The effects of surface plasmon for InGaN/GaN multi-quantum wells and ZnO nanoparticles optical linear and nonlinear emission efficiency had been experimentally studied. Due to the critical design for InGaN MQWs with inverted hexagonal pits based on GaN, both contribution of surface plasmon effect and image charge effect at resonant and off resonant frequencies were experimentally and theoretically investigated. With off- resonant condition, the InGaN MQWs emission significantly enhanced by metal nanoparticles. This enhancement was caused by the image charge effect, due to the accumulation of carriers to NPs region. When InGaN emission resonated with metal particles SP modes, surface Plasmon effect dominated the emission process. We also studied the surface plasmon effect for ZnO nanoparticles nonlinear optical processes, SHG and TPE. Defect level emission had more contribution at high incident intensity. Emissions are different for pumping deep into the bulk and near surface. A new assumption to increase the TPE efficiency was studied. We thought by using Au nanorods localized surface plasmon mode to couple the ZnO virtual state, the virtual state’s life time would be longer and experimentally lead the emission enhancement. We studied the TPE phenomena at high and near band gap energy. Both emission intensity and decay time results support our assumption. Theoretically, the carriers dynamic mechanism need further studies.

Large scale data centers (DC) and high performance computing (HPC) systems require more and more computing power at higher energy efficiency. They are already consuming megawatts of power, and a linear extrapolation of trends reveals that they may eventually lead to unrealistic power consumption scenarios in order to satisfy future requirements (e.g., Exascale computing). Conventional complementary metal oxide semiconductor (CMOS)-based electronic interconnects are not expected to keep up with the envisioned future board-to-board and chip-to-chip (within multi-chip-modules) interconnect requirements because of bandwidth-density and power-consumption limitations. However, low-power and high-speed optics-based interconnects are emerging as alternatives for DC and HPC communications; they offer unique opportunities for continued energy-efficiency and bandwidth-density improvements, although cost is a challenge at the shortest length scales. Plasmonics-based interconnects on the other hand, due to their extremely small size, offer another interesting solution for further scaling operational speed and energy efficiency. At the device-level, CMOS compatibility is also an important issue, since ultimately photonics or plasmonics will have to be co-integrated with electronics. In this paper, we survey the available literature and compare the aforementioned interconnect technologies, with respect to their suitability for high-speed and energy-efficient on-chip and offchip communications. This paper refers to relatively short links with potential applications in the following interconnect distance hierarchy: local group of racks, board to board, module to module, chip to chip, and on chip connections. We compare different interconnect device modules, including low-energy output devices (such as lasers, modulators, and LEDs), photodetectors, passive devices (i.e., waveguides and couplers) and electrical circuitry (such as laserdiode drivers, modulator drivers, transimpedance, and limiting amplifiers). We show that photonic technologies have the potential to meet the requirements for selected HPC and DC applications in a shorter term. We also present that plasmonic interconnect modules could offer ultra-compact active areas, leading to high integration bandwidth densities, and low device capacitances allowing for ultra-high bandwidth operation that would satisfy the application requirements further into the future.

Magister Philosophiae - MPhil / The fascinating optical properties of metallic nanostructures, dominated by collective oscillations of free electrons known as plasmons, open new opportunities for the development of devices fabrication based on noble metal nanoparticle composite materials. This thesis demonstrates a low-cost and versatile technique to produce stimuli-responsive ultrafast plasmonic nanostructures with reversible tunable optical properties. Albeit challenging, further control using thermal external stimuli to tune the local environment of gold nanoparticles embedded in V02 host matrix would be ideal for the design of responsive functional nanocomposites. We prepared Au-V02 nanocomposite thin films by the inverted cylindrical reactive magnetron sputtering (ICMS) known as hollow cathode magnetron sputtering for the first time and report the reversible tuning of surface plasmon resonance of Au nanoparticles by only adjusting the external temperature stimuli. The structural, morphological, interfacial analysis and optical properties of the optimized nanostructures have been studied. ICMS has been attracting much attention for its enclosed geometry and its ability to deposit on large area, uniform coating of smart nanocomposites at high deposition rate. Before achieving the aforementioned goals, a systematic study and optimization process of V02 host matrix has been done by studying the influence of deposition parameters on the structural, morphological and optical switching properties of V02 thin films. A reversible thermal tunability of the optical/dielectric constants of V02 thin films by spectroscopic ellipsometry has been intensively also studied in order to bring more insights about the shift of the plasmon of gold nanoparticles imbedded in V02 host matrix.

No description available.

Mémoire numérisé par la Direction des bibliothèques de l'Université de Montréal.

No description available.

