Practical combustion devices such as gas turbines and diesel engines operate at high pressures to increase their efficiency. Pressure significantly increases the overall soot yield. Morphology of these ultra-fine particles determines their airborne lifetime and their interaction with the human respiratory system. Therefore, investigating soot morphology at high pressure is of practical relevance. In this work, a novel experimental setup has been designed and built to study the soot morphology at elevated pressures. The experimental setup consists of a pressure vessel, which can provide optical access from 10° to 165° for multi-angle light scattering, and a counterflow burner which produces laminar flames at elevated pressures. In the first part of the study, N2-diluted ethylene/air and ethane air counterflow flames are stabilized from 2 to 5 atm. Two-angle light scattering and extinction technique have been used to study the effects of pressure on soot parameters. Path averaged soot volume fraction is found to be very sensitive to pressure and increased significantly from 2 to 5 atm. Primary particle size and aggregate size also increased with pressure. Multi-angle light scattering is also performed and flames are investigated from 3 to 5 atm. Scattering to absorption ratio is calculated from multi-angle light scattering and extinction data. Scattering to absorption ratio increased with pressure whereas the number of primary particles in an aggregate decreased with increasing pressure. In the next part of the study, Thermophoretic Sampling of soot is performed, in counterflow flames from 3 to 10 atm, followed by transmission electron microscopy. Mean primary particle size increased with pressure and these trends are consistent withour light scattering measurements. Fractal properties of soot aggregates are found to be insensitive to pressure. 2D diffused light line of sight attenuation (LOSA) and Laser Induced Incandescence (LII) are used to measure local soot volume fraction from 2 to 10 atm. Local soot volume fraction increased with pressure and soot concentration profiles showed good agreements when measured by both techniques. Experimental data obtained in this work is very helpful for the modelers for validating their codes and predicting the soot formation in pressurized flames.

En raison de leur petite taille, les nanoparticules (NP) (< 100 nm) peuvent coaguler très rapidement ce qui favorise leur pénétration dans l’organisme sous forme d’agglomérats. L’objectif de cette recherche est d’étudier l’influence de l’état d’agglomération de NP de dioxyde de titane (TiO2) de trois tailles de départ différentes, 5, 10-30 ou 50 nm sur la toxicité pulmonaire chez le rat mâle (F344) exposé à des aérosols de 2, 7 ou 20 mg/m3 pendant 6 heures. Dans une chambre d’inhalation, six groupes de rats (n = 6 par groupe) ont été exposés par inhalation aiguë nez-seulement à des aérosols ayant une taille primaire de 5 nm, mais produits sous forme faiblement (< 100 nm) ou fortement (> 100 nm) agglomérée à 2, 7 et 20 mg/m3. De façon similaire, quatre autres groupes de rats ont été exposés à 20 mg/m3 à des aérosols ayant une taille primaire de 10-30 et 50 nm. Les différents aérosols ont été générés par nébulisation à partir de suspensions ou par dispersion à sec. Pour chaque concentration massique, un groupe de rats témoins (n = 6 par groupe) a été exposé à de l’air comprimé dans les mêmes conditions. Les animaux ont été sacrifiés 16 heures après la fin de l’exposition et les lavages broncho-alvéolaires ont permis de doser des marqueurs d’effets inflammatoires, cytotoxiques et de stress oxydant. Des coupes histologiques de poumons ont également été analysées. L’influence de l’état d’agglomération des NP de TiO2 n’a pu être discriminée à 2 mg/m3. Aux concentrations massiques de 7 et 20 mg/m3, nos résultats montrent qu’une réponse inflammatoire aiguë est induite suite à l'exposition aux aérosols fortement agglomérés. En plus de cette réponse, l’exposition aux aérosols faiblement agglomérés à 20 mg/m3 s’est traduite par une augmentation significative de la 8-isoprostane et de la lactate déshydrogénase. À 20 mg/m3, les effets cytotoxiques étaient plus importants suite à l’exposition aux NP de 5 nm faiblement agglomérées. Ces travaux ont montré dans l'ensemble que différents mécanismes de toxicité pulmonaire peuvent être empruntés par les NP de TiO2 