Ionospheric phase delays of radio signals from Global Positioning System (GPS) satellites have been used to compute ionospheric Total Electron Content (TEC). An extended Chapman profle model is used to estimate the electron density profles and TEC. The Chapman profle that can be used to predict TEC over the mid-latitudes only applies during day time. To model night time TEC variability, a polynomial function is fitted to the night time peak electron density profles derived from the online International Reference Ionosphere (IRI) 2001. The observed and predicted TEC and its variability have been used to study ionospheric in°uence on Radio Astronomy in South Africa region. Di®erential phase delays of the radio signals from Radio Astronomy sources have been simulated using TEC. Using the simulated phase delays, the azimuth and declination o®sets of the radio sources have been estimated. Results indicate that, pointing errors of the order of miliarcseconds (mas) are likely if the ionospheric phase delays are not corrected for. These delays are not uniform and vary over a broad spectrum of timescales. This implies that fast frequency (referencing) switching, closure phases and fringe ¯tting schemes for ionospheric correction in astrometry are not the best option as they do not capture the real state of the ionosphere especially if the switching time is greater than the ionospheric TEC variability. However, advantage can be taken of the GPS satellite data available at intervals of a second from the GPS receiver network in South Africa to derive parameters which could be used to correct for the ionospheric delays. Furthermore GPS data can also be used to monitor the occurrence of scintillations, (which might corrupt radio signals) especially for the proposed, Square Kilometer Array (SKA) stations closer to the equatorial belt during magnetic storms and sub-storms. A 10 minute snapshot of GPS data recorded with the Hermanus [34:420 S, 19:220 E ] dual frequency receiver on 2003-04-11 did not show the occurrence of scintillations. This time scale is however too short and cannot be representative. Longer time scales; hours, days, seasons are needed to monitor the occurrence of scintillations.

This thesis presents an update to the ionospheric propagation factor, M(3000)F2, global empirical model developed by Oyeyemi et al. (2007) (NNO). An additional aim of this research was to produce the updated model in a form that could be used within the International Reference Ionosphere (IRI) global model without adding to the complexity of the IRI. M(3000)F2 is the highest frequency at which a radio signal can be received over a distance of 3000 km after reflection in the ionosphere. The study employed the artificial neural network (ANN) technique using relevant geophysical input parameters which are known to influence the M(3000)F2 parameter. Ionosonde data from 135 ionospheric stations globally, including a number of equatorial stations, were available for this work. M(3000)F2 hourly values from 1976 to 2008, spanning all periods of low and high solar activity were used for model development and verification. A preliminary investigation was first carried out using a relatively small dataset to determine the appropriate input parameters for global M(3000)F2 parameter modelling. Inputs representing diurnal variation, seasonal variation, solar variation, modified dip latitude, longitude and latitude were found to be the optimum parameters for modelling the diurnal and seasonal variations of the M(3000)F2 parameter both on a temporal and spatial basis. The outcome of the preliminary study was applied to the overall dataset to develop a comprehensive ANN M(3000)F2 model which displays a remarkable improvement over the NNO model as well as the IRI version. The model shows 7.11% and 3.85% improvement over the NNO model as well as 13.04% and 10.05% over the IRI M(3000)F2 model, around high and low solar activity periods respectively. A comparison of the diurnal structure of the ANN and the IRI predicted values reveal that the ANN model is more effective in representing the diurnal structure of the M(3000)F2 values than the IRI M(3000)F2 model. The capability of the ANN model in reproducing the seasonal variation pattern of the M(3000)F2 values at 00h00UT, 06h00UT, 12h00UT, and l8h00UT more appropriately than the IRI version is illustrated in this work. A significant result obtained in this study is the ability of the ANN model in improving the post-sunset predicted values of the M(3000)F2 parameter which is known to be problematic to the IRI M(3000)F2 model in the low-latitude and the equatorial regions. The final M(3000)F2 model provides for an improved equatorial prediction and a simplified input space that allows for easy incorporation into the IRI model.

The use of ray tracing in the analysis of certain daytime ionograms recorded at Grahamstown is discussed in this thesis. A computer program has been modified and used to trace rays in the frequency range 1 - 30 MHz. Vertical, short distance oblique, and long distance oblique ionograms have been synthesized from the results and compared with experimental ionograms for Grahamstown, the Alice - Grahamstown transmission path (64 km), and the SANAE - Grahamstown transmission path (4470 km) respectively. Ray paths have been calculated and related in detail to the models of the ionosphere and geomagnetic field. The main features of the vertical and short distance oblique ionograms can, in general, be reproduced using spherically stratified ionosphere models with electron density profiles derived from vertical ionograms. A suitable model for the geomagnetic field is a tilted dipole equivalent to the actual field at Grahamstown. The two-hop mode is shown to be, usually, the lowest on the long distance oblique records. The ionosphere model is the principal limiting factor in reproducing such ionograms, and the most satisfactory results have been those obtained with a model in which electron density is assumed to vary linearly with latitude between the profiles at SANAE and Grahamstown. The promising results obtained by ray tracing with normal ionospheric conditions indicate that the method has further possibilities which could usefully be explored. / KMBT_363 / Adobe Acrobat 9.54 Paper Capture Plug-in

Indoor use of wireless systems poses one of the biggest design challenges. It is difficult to predict the propagation of a radio frequency wave in an indoor environment. To assist in deploying the above systems, characterization of the indoor radio propagation channel is essential. The contributions of this work are two-folds. First, in order to build a model, extensive field strength measurements are carried out inside two different buildings. Then, path loss exponents from log-distance path loss model and standard deviations from