Thesis (Ph. D.)--State University of New York. College of Environmental Science and Forestry, Syracuse, 1997. / eContent provider-neutral record in process. Description based on print version record. Includes bibliographical references.

Thesis (Ph. D.)--State University of New York. College of Environmental Science and Forestry, Syracuse, 1997. / eContent provider-neutral record in process. Description based on print version record. Includes bibliographical references.

Thesis (Ph. D.)--Ohio State University, 2003. / Document formatted into pages; contains xvi, 371 p.; also contains graphics. Includes bibliographical references. Abstract available online via OhioLINK's ETD Center; full text release delayed at author's request until 2005 May 5.

Thesis (Ph.D)--Chemistry and Biochemistry, Georgia Institute of Technology, 2009. / Committee Chair: Marder, Seth; Committee Member: Bredas, Jean-Luc; Committee Member: Kroger, Nils; Committee Member: Perry, Joe; Committee Member: Sandhage, Ken. Part of the SMARTech Electronic Thesis and Dissertation Collection.

The techniques of X-ray photoelectron spectroscopy (XPS), secondary ionization mass spectroscopy, chemical abstraction analysis and microelectrophoresis were used to confirm the existence of iron films on cassiterite grains recovered from the tin concentrator of Renison Limited (Australia). All analyses indicated the level of surface iron contamination to be far in excess of that characteristic of the bulk mineral lattice. No evidence was found in XPS analyses to support the contention that this iron represented lattice iron that had accumulated on the surface due to migration through the lattice, as has been suggested to be the case for certain sulphide minerals. Instead, all of the experimental data supported the hypothesis that the surface film was the result of previous adsorption of hydrous ferric oxide sols onto the cassiterite surface in the plant environment but which had undergone fundamental structural changes when the sample was dried. Specifically, the presence of the iron film did not change significantly the electrokinetic properties of cassiterite, as is known to be the case for other insoluble oxide minerals in the presence of freshly precipitated hydrolyzed metal ionic species. To reconcile these observations, it was shown independently that drying, both thermally and under vacuum, caused the charge reversal phenomena related to hydrolyzed metal ion adsorption either to diminish or disappear. In the presence of styryl phosphonic acid, the iron contaminated cassiterite exhibited a microflotation response that corresponded remarkably with the actual flotation observed in the plant from which it was taken. A critical examination of the literature revealed that this behaviour was indicative of that reported for other cassiterites in both batch and plant flotation of ores. Most notably the mineral floated strongly between pH 4.0 and 7.5. However, after acid leaching, the pH of maximum recovery moved to more acidic values around pH 2.0 and the mineral floated much less strongly in the slightly acidic to alkaline range. This latter behaviour correlated with a large body of published data for which it was known that the cassiterite used was either a high purity sample, not exposed to solutions containing dissolved metal ionic species, or had been acid cleaned prior to test work. Conversely, results from fundamental studies, where this was known not to be the case, exhibited remarkable consistency with the data obtained for the untreated cassiterite sample. The principal influence of the iron species adsorbed onto the surface of cassiterite was shown to be flotation activation in the pH range where the adsorbed species were not extensively solubilized. In the acidic range below pH 4.0, solubilization of the surface iron entities occurred which caused a severe flotation depressant effect. This solubilization was promoted in the presence of sodium fluoride, a known complexing agent for iron in acidic solutions, and the phosphonic acid. In the latter case, evidence was found for the formation of a soluble iron phosphonate complex. Independent confirmation was also sought and obtained from light scattering photometry to verify the strong affinity of phosphonic acids for hydrous ferric oxide species. Other ionic entities, such as those of magnesium and calcium were found to interact far less strongly. On the basis of this research, it has proven possible to provide a rational interpretation of all previously existing data pertaining to cassiterite flotation with phosphonic acids, for which reasonable sample description and preparation information exist. Such a reconciliation has not previously been provided, either through studies on the effects of cassiterite mineral lattice impurities or other work with dissolved metal ionic species. Furthermore, a significant link has been established between the results of fundamental analyses and industrial related observations. In particular, commercially successful practices, such as fluoride pretreatment of ore slurries prior to cassiterite flotation, now can be interpreted successfully in terms of fundamental ion solution chemistry. The evidence is that such processes involve the solubilization under acidic conditions of adsorbed iron hydroxy sols from the surface of minerals prior to cassiterite flotation. A bulk rejection of the complexed metal ionic species is then made in the water split of the desliming circuit that precedes flotation. The solution chemical evidence obtained supporting such a mechanism is considerable and no finding, in this work or elsewhere, refutes it. / Applied Science, Faculty of / Mining Engineering, Keevil Institute of / Graduate

