The Late Archean Magmatic Event (LAME), ca. 2.7 Ga, was the greatest crustal addition event in Earth history. My focus is the Superior Province of Canada, where LAME occurred ca. 2.75 – 2.65 Ga. Mantle plumes impinged on the Abitibi subprovince, where ~ 16 km regional thickness of tonalite-trondhjemite-granodiorite (TTG) melt was produced. Granites (sensu stricto) were the last magmatic phase of LAME, with a Superior-wide regional thickness of ~ 1 – 3 km. Assuming a crustal source for both TTG and granites, I use 1-D thermal models to investigate the origin of TTG in the Abitibi subprovince and that of late granites in the Superior Province. Melting curves appropriate to the source of TTG and granites are used to determine the thickness of melt produced in the models. I show that the incorporation of upward melt transfer into a standard model of lower crustal melting may increase the amount of predicted melt by ~ 1/(1-f), where f denotes the fraction of melt that is on average being extracted from the source rocks. Partitioning of heat producing elements between melt and restite reduces the amount of melt produced, but the effect is secondary compared to the increase in melt production through upward melt transfer. For the Abitibi subprovince, I show that the emplacement of a single plume coupled with the emplacement of a 12-km-thick greenstone cover can generate a maximum of ~ 9-km-thickness of TTG melt. However, the emplacement of a series of plumes, each coupled with the emplacement of a 3-km-thick greenstone cover and a 10-km-thick sill results in ~ 20-km-thickness of TTG melt. My model incorporates delamination of restitic eclogite. Finally, I show that late granites in the Superior Province may have resulted from thickening of a crust that had been “pre-heated” during earlier arc activity and that prolonged granitic magmatism observed in some areas of the Superior Province may be explained by late underthrusting of fertile source rocks into deeper and hotter regions of the crust.

The Late Archean Magmatic Event (LAME), ca. 2.7 Ga, was the greatest crustal addition event in Earth history. My focus is the Superior Province of Canada, where LAME occurred ca. 2.75 – 2.65 Ga. Mantle plumes impinged on the Abitibi subprovince, where ~ 16 km regional thickness of tonalite-trondhjemite-granodiorite (TTG) melt was produced. Granites (sensu stricto) were the last magmatic phase of LAME, with a Superior-wide regional thickness of ~ 1 – 3 km. Assuming a crustal source for both TTG and granites, I use 1-D thermal models to investigate the origin of TTG in the Abitibi subprovince and that of late granites in the Superior Province. Melting curves appropriate to the source of TTG and granites are used to determine the thickness of melt produced in the models. I show that the incorporation of upward melt transfer into a standard model of lower crustal melting may increase the amount of predicted melt by ~ 1/(1-f), where f denotes the fraction of melt that is on average being extracted from the source rocks. Partitioning of heat producing elements between melt and restite reduces the amount of melt produced, but the effect is secondary compared to the increase in melt production through upward melt transfer. For the Abitibi subprovince, I show that the emplacement of a single plume coupled with the emplacement of a 12-km-thick greenstone cover can generate a maximum of ~ 9-km-thickness of TTG melt. However, the emplacement of a series of plumes, each coupled with the emplacement of a 3-km-thick greenstone cover and a 10-km-thick sill results in ~ 20-km-thickness of TTG melt. My model incorporates delamination of restitic eclogite. Finally, I show that late granites in the Superior Province may have resulted from thickening of a crust that had been “pre-heated” during earlier arc activity and that prolonged granitic magmatism observed in some areas of the Superior Province may be explained by late underthrusting of fertile source rocks into deeper and hotter regions of the crust.