase-matching chi(2) nonlinearities in AlxGa1-xAs. The method exploits strong modal dispersion of a Bragg mode and total internal reflection modes co-propagating inside the waveguide. It is shown that phase-matching is attained among the lowest order modes of interacting harmonics, which allows maximizing the utilization of harmonics powers for nonlinear interactions. As our first demonstration, we report second-harmonic generation (SHG) of a 2-ps telecommunication pump in a 2.4 mm long slab BRW. The conversion efficiency is estimated as 2.0 %/W.cm^2 with a generated SH power of 729 nW. This efficiency has been considerably improved by introducing lateral confinement of optical modes in ridge structures. Characterizations denote that efficiency of SHG in ridge BRWs can increase by over an order of magnitude in comparison to that of the slab device. Also, we report continuous-wave SHG in BRWs. Using a telecommunication pump with a power of 98 mW, the continuous-wave SH power of 23 nW is measured in a 2.0 mm long device. Significant enhancements of chi(2) interactions is obtained in the modified design of matching-layer enhanced BRW (ML-BRW). For the first time, we report type-II SHG in ML-BRW, where the second-harmonic power of 60 µW is measured for a pump power of 3.3 mW in a 2.2 mm long sample. Also, we demonstrate the existence of type-0 SHG, where both pump and SH signal have an identical TM polarization state. It is shown that the efficiency of the type-0 process is comparable to type-I and type-II processes with the phase-matching wavelengths of all three interactions lying within a spectral window as small as 17 nm. ML-BRW is further reported for sum-frequency and difference-frequency generations. For applications requiring high pump power, a generalized ML-BRW design is proposed and demonstrated. The proposed structure offsets the destructive effects of third-order nonlinearities on chi(2) processes when high power harmonics are involved. This is carried out through incorporation of larger bandgap materials by using high aluminum content AlxGa1-xAs layers without undermining the nonlinear conversion efficiency. Theoretical investigations of BRWs as integrated sources of photon-pairs with frequency correlation properties are discussed. It is shown that the versatile dispersion properties in BRWs enables generation of telecommunication anti-correlated photon-pairs with bandwidth tunablity between 1 nm and 450 nm.

Bragg reflection waveguides (BRW) or one-dimensional photonic bandgap structures have been demonstrated for phase-matching chi(2) nonlinearities in AlxGa1-xAs. The method exploits strong modal dispersion of a Bragg mode and total internal reflection modes co-propagating inside the waveguide. It is shown that phase-matching is attained among the lowest order modes of interacting harmonics, which allows maximizing the utilization of harmonics powers for nonlinear interactions. As our first demonstration, we report second-harmonic generation (SHG) of a 2-ps telecommunication pump in a 2.4 mm long slab BRW. The conversion efficiency is estimated as 2.0 %/W.cm^2 with a generated SH power of 729 nW. This efficiency has been considerably improved by introducing lateral confinement of optical modes in ridge structures. Characterizations denote that efficiency of SHG in ridge BRWs can increase by over an order of magnitude in comparison to that of the slab device. Also, we report continuous-wave SHG in BRWs. Using a telecommunication pump with a power of 98 mW, the continuous-wave SH power of 23 nW is measured in a 2.0 mm long device. Significant enhancements of chi(2) interactions is obtained in the modified design of matching-layer enhanced BRW (ML-BRW). For the first time, we report type-II SHG in ML-BRW, where the second-harmonic power of 60 µW is measured for a pump power of 3.3 mW in a 2.2 mm long sample. Also, we demonstrate the existence of type-0 SHG, where both pump and SH signal have an identical TM polarization state. It is shown that the efficiency of the type-0 process is comparable to type-I and type-II processes with the phase-matching wavelengths of all three interactions lying within a spectral window as small as 17 nm. ML-BRW is further reported for sum-frequency and difference-frequency generations. For applications requiring high pump power, a generalized ML-BRW design is proposed and demonstrated. The proposed structure offsets the destructive effects of third-order nonlinearities on chi(2) processes when high power harmonics are involved. This is carried out through incorporation of larger bandgap materials by using high aluminum content AlxGa1-xAs layers without undermining the nonlinear conversion efficiency. Theoretical investigations of BRWs as integrated sources of photon-pairs with frequency correlation properties are discussed. It is shown that the versatile dispersion properties in BRWs enables generation of telecommunication anti-correlated photon-pairs with bandwidth tunablity between 1 nm and 450 nm.

