The IEEE 802.16 (WiMAX) is the promising technique to overcome some disadvantages on the Security concern of the widespread IEEE 802.11 standard. For providing high speed wide area broadband wireless access, WiMAX is an emerging wireless technology for creating multi-hop Mesh network. Based on the wired backbone wireless Mesh networks serve to get over present dependencies of wireless system. Wireless operates on Physical later and MAC layer in the air interface to provide fixed and Mobile Broadband Wireless Access (BWA) in broad range of frequencies. Due to the lack of Physical infrastructure of wireless networks are inherently less secure. In order to protect data exchange between the MAC layer and PHY layer WiMAX specifies a security sub-layer at the bottom of the MAC layer. The security sub-layer provides privacy with SS and BS from service hijacking. For providing authentication, data traffic privacy services and key management a PKM protocol defined by the WiMAX MAC as a sub-layer where the PKM protocol is the main protocol work in the security sub-layer. WiMAX is only a “Paper based” newly established technology based on Wi-Fi system then it is tough to find out its security holes in all the way. Keeping all the fact in mind the objectives of the thesis are to analyze the WiMAX security architecture security keys (AK, KEK and HMAC) are used for authorization, authentication and key management and TEK is for secure data transmission, possible security vulnerabilities, threats and risks are classified according to different layer with 802.16 std Mesh network. In addition, vulnerabilities comparison between IEEE 802.11 and 802.16 std has been pointed out in details, as well as security improvements and possible solutions has been proposed to protect WiMAX attacks.

When using Voice over IP (VoIP) in Wireless Mesh Networks the overhead induced by the IEEE 802.11 PHY and MAC layer accounts for more than 80% of the channel utilization time, while the actual payload only uses 20% of the time. As a consequence, the Voice over IP capacity is very low. To increase the channel utilization efficiency and the capacity several IP packets can be aggregated in one large packet and transmitted at once. This paper presents a new hop-by-hop IP packet aggregation scheme for Wireless Mesh Networks. The size of the aggregation packets is a very important performance factor. Too small packets yield poor aggregation efficiency; too large packets are likely to get dropped when the channel quality is poor. Two novel distributed protocols for calculation of the optimum respectively maximum packet size are described. The first protocol assesses network load by counting the arrival rate of routing protocol probe messages and constantly measuring the signal-to-noise ratio of the channel. Thereby the optimum packet size of the current channel condition can be calculated. The second protocol, which is a simplified version of the first one, measures the signal-to-noise ratio and calculates the maximum packet size. The latter method is implemented in the ns-2 network simulator. Performance measurements with no aggregation, a fixed maximum packet size and an adaptive maximum packet size are conducted in two different topologies. Simulation results show that packet aggregation can more than double the number of supported VoIP calls in a Wireless Mesh Network. Adaptively determining the maximum packet size is especially useful when the nodes have different distances or the channel quality is very poor. In that case, adaptive aggregation supports twice as many VoIP calls as fixed maximum packet size aggregation.

Increasing capacity in wireless mesh networks can be achieved by using multiple channels and radios. By using different channels, two nodes can send packets at the same time without interfering with each other. To utilize diversity of available frequency, typically cards use channel-switching, which implies significant overhead in terms of delay. Assignment of which channels to use needs to be coupled with routing decisions as routing influences topology and traffic demands, which in turn impacts the channel assignment. Routing algorithms for wireless mesh networks differ from routing algorithms that are used in wired networks. In wired networks, the number of hops is usually the only metric that matters. Wireless networks, on the other hand, must consider the quality of different links, as it is possible for a path with a larger amount of hops to be better than a path with fewer hops. Typical routing protocols for wireless mesh networks such as Optimized Link State Routing (OLSR) use a single path to send packets from source to destination. This path is precomputed based on link state information received through control packets. The consideration of more information than hop-count in the routing process has shown to be beneficial as for example link quality and physical layer data rate determines the quality of the end-to-end path. In multi-channel mesh networks, also channel switching overhead and channel diversity need to be considered as a routing metric. However, a major drawback of current approaches is that a path is precomputed and used as long as the path is available and shows a good enough metric. As a result, short term variations on link quality or channel switching are not considered. In this thesis, a new routing protocol is designed that provides a set of alternative forwarding candidates for each destination. To minimize delay (from both transmission and channel switching), a forwarding mechanism is developed to select one of the available forwarding candidates for each packet. The implementation was tested on an ARM based multi-radio platform, of which the results show that in a simple evaluation scenario the average delay was reduced by 22 % when compared to single path routing.

A wireless mesh network is a mesh network implemented over a wireless network system such as wireless LANs. Wireless Mesh Networks(WMNs) are promising for numerous applications such as broadband home networking, enterprise networking, transportation systems, health and medical systems, security surveillance systems, etc. Therefore, it has received considerable attention from both industrial and academic researchers. This dissertation explores schemes for resource management and optimization in WMNs by means of network routing and network coding. In this dissertation, we propose three optimization schemes. (1) First, a triple-tier optimization scheme is proposed for load balancing objective. The first tier mechanism achieves long-term routing optimization, and the second tier mechanism, using the optimization results obtained from the first tier mechanism, performs the short-term adaptation to deal with the impact of dynamic channel conditions. A greedy sub-channel allocation algorithm is developed as the third tier optimization scheme to further reduce the congestion level in the network. We conduct thorough theoretical analysis to show the correctness of our design and give the properties of our scheme. (2) Then, a Relay-Aided Network Coding scheme called RANC is proposed to improve the performance gain of network coding by exploiting the physical layer multi-rate capability in WMNs. We conduct rigorous analysis to find the design principles and study the tradeoff in the performance gain of RANC. Based on the analytical results, we provide a practical solution by decomposing the original design problem into two sub-problems, flow partition problem and scheduling problem. (3) Lastly, a joint optimization scheme of the routing in the network layer and network coding-aware scheduling in the MAC layer is introduced. We formulate the network optimization problem and exploit the structure of the problem via dual decomposition. We find that the original problem is composed of two problems, routing problem in the network layer and scheduling problem in the MAC layer. These two sub-problems are coupled through the link capacities. We solve the routing problem by two different adaptive routing algorithms. We then provide a distributed coding-aware scheduling algorithm. According to corresponding experiment results, the proposed schemes can significantly improve network performance.

京都大学 / 新制・課程博士 / 博士(情報学) / 甲第23328号 / 情博第764号 / 新制||情||130(附属図書館) / 京都大学大学院情報学研究科通信情報システム専攻 / (主査)教授 原田 博司, 教授 守倉 正博, 教授 大木 英司 / 学位規則第4条第1項該当 / Doctor of Informatics / Kyoto University / DFAM

As the need to remain connected increases, more and more people are turning to wireless mesh networks because they reduce the need for network infrastructure. Unfortunately, TCP does not perform well in such networks. HxH, an alternate protocol, has shown great promise in simulations, but since it relies on exploiting passive feedback, real measurements are needed to determine how effective the protocol really is. This thesis uses a measurement study on a wireless mesh network to characterize the performance of the HxH protocol in real-world networks. Several aspects of the HxH protocol do in fact perform well on real networks, but the high rate of packet loss renders other aspects of the protocol ineffective.

A wireless imaging system for monitoring strawberry fields provides enough quality image data for computer vision algorithms to make meaningful yield predictions. This report contains a design for a wireless sensor network modified with mesh networking techniques to extend coverage range and a solar energy harvesting system to improve sensor node lifetime. A two hop system with six nodes is implemented in a laboratory environment validating the communication systems integrity over an 800’ range. Moving from a primary battery system to solar energy harvesting increases the module lifetime indefinitely.

No description available.

No description available.

No description available.