No description available.

In this dissertation, I have verified that the striking purple color of the intermetallic compound AuAl₂, also known as purple gold, originates from surface plasmons (SPs). This contrasts to a previous assumption that this color is due to an interband absorption transition. The existence of SPs was demonstrated by launching them in thin AuAl2 films in the Kretschmann configuration, which enables us to measure the SP dispersion relation. I observed that the SP energy in thin films of purple gold is around 2.1 eV, comparable to previous work on the dielectric function of this material. Furthermore, SP sensing using AuAl₂ also shows the ability to measure the change in the refractive index of standard sucrose solution. AuAl₂ in nanoparticle form is also discussed in terms of plasmonic applications, where Mie scattering theory predicts that the particle bears nearly uniform absorption over the entire visible spectrum with an order magnitude higher than a lightabsorbing carbonaceous particle. The second topic of this dissertation focuses on plasmon enhanced fluorescence in gold nanoparticles (Au NPs). Here, I investigated the distance-dependent fluorescence emission of rhodamine green 110 fluorophores from Au NPs with tunable spacers. These spacers consist of polyelectrolyte multilayers (PEMs) consisting of poly(allylamine hydrochloride) and poly(styrene sulfonate) assembled at pH 8.4. The distance between Au NPs and fluorophores was varied by changing the ambient pH from 3 to 10 and back, which causes the swelling and deswelling of PEM spacer. Maximum fluorescence intensity with 4.0-fold enhancement was observed with 7-layer coated Au NPs at ambient pH 10 referenced to pH 3. The last topic of this dissertation examines a novel approach to assemble nanoparticles, in particular, dimers of gold nanospheres (NSs). 16 nm and 60 nm diameter NSs were connected using photocleavable molecules as linkers. I showed that the orientation of the dimers can be controlled with the polarization of UV illumination that cleaves the linkers, making dipolar patches. This type of assembly provides a simple method with potential applications in multiple contexts, such as biomedicine and nanorobotics. / PHD / This dissertation covers three related topics. The first is an investigation of the optical properties of the unusually colored purple gold, which is a blend of gold and aluminum with the chemical formula is AuAl₂. This compound is interesting in that the origin of this color is different from most other metals. In the case of gold, for example, the metal gold is yellow color by absorbing the blue component from white light, leaving behind yellow color reflected light. The blue light is absorbed by electrons that change their state from a lower energy to a higher one. In purple gold, the color results from a different phenomenon known as “surface plasmons.” Surface plasmons are waves consisting of many electrons that move back and forth near an interface between a metal and an electrical insulator. The energy of surface plasmons in purple gold is low and corresponds to the purple color in this compound. Recently, published theoretical work supports the possibility of surface plasmons in purple gold. In this dissertation, I experimentally verify the presence of surface plasmons in purple gold. To launch surface plasmons, light was reflected off of a purple gold film deposited on the hypotenuse of a prism with varying angles of incidence. Surface plasmons can be observed by the sudden dimming of reflected light. From this, I was able to extract the surface plasmon dispersion relation, which is the relation between the inverse of the wavelength and the energy of the surface plasmons. In addition, I computed the light absorption properties of purple v gold when it is used in a nanoparticle form. The computational result showed that small purple gold nanoparticles absorb light very well, which may be useful in photothermal cancer therapy and solar steam generation. The second dissertation topic comprises a study of fluorescent molecules. These are compounds that reemit light with a different and redder color than the color of the light that illuminates them. In this experiment, green fluorescent molecules were placed near the surface of gold nanoparticles to observe how the brightness of the light emission is affected by the distance between the molecule and the metal. The underlying mechanism is based on localized surface plasmon resonances in gold nanoparticles. Localized surface plasmon resonances are waves consisting of many electrons that oscillate inside the particle, and they only occur when light at certain frequency illuminate the particle. On the resonance, the particle also exhibits the brighter light around the particle’s surface but the dimmer light away from the particle’s surface. The light enhancement from the particle can change the light emission of the fluorescent molecules. If the fluorescent molecules were placed in the range of localized surface plasmon resonances, the light emission is increased owing to the brighter light from the particle. However, if the fluorescent molecules were placed further away from the range of localized surface plasmon resonances, the light emission is decreased owing to the dimmer light from the particle. The distance between the surface of gold nanoparticle and the fluorescent molecules was varied by wrapping the gold particles with ultra-thin films of different plastic polymers before attaching fluorescent molecules to the surface of the films. These polymer films have the property that they swell and shrink when the acidity and basicity of the solution of gold particles changes, which allows me to vary the distance between the gold particles and fluorescent molecules. The results showed that the observed light gets dimmer when the solution is more acidic. On the other hand, the brighter light is noticed when the solution is more basic, and this observation is repeatable many times. Moreover, my work differs from other published works vi in that the particles with the polymer films are more robust and stable than the other particles. This allows more design flexibility and suggests applications in biomedical or environmental research where the particles can be used to locally measure properties, such as acidity in confined spacers such as living cells. It may be possible to use this technique for tumor cells in our body or toxic pollutants in the air or water. The last dissertation topic involves assembling nanoparticles to build them into larger structures. In this experiment, I fabricated particle dimers that consisted of two gold nanospheres of different sizes. They were attached together by using small molecules that are sensitive to ultraviolet (UV) light, where these molecules allow small gold nanospheres to be attached to large gold nanospheres only in those locations on the large nanospheres that have been illuminated with a sufficient amount of UV light. To achieve this alignment, UV light with a linear polarization (a specific electric field direction) was used to select the area on the large nanospheres where the UV light was particularly intense and therefore able to break the molecules, leaving positively charged surface patches on the spheres. This results in the electrostatic attraction between the positive patches on the large gold nanospheres and the negatively charged small gold nanospheres. With this method, I was able to make dimers of nanospheres in a preferred alignment by changing the polarization of UV light. The experimental results showed a good yield of dipolar patches, which allows multifunctional nanostructures with applications in nanomedicine, optical sensing, nanoelectronics, etc.

