International Telemetering Conference Proceedings / October 22-25, 2001 / Riviera Hotel and Convention Center, Las Vegas, Nevada / This paper proposes a modification of the high alphabet method of data transmission over an RF carrier. The system maps eleven characters into three tones. The three tones are Frequency Modulated onto an RF carrier. The 165 unique characters can be utilized for data transmission. The advantages of this system are: 1. Longer duration data words which have narrow bandwidth yielding a high signal to noise ratio. 2. Digital Signal Processing can be utilized to reconstruct characters from the tri-tone encoding. 3. The system will be less susceptible to external interference than normal Frequency Shift Keying system. The majority of the three tone burst would have to masked in order to loose a data word.

International Telemetering Conference Proceedings / October 23-26, 2000 / Town & Country Hotel and Conference Center, San Diego, California / An algorithm for automatic modulation recognition of ASK, PSK and FSK was developed by Azzouz and Nandi. The algorithm has some serious problems at SNR of 10 dB and below. This paper describes a modification to the algorithm that significantly improves the performance for detection of ASK and FSK at moderate and low SNR.

ITC/USA 2009 Conference Proceedings / The Forty-Fifth Annual International Telemetering Conference and Technical Exhibition / October 26-29, 2009 / Riviera Hotel & Convention Center, Las Vegas, Nevada / Space-time Coding (STC) for Multiple-Input Multiple-Output (MIMO) wireless communication systems is an effective technique for providing robust wireless link performance in telemetry systems. This paper investigates the degradation in system performance when synchronization errors between the transmitter and receiver are present. Specifically, expressions that quantify the increase in symbol-error-rate as a function of symbol synchronization error are derived for a two-transmit and single receive antenna MISO system using binary frequency shift keying waveforms. These results are then extended to the MIMO case. The analytic results are verified with simulation results that show close agreement between the theoretical expressions and Monte Carlo simulation runs.

No description available.

No description available.

The Motorola Inc. paging protocol FLEX is discussed. The design and construction of a FLEX paging protocol decoder is discussed in detail. It proposes a decoding solution that includes a radio frequency (RF) receiver and a decoder board. The RF receiver will be briefly discussed. The decoder design is the main focus of this thesis as it transforms the RF frequency modulated (FM) data from the receiver and converts it to FLEX data words. The decoder is designed to handle bit sampling, bit clock synchronization, FLEX packet detection, and FLEX data word collection. The FLEX data words are then sent by the decoder to an external computer through a serial link for bit processing and storage. A FLEX transmitter will send randomly generated data so that a bit error rate (BER) calculation can be made at a PC. Each receiver'9s noise power and noise bandwidth will be measured so that noise spectral density may be calculated. A complete measurement set-up will be shown on how these noise measurements are made. The BER at a known power level is recorded. This enables Eb/No curves to be generated so that results of the decoding algorithm may be compared. This is performed on two different receivers. / Master of Science

This work presents a spin torque nano-oscillator (STNO) based binary frequency shift keying (BFSK) modulation schema implemented on a printed circuit board (PCB). Maximal input data rate reaches 20 Mbit/s. Depending on the STNO used, carrier frequency can range from 1 to 10 GHz. Both DC and AC currents flowing through the STNO can be tuned between 0 to 4 mA. Using one magnetic tunnel junction (MTJ) STNO, a 380 MHz frequency shift around the center frequency 9 GHz was observed, when the modulated current was toggled between 0.8 mA and 1.2 mA at a rate of 20 Mbit/s. This is the first work demonstrating that the STNOs are applicable for BFSK modulation on the wireless application level.

International Telemetering Conference Proceedings / October 26-29, 1998 / Town & Country Resort Hotel and Convention Center, San Diego, California / Presentation of Alcatel Espace last studies and developments regarding TT&C receiver Products for satellite. This document lays on 3 parts: · a technical point of view showing digital demodulation principles used (base band recovery, analytical head, PM or FM demodulation) and their related offered possibilities(digital controlling loop, lock status detection, jammer detection,....) · a technology/design description · a synthesis showing performance and results

No description available.

The purpose of this semestral project is to explain the basic issues of simple digital modulations through the creation of simple digital modulations using direct digital synthesis. It begins with a short review of digital modulation theory and the theory about direct digital synthesis. All the technical documentation is attached, including schematics and boards of functional modulator.