en fonction de la taille de départ et de l’état d’agglomération. / Given their small size, nanoparticles (NP) (< 100 nm) can coagulate quickly, which promotes their entry into the body in the form of agglomerates. The objective of this study is to evaluate the influence of the agglomeration state of three different primary particle sizes (5, 10-30 and 50 nm) of titanium dioxide (TiO2) NP on the pulmonary toxicity of male rats (F344) exposed to aerosols at 2, 7 or 20 mg/m3 for 6 hours. In an inhalation chamber, six groups of rats (n = 6 per group) were acutely exposed by nose-only inhalation to aerosols with a 5-nm primary particle size, produced in the form of small agglomerates (< 100 nm) (SA) or large agglomerates (> 100 nm) (LA) at 2, 7 and 20 mg/m3. Similarly, four other groups of rats were exposed to aerosols at 20 mg/m3 with a primary particle size of 10-30 and 50 nm. The different aerosols were generated by nebulization of suspensions or by dry dispersion. For each mass concentration, one group of control rats (n = 6 per group) was exposed to compressed air under the same conditions. The animals were sacrificed 16 hours after the end of exposure, and analysis of the bronchoalveolar lavage fluids was used to measure markers of inflammatory, cytotoxicity and oxidative stress effects. Lung sections were also analyzed for histopathology. The influence of the agglomeration state of TiO2 NP (5 nm) could not be determined at 2 mg/m3. For mass concentrations of 7 and 20 mg/m3, our results showed that an acute inflammatory response was induced following exposure to LA aerosols. In addition to this response, exposure to SA aerosols resulted in a significant increase in 8-isoprostane and lactate dehydrogenase. At 20 mg/m3, the cytotoxic effects were greater after exposure to the 5-nm NP in the SA aerosol. This study showed that TiO2 NP use different mechanisms to induce their pulmonary toxicity as a function of their primary particle size and their agglomeration state.

En raison de leur petite taille, les nanoparticules (NP) (< 100 nm) peuvent coaguler très rapidement ce qui favorise leur pénétration dans l’organisme sous forme d’agglomérats. L’objectif de cette recherche est d’étudier l’influence de l’état d’agglomération de NP de dioxyde de titane (TiO2) de trois tailles de départ différentes, 5, 10-30 ou 50 nm sur la toxicité pulmonaire chez le rat mâle (F344) exposé à des aérosols de 2, 7 ou 20 mg/m3 pendant 6 heures. Dans une chambre d’inhalation, six groupes de rats (n = 6 par groupe) ont été exposés par inhalation aiguë nez-seulement à des aérosols ayant une taille primaire de 5 nm, mais produits sous forme faiblement (< 100 nm) ou fortement (> 100 nm) agglomérée à 2, 7 et 20 mg/m3. De façon similaire, quatre autres groupes de rats ont été exposés à 20 mg/m3 à des aérosols ayant une taille primaire de 10-30 et 50 nm. Les différents aérosols ont été générés par nébulisation à partir de suspensions ou par dispersion à sec. Pour chaque concentration massique, un groupe de rats témoins (n = 6 par groupe) a été exposé à de l’air comprimé dans les mêmes conditions. Les animaux ont été sacrifiés 16 heures après la fin de l’exposition et les lavages broncho-alvéolaires ont permis de doser des marqueurs d’effets inflammatoires, cytotoxiques et de stress oxydant. Des coupes histologiques de poumons ont également été analysées. L’influence de l’état d’agglomération des NP de TiO2 n’a pu être discriminée à 2 mg/m3. Aux concentrations massiques de 7 et 20 mg/m3, nos résultats montrent qu’une réponse inflammatoire aiguë est induite suite à l'exposition aux aérosols fortement agglomérés. En plus de cette réponse, l’exposition aux aérosols faiblement agglomérés à 20 mg/m3 s’est traduite par une augmentation significative de la 8-isoprostane et de la lactate déshydrogénase. À 20 mg/m3, les effets cytotoxiques étaient plus importants suite à l’exposition aux NP de 5 nm faiblement agglomérées. Ces travaux ont montré dans l'ensemble que différents mécanismes de toxicité pulmonaire peuvent être empruntés par les NP de TiO2 en fonction de la taille de départ et de l’état d’agglomération. / Given their small size, nanoparticles (NP) (< 100 nm) can coagulate quickly, which promotes their entry into the body in the form of agglomerates. The objective of this study is to evaluate the influence of the agglomeration state of three different primary