This thesis examines second-order optical nonlinear wave mixing processes in domain-disordered quasi-phase matching waveguides and evaluates their potential use in compact, monolithically integrated wavelength conversion devices. The devices are based on a GaAs/AlGaAs superlattice-core waveguide structure with an improved design over previous generations. Quantum-well intermixing by ion-implantation is used to create the quasi-phase matching gratings in which the nonlinear susceptibility is periodically suppressed. Photoluminescence experiments showed a large band gap energy blue shift around 70 nm after intermixing. Measured two-photon absorption coefficients showed a significant polarization dependence and suppression of up to 80% after intermixing. Similar polarization dependencies and suppression were observed in three-photon absorption and nonlinear refraction. Advanced modeling of second-harmonic generation showed reductions of over 50% in efficiency due to linear losses alone. Self-phase modulation was found to be the dominant parasitic nonlinear effect on the conversion efficiency, with reductions of over 60%. Simulations of group velocity mismatch showed modest reductions in efficiency of less than 10%. Experiments on second-harmonic generation showed improvements in efficiency over previous generations due to low linear loss and improved intermixing. The improvements permitted demonstration of continuous wave second-harmonic generation for the first time in such structures with output power exceeding 1 µW. Also, Type-II phase matching was demonstrated for the first time. Saturation was observed as the power was increased, which, as predicted, was the result of self-phase modulation when using 2 ps pulses. By using 20 ps pulses instead, saturation effects were avoided. Thermo-optically induced bistability was observed in continuous wave experiments. Difference frequency generation was demonstrated with wavelengths from the optical C-band being converted to the L- and U-bands with continuous waves. Conversion for Type-I phase matching was demonstrated over 20 nm with signal and idler wavelengths being separated by over 100 nm. Type-II phase matched conversion was also observed. Using the experimental data for analysis, self-pumped conversion devices were found to require external amplification to reach practical output powers. Threshold pump powers for optical parametric oscillators were calculated to be impractically large. Proposed improvements to the device design are predicted to allow more practical operation of integrated conversion devices based on quasi-phase matching superlattice waveguides.

No description available.

Diode lasers are a convenient and economical source of near-infrared radiation, which may usefully be applied to a host of different sensitive detection methods; this thesis presents novel extensions of these methods, making use of the favourable characteristics of this type of light source. The first part of this thesis details the development of an optical feedback cavity-enhanced absorption spectroscopy (OF-CEAS) apparatus, including the development of the optical system, the sample handling, and the electronics for feedback phase control. A preliminary demonstration of the system is reported, presenting the detection of atmospheric water absorptions close to 1596 nm. Optimisation and application of the OF-CEAS spectrometer are then demonstrated, after which the spectrometer is applied to the sensitive detection of carbon dioxide absorptions suitable as a diagnostic aid in identifying Heliobacter pylori infection. A time-normalised α-min value of 5.8 × 10⁻⁹ cm⁻¹s^1/2 was measured for these spectra. Further optimisation of the system leads to an ultimate detection sensitivity of 1.42 × 10⁻⁹ cm⁻¹s^1/2, measured on absorption transitions in acetylene close to 1532 nm. In order further to characterise the performance of the OF-CEAS system, analogous experiments are presented using the OF-CEAS setup and a standard diode-laser cavity-enhanced absorption spectroscopy (CEAS) apparatus. Detection is carried out on the P(6) line of the ν₁ + ν₃ vibrational band of the mixed isotopologue of acetylene, ¹²-C¹³-CH₂. Direct comparison is made between the sensitivities of the two methods, and in light of this the suitability of each technique for detection in different environments is considered. The well-characterised and consistent frequency scale which is inherent to the OF-CEAS technique is then applied to a line shape analysis for the presented absorption spectra. Pressure-broadening coefficients are determined for selected absorptions in the ν₁ + ν₃ band of acetylene. In spite of the low resolution associated with this technique, this accurate frequency scaling allows observation of subtle line shape effects such as Dicke collisional narrowing using the data presented in Chapter 3 for the R(60) line in the 3ν₁ + ν₃ vibrational band of CO₂. These effects are quantified through use of a Galatry fit to each absorption spectrum. The statistical significance associated with the use of such a model, and the physical meaning of the results, are examined and discussed. An alternative strategy for increasing the sensitivity of a diode-laser-based gas monitoring technique lies in moving detection to the mid-infrared region, where the absorption cross-sections are generally larger. With this motivation, difference frequency generation is presented, to produce radiation close to 3.5 µm which is then applied to a series of different enhanced spectroscopy techniques. The optimal sensitivity, of 32 ppb NO2 at 45 Torr total sample pressure, was achieved using wavelength modulation spectroscopy. The different techniques are compared and possible improvements to them are put forward. Finally, proof-of-principle work is presented seeking to combine the enhanced circulating power associated with the optical-feedback-locked techniques and non-linear optical techniques to move detection to a more favourable spectral region. Light close to 429 nm is generated by second harmonic generation in a crystal of potassium niobate, with resonance-enhancement afforded by a feedback V-cavity of the sort employed in OF-CEAS. The potential of such a system for diode-laser-based generation of blue and ultraviolet light is demonstrated and discussed, along with improvements that might be implemented to increase the efficiency of the system.