The synthesis and characterization of some phosphonic acids as well as the modification of indium tin oxide (ITO) substrates using these phosphonic acids are presented in this thesis. Phosphonic acids have been known to bind strongly to the surface of a number of metal oxides. ITO substrates were reported to be modified with a variety of surface modifiers. Herein the ITO substrates were modified with the chosen phosphonic acids with different functional groups in order to tune the work function and compare the work function changes with the functional group properties.

Made available in DSpace on 2014-10-09T12:46:38Z (GMT). No. of bitstreams: 0 / Made available in DSpace on 2014-10-09T13:58:05Z (GMT). No. of bitstreams: 1 08351.pdf: 5297394 bytes, checksum: 64bc1483562150f9c5eeb05214a169f5 (MD5) / Dissertacao (Mestrado Profissionalizante em Lasers em Odontologia) / IPEN/D-MPLO / Instituto de Pesquisas Energeticas e Nucleares, IPEN/CNEN-SP; Faculdade de Odontologia, Universidade de Sao Paulo

Made available in DSpace on 2014-10-09T12:46:38Z (GMT). No. of bitstreams: 0 / Made available in DSpace on 2014-10-09T13:58:05Z (GMT). No. of bitstreams: 1 08351.pdf: 5297394 bytes, checksum: 64bc1483562150f9c5eeb05214a169f5 (MD5) / Dissertacao (Mestrado Profissionalizante em Lasers em Odontologia) / IPEN/D-MPLO / Instituto de Pesquisas Energeticas e Nucleares, IPEN/CNEN-SP; Faculdade de Odontologia, Universidade de Sao Paulo

This thesis focuses on understanding the chemistry involved in a variety of surface modification reactions, both on metal oxides and graphene. In this work, the rates of chemisorption of a prototypical phosphonic acid on ITO under several processing protocols are measured using XPS to determine the optimal procedure. UPS is used to track the dependence of the electronic structure of the system, specifically of the work function and position of the valence band maximum on coverage. Phosphonic acid monolayers with appropriate tail groups can also be used to initiate chemistry from surfaces, which has potential for building layers of organic-electronic devices, including organic solar cells and capacitors. The growth of non-conjugated polymers from BaTiO₃ nanoparticles using a facile ATRP technique is studied via solution-phase and solid-state techniques to determine its applicability to make matrix-free composites for hybrid dielectrics. In addition, the surface chemistry involved in Kumada Catalyst-Transfer to grow polythiophene derivatives from ITO is examined via XPS. Finally, the newly emerged alternative for replacement of ITO as transparent electrode, graphene, is n- and p-doped using redox-active, solution-processable metal-organics, which increased its conductivity and allowed the work function to be tuned over a range of 1.8 eV. The systems are characterized in a systematic study, and the results are promising for future applications of graphene.

The drug, N,N bis (ethylene)-P (1-adamantyl) phosphonic diamide inhibits focus formation of Rous Sarcoma Virus in tissue culture. Transformation of chick cells was inhibited when the drug was added to chick cells prior to infection. The drug did not inhibit the transformation of Normal Rat Kidney Cells infected with RSV, when the cells were grown at non-permissive temperatures and shifted to permissive temperatures upon addition of the drug. Nor did the drug revert cells transformed at permissive temperatures. These studies indicated that the inhibition of RSV is in the early stage of viral growth, possible penetration or uncoating.