Le travail de thèse présenté dans ce manuscrit traite des lasers à cascade quantique à plasmons de surface dans la gamme spectrale du moyen-IR et de leurs applications aux cristaux photoniques moyen-IR et THz. Pour les grandes longueurs d'onde (λ > 10µm) la lumière est confinée au sein de la région active du laser grâce à une couche de métal déposée directement à la surface de la région active. Ces guides sont appelés guide à plasmons de surface. La faible épaisseur de ces guides est un atout majeur pour la fabrication de dispositifs à cristal photonique ou DFB (Distributed Feed Back). Ce manuscrit présente une étude complète de ces guides. Il démontre de manière expérimentale et théorique qu'il est possible d'améliorer les performances de ces guides en utilisant une couche d'argent à la place de l'or habituellement utilisé. Pour approfondir cette étude, une méthode originale basée sur les guides multisections et permettant de mesurer les pertes et le gain des guides à plasmons de surface a été soigneusement étudiée à l'aide de nombreuses expériences. La deuxième partie de ce manuscrit est consacrée à l'étude théorique du réseau nid d'abeille pour la fabrication de microcavité laser pour le moyen-IR et le THz. Cette étude est réalisée grâce à des simulations bidimensionnelles à partir d'un code utilisant la méthode des ondes planes et en trois dimensions grâce à un code utilisant la méthode FDTD (Finite-Difference Time-Domain). Lors de ces études, un phénomène nouveau a été mis en évidence sur les guides métal-métal THz démontrant qu'il est possible d'implémenter un cristal photonique par la seule structuration du métal du contact supérieur.

Les propriétés singulières des ondes évanescentes ont permis le développement de la microscopie en champ<br />proche optique, mais également l'émergence de capteurs moléculaires basée sur l'excitation de plasmons de<br />surface. Ce travail de thèse est consacré au développement de nano-sondes à base de fibres optiques destinées à ces<br />deux applications.<br />Après un état de l'art des différents procédés de la littérature, ce travail aborde une nouvelle approche pour<br />créer des nano-sondes optiques. La gravure chimique, pour créer une pointe à l'extrémité d'une fibre conique, est<br />premièrement optimisée. Les étapes suivantes sont réalisées dans un dispositif plasma original, basé sur une<br />décharge en régime de cathode creuse cylindrique. Pour finaliser la fabrication des sondes, les pointes métallisées<br />sont ouvertes in situ avec une micro-étincelle obtenue via une décharge couronne en configuration pointe-plan.<br />Notre microscope est ensuite détaillé et une étude paramétrique est menée afin d'optimiser la formation des<br />images, les capacités de résolution du sont discutées. A titre d'exemple, le microscope est ensuite appliqué à la<br />science des nano-matériaux, et quelles pistes d'investigation de nano-structures sont explorées, ainsi que le<br />potentiel de spectroscopie Raman en champ proche.<br />La spectroscopie résonante des plasmons de surface est aussi abordée. Les sondes spécialement modifiées<br />sont ici destinées à la détection moléculaire en milieu aqueux. Les capteurs ainsi élaborés sont testés dans des<br />microvolumes de solution, et leur capacité d'exaltation du signal Raman est présentée.