Spelling suggestions: "subject:"alectric current"" "subject:"delectric current""
151 |
Realization of switched-capacitor filters employing voltage-inverter switchesLi, Mei-kuen, Margaret, 李美娟 January 1981 (has links)
abstract / Electrical and Electronic Engineering / Doctoral / Doctor of Philosophy
|
152 |
Analysis of losses in power inductor for high-frequency switching power converters鐘學仁, Chung, Hok-Yan. January 2001 (has links)
published_or_final_version / Electrical and Electronic Engineering / Master / Master of Philosophy
|
153 |
Informacinių technologijų taikymas, mokant fiziką mokykloje tema "Elektros srovė dujose" / Application of Information Technologies in Teaching Physics Theme "Electric Current in Gases" at SchoolGlasinskas, Rolandas 13 September 2004 (has links)
The purpose of this work was to investigate teaching possibilities of the theme “Electric Current in Gases” in the course of Physics for secondary schools while using Information Technologies and their influence on teaching/learning process.
|
154 |
Development of a model of the alpha/beta 765kV line for the evaluation of auto-reclosing.Van Heerden, Peter Robert. January 2009 (has links)
The intention of this dissertation is to determine, on the Eskom system, if the pre-insertion
closing resistors installed on the Alpha-Beta 765 kV line breakers are preventing overvoltages
from being caused during auto-reclosing. Other possible solutions of reclosing protection are
investigated. It has been shown on two occasions, from actual field data that overvoltages have
occurred on the lines after reclosing. High overvoltages on this network could be the cause of
the many reactor failures that have occurred.
A mathematical model of the Alpha-Beta 765kV system was produced on Matlab/Simulink to
simulate the resonance of the line during opening and then the effect on the voltage when
reclosing takes place. The effects of installing pre-insertion resistors to reduce overvoltages on
reclosing were analysed, as well as looking at controlled reclosing at the optimal voltage across
the line breakers.
It was shown from the studies, that pre-insertion resistors do limit the overvoltages to within the
surge capabilities of the line (10% overvoltage) and that the cause of the previous overvoltages
were actually due to insertion resistor operations failure. It was also shown that the method of
controlled closing at optimal voltage across the breakers is also a successful method of
preventing overvoltages. This dissertation also evaluates a design specification for a switching
relay for controlled re-closing of the line. / Thesis (M.Sc.)-University of KwaZulu-Natal, Durban, 2009.
|
155 |
Achieving high speed, high precision A/D conversion using nonlinearity correctionSculley, Terry Lee 08 1900 (has links)
No description available.
|
156 |
Development of silicon based direct conversion receiversChakraborty, Sudipto 12 1900 (has links)
No description available.
|
157 |
Simultaneous control-structure optimization of power convertersGezgin, Cahit 05 1900 (has links)
No description available.
|
158 |
Novel design and implementation of a permanent magnet linear tubular generator for ocean wave energy conversion /Prudell, Joseph H. January 1900 (has links)
Thesis (M.S.)--Oregon State University, 2008. / Printout. Includes bibliographical references (leaves 105-106). Also available on the World Wide Web.
|
159 |
Induced currents in gas pipelines due to nearby power linesMarkovic, Dejan. January 2005 (has links)
Thesis (M.Eng.)--University of Wollongong, 2005. / Typescript. Includes bibliographical references: leaf 115-120.
|
160 |
Novel magnetic composites for high frequency applications /Zhang, Xiaokai. January 2009 (has links)
Thesis (Ph.D.)--University of Delaware, 2009. / Principal faculty advisor: John Q. Xiao, Dept. of Physics and Astronomy. Includes bibliographical references.
|
Page generated in 0.0744 seconds