particle sizes (5, 10-30 and 50 nm) of titanium dioxide (TiO2) NP on the pulmonary toxicity of male rats (F344) exposed to aerosols at 2, 7 or 20 mg/m3 for 6 hours. In an inhalation chamber, six groups of rats (n = 6 per group) were acutely exposed by nose-only inhalation to aerosols with a 5-nm primary particle size, produced in the form of small agglomerates (< 100 nm) (SA) or large agglomerates (> 100 nm) (LA) at 2, 7 and 20 mg/m3. Similarly, four other groups of rats were exposed to aerosols at 20 mg/m3 with a primary particle size of 10-30 and 50 nm. The different aerosols were generated by nebulization of suspensions or by dry dispersion. For each mass concentration, one group of control rats (n = 6 per group) was exposed to compressed air under the same conditions. The animals were sacrificed 16 hours after the end of exposure, and analysis of the bronchoalveolar lavage fluids was used to measure markers of inflammatory, cytotoxicity and oxidative stress effects. Lung sections were also analyzed for histopathology. The influence of the agglomeration state of TiO2 NP (5 nm) could not be determined at 2 mg/m3. For mass concentrations of 7 and 20 mg/m3, our results showed that an acute inflammatory response was induced following exposure to LA aerosols. In addition to this response, exposure to SA aerosols resulted in a significant increase in 8-isoprostane and lactate dehydrogenase. At 20 mg/m3, the cytotoxic effects were greater after exposure to the 5-nm NP in the SA aerosol. This study showed that TiO2 NP use different mechanisms to induce their pulmonary toxicity as a function of their primary particle size and their agglomeration state.

<p dir="ltr">Soot is a byproduct formed during incomplete combustion of hydrocarbon fuels. Atmospheric soot from aircraft emissions increases local air temperatures, drives cloud formation, and decreases albedo on snow and ice: three factors that promote global warming. It is also potentially harmful to humans and has been associated with negative effects on heart and lung health. Operationally, soot formation indicates an inefficiency in combustion and can cause deterioration in aircraft engines. Modeling soot formation in complex flow fields is difficult and has been largely unsuccessful. In-situ soot measurements at relevant conditions can inform the design and operation of aircraft engines with reduced soot emissions. Laser-induced incandescence (LII) is a diagnostic that allows for non-intrusive measurements of soot volume fraction and primarily particle size in combustion environments. It involves laser-heating soot particles to temperatures at which they incandescence and measuring the radiated signal. The strong absorption capabilities and high sublimation temperature of soot make this diagnostic highly selective against the detection of other species. A coupled set of differential equations can be used to model the change in temperature and mass of a soot particle over time. Methods for modeling the fundamental processes in LII were reviewed in this work and comparisons were made between several different models.</p><p dir="ltr">International Sooting Flame target conditions were used to form a laminar diffusion flame in a Yale burner with a range of soot levels. Soot volume fraction measurements were conducted and compared with other experimental values to validate the accuracy of the experimental setup and techniques used. A calibration was performed using a laser extinction measurement from a previous study. Results showed an overall increase in soot volume fraction with increasing percentages of ethylene, as well as a transition in the peak location. Time-resolved LII was conducted at 10 MHz to determine the primary particle size of soot particles. Larger primary particles were observed with increasing height for flames with higher ethylene content. Changes in the soot formation and surface growth rates are suspected factors in the observed trends in the data. </p><p dir="ltr">The overall objective of this study was to validate an experimental setup for Laser-Induced Incandescence using a laminar diffusion flame. LII measurements were successfully demonstrated using the same diagnostic setup in a liquid-fueled swirl-stabilized flame at aircraft engine-relevant conditions. This study sets the groundwork for further investigation into aircraft soot generation using LII. </p>