This study aimed to contribute to baseline knowledge of permafrost geochemistry within the uppermost 3-4 m of permafrost at 8 sites on the Peel Plateau and east of the Mackenzie Delta, NWT (67-68oN). The following variables were measured: gravimetric water content (GWC), pore water conductivity (PWC), leachate conductivity (LC), dissolved ions by ICP-AES (i.e. Ca, SO4, Mg, Fe, K, Na, Mn, Cl), organic carbon content (calculated by linear regression from organic matter content), as well as inorganic carbon content (obtained from loss on ignition analysis). PWC was positively correlated to GWC and values were generally at least 5 times less than LC values, likely underestimating total dissolved solutes using the former method. LC increased with depth to reach maximum values below the paleo thaw unconformity (>10 mS/cm). Carbon content typically remained low throughout the cores with the exception of samples associated to the shallow-rooted vegetation cover at the ground surface. Results showed that the active layer, relict active layer and the permafrost below the thaw unconformity can be divided into three statistically significant layers. PCA results indicated some spatial patterns with increasing LC values at greater depth, suggesting that layer geochemical profiles reflect varying degrees of soil chemical weathering processes since the early Holocene.

L'objectif de cette étude est d'identifier et de quantifier les déformations actuelles dans la chaine du Rif (Maroc), notamment celles associées aux failles actives (localisation, géométrie, cinématique). Pour ce faire, nous mettons en œuvre pour la première fois dans cette région, une approche morphotectonique. Les sites et failles sélectionnés et étudiés se situent dans la partie Nord (les failles conjuguées de la baie d'Al-Hoceima: Trougout, Boujibar et Rouadi), l'Est (la faille de Nékor) et le Sud (front chevauchant sud rifain entre Fes et Meknes).A partir des outils de la morphotectonique (MNTs à différentes résolutions, images satellitaires, photographies aériennes), d'analyses de terrain et grâce aux méthodes de datation du Quaternaire (U/Th, OSL, 14C et isotopes cosmogéniques produits in-situ 10Be, 3He, 36Cl), cette étude met en évidence et quantifie une déformation transtensive dans la partie Nord de la chaine. Les vitesses de glissement horizontales et verticales le long de la faille principale d'orientation méridienne de Trougout sont de ~1.6 mm/an et ~2 mm/an, respectivement. Dans la partie Sud, nous montrons que le front rifain entre Fez et Meknes est actif avec une vitesse de raccourcissement de ~1.8 mm/an. La déformation dans la région Est se localise principalement sur la faille du Nékor avec une vitesse décrochante senestre de ~1.5 mm/an. Par ailleurs, la présence de nombreuses figures d'incision et de surfaces marines soulevées au niveau du littoral Nord témoignent d'une surrection généralisée de la chaine de l'ordre de ~0.2 mm/an. L'ensemble de cette déformation semble être constante depuis la période du Messino-Pliocène. Ces résultats sont cohérents avec les données GPS qui montrent un déplacement de ~5mm/an vers le SW de l'ensemble du Rif associé à un mouvement rotatif horaire, dans le référentiel Afrique stable. D'un point de vue géodynamique, nous proposons que le Rif, la mer d'Alboran et les Bétiques appartiennent à une même microplaque limitée au Nord par les failles décrochantes des Bétiques, au Sud par le chevauchement rifain, à l'Est et au Nord-Est par les failles décrochantes de Nékor et de la TASZ (Trans Alboran Shear Zone) et à l'Ouest par les structures plissées bordières du Rif. / In order to identify and quantify the Rif (Morocco) present-day deformation, especially those related to active faults (location, geometry, kinematic), we perform a morphotectonic study. The studied area and faults are located in the Northern part (conjugate faults of Al-Hoceima Bay: Trougout, Boujibar and Rouadi), the Eastern part (Nekor fault) and the Southern part of the chain (Rif frontal thrust between Fes and Meknes cities).Morphotectonic tools (DEMs at different scales, satellite and aerial pictures), field studies and Quaternary dating methods (U/Th, OSL, 14C and in-situ cosmogenic isotopes 10Be, 3He, 36Cl) allow us to characterize transtensional deformation in the Northern Rif. Horizontal and vertical slip rates along the N-S-oriented Trougout major fault are ~1.6 mm/yr and ~2 mm/yr respectively. In the Southern part, the Rif frontal thrust shows a shortening rate of ~1.8 mm/yr into Fes and Meknes area. In the Eastern part, the deformation is focused on the Nekor left-lateral strike-slip major fault with ~1.5 mm/yr. Incision features and raised marine terraces involve an uplift of the chain about ~0.2 mm/yr. The overall deformation in the Rif seems to be continuous since the Messinian-Pliocene time.These new morphotectonic constraints are consistent with the GPS measurements showing southwestward overall motion of most of the Rif belt with respect to stable Africa, associated to clockwise rotation. Finally, we propose a geodynamic model in which the Rif, the Alboran sea and the Betics belong to a single microplate bounded by the strike-slip faults of the Betics on the North, the Rif frontal thrust on the South, the Nekor and TASZ (Trans Alboran Shear Zone) strike-slip faults on the East and North-East, and the western Rif folded structures on the West.

Ce travail de thèse a été consacré à l’étude de la stabilité dans différents milieux des matériaux constitutifs de la couche active des cellules solaires organiques. Les deux objectifs principaux étaient premièrement d’approfondir la compréhension sur certains mécanismes complexes intervenant dans la couche active, et deuxièmement d’étudier les processus de dégradation intervenant spécifiquement aux interfaces de la couche active au sein de la cellule. La première partie de ce mémoire est consacrée à l’étude de la dégradation photochimique et thermique de la couche active des cellules solaires en faisant varier le matériau polymère qui la constitue. La deuxième partie est dédiée au rôle d’un troisième composant de la couche active que peut être la présence d’additifs résiduels provenant de la mise en forme, ou d’un additif stabilisant ajouté à dessein. La troisième partie est consacrée au processus de délamination susceptible d’intervenir à l’interface couche active / couche transporteuse de trous. Enfin, une dernière partie concerne l’étude de l’alignement des niveaux énergétiques entre la molécule de C60 et divers substrats transporteurs d’électrons. L’influence de la lumière et de la température sur les propriétés d’interface couche active / couche transporteuse d’électrons est également reportée. / This word was devoted to the stability in various conditions of materials used in the active layer of organic solar cells. The main goals of this work were first to provide deeper understanding about complex mechanisms occurring in the active layer and second to investigate interfacial degradation pathways involving the active layer. A first part was dedicated to the photo and thermal stability of the polymer blend materials which constitute the active layer of the solar cells. A second section focused on the role of the third component of the active layer which can be undesired residual additives coming from the processing or the desired insertion of a stabilizer additive. A third part concerned the delamination issue which takes place at the active layer / hole transporting layer interface. Finally, a last section was devoted to the energy level alignment between the C60 molecules and various electron transporting substrates. The photo and thermal stability of the active layer / electron transporting layer interface was also studied in this section.

Active weight, active expense ratio and active alpha are measures that can be calculated with relative ease for any fund using publicly available data. However, for active weight to be truly useful to an investor the relationship between these quantities and fund performance needed to be explored in greater detail. Furthermore, the costs of South African unit trust funds had not been studied using Miller’s techniques and needed further study. Finally, active weight had not been used to study the evolution of active management over time. Using quarterly South African unit trust fund data this study delivered on the following key findings: that funds with higher active weight provide excess returns to their investors; that funds with a higher active expense ratio do not necessarily provide greater returns; and that the active alpha for South African unit trusts is negatively correlated with fund performance. / Dissertation (MBA)--University of Pretoria, 2012. / Gordon Institute of Business Science (GIBS) / unrestricted

No description available.

Cylindrical shells are common structures that are often used in industry, such as pipes, ducts, aircraft fuselages, rockets, submarine pressure hulls, electric motors and generators. In many applications it is desired to attenuate the sound radiated from the vibrating structure. There are both active and passive methods to achieve this purpose. However, at low frequencies passive methods are less effective and often an excessive amount of material is needed to achieve acceptable results. There have been a number of works regarding active control methods for this type of structure. In most cases a considerable number of error sensors and secondary sources are needed. However, in practice it is much preferred to have the fewest number of error sensors and control forces possible. Most methods presented have shown considerable dependence on the error sensor location. The goal of this dissertation is to develop an active noise control method that is able to attenuate the radiated sound effectively at low frequencies using only a small number of error sensors and secondary sources, and with minimal dependence on error sensor location. The Weighted Sum of Spatial Gradients control metric has been developed both theoretically and experimentally for simply supported cylindrical shells. The method has proven to be robust with respect to error sensor location. In order to quantify the performance of the control method, the radiated sound power has been chosen. In order to calculate the radiated sound power theoretically, the radiation modes have been developed for cylindrical shells. Experimentally, the radiated sound power without and with control has been measured using the ISO 3741 standard. The results show comparable, or in some cases better, performance in comparison with other known methods. Some agreement has been observed between model and experimental results. However, there are some discrepancies due to the fact that the actual cylinder does not appear to behave as an ideal simply supported cylindrical shell.

The Student-Centered Active Learning Environment for Undergraduate Programs (SCALE-UP) method incorporates active learning pedagogies into space designed to facilitate effective active learning. Methods predominately used to demonstrate the effectiveness of active learning in STEM fields do not generally account for differences in student characteristics; furthermore, there is a lack of data sources that measure student-centered educational practices. This study examined the impact of SCALE-UP on student achievement in introductory biology, as evidenced by course grades. A regression framework was used to account for student characteristics. Course syllabi, classroom observation data, and an instructor interview were examined to gain deeper understanding of teaching practices across classes being compared. Findings indicate the SCALE-UP classroom did not directly impact biology course grades; however, it did impact the nature of active learning techniques used during the course. Implications for practice and future research were discussed.

No description available.

Handwriting recognition systems have achieved remarkable performance over the past several years with the advent of deep neural networks. For high-quality recognition, these models require large amounts of labeled training data, which can be difficult to obtain. Various methods to reduce this effort have been proposed in the realms of active and transfer learning, but not in combination. We propose a framework for fitting new handwriting recognition models that joins active and transfer learning into a unified framework. Empirical results show the superiority of our method compared to traditional active learning, transfer learning, or standard supervised training schemes.

Diploma thesis deals with the issue of active and semi-active damping and its possible applications in the context of vehicles. The beginning of the document is focused on the actual state, major applications and patents in the field. As each of the individual ways of usage is relatively specific, the next part is aimed particularly at the damping unit of bicycle. Given the choice, real measurements and simulations were made in order to verify the applicability of such a device in practice.