Currently the trend of electronic product development is to ward ¡§light and thin, multi-functional, high density and durability¡¨. When the microelectronic chips tend to be high power, high density and high speed, the rapid increase of heat in a reduced unit area of package size, will lead to failure of electronic products. The contents of thesis is to find out the dominant factors in heat transfer by changing the geometries and material properties of QFN and BGA packages. It also aims to achieve the beat the thermal performance by reducing the probability of failure. In industries it needs a lot of cost and time in experiment work due to the changes of size and materials. Herein, the softwares of ANSYS and ICEPAK are adopted to model the QFN and BGA packages with the statistical experimental design of Taguchi method L18 (21¡Ñ37) orthogonal array setting parameters and obtain the degree of effect for each factor. Eventually, we use the analysis of variance ANOVA to obtain the contribution of each factor and to identify the significant degree for various parameters by variance error integration. From the results the die attach thermal conductivity affects the contribution of thermal performance up to 81.46% for QFN package in comparison with other controlling factors of high significance and high impact effects. Die attach thermal conductivity between 0.5 W/m•k and 1.5 W/m•k the Tj declines much larger than that between 1.5 W/m•k and 8 W/m•k. Die /PKG area ratio affects the contribution of the thermal performance to 64.24% and increasing Die /PKG area ratio can reduce the Tj for BGA package. The significant effect is also higher than other factors. However, the contribution of substrate layers is 18.83% at 99% confidence level.

This work deals with the issue of emissivity and its impact on the heat dissipation.The first part describes the basics of thermal management, the issue of emissivity and its measurement. In the second, experimental part, are dedicated the emissivity values of examined specimens. These values are then used as initial conditions for the thermal simulation. In the last part are compared the measured results and the simulated results and is evaluated the impact of emissivity for the heat dissipation.

The diploma thesis deals with the simulation of heat dissipation for LED Seoul SZ5-P. The heat transfer is discussed first. Further, the issue of thermal management and its design is analyzed. The dependence of LED junction temperature on area of single and double layer printed circuit board is simulated with Ansys Icepak. Additionally, influences of the number and placement of vias on the printed circuit board and aluminum substrate printed circuit board are simulated. Last but not least, the equations describing the dependence of printed circuit board area on desired LED junction temperature are derived. Finally, the values of heat transfer coefficient including convection and radiation are determined for various heat losses and junction temperatures.

In the introduction a traction circuit is analyzed with different types of electric devices. The thesis describes power railway electric circuits, their loads and types of used contactors. Railway standards chapter summarizes requirements of standards for railway contactors. Follows literature focusing on power current switching and power switching devices design. Based on previous, a design procedure is developed for railway MV contactor in accordance with end-user and standards requirements. Thesis closes with pre-designing a railway contactor by calculating electrodynamic forces, heatflow and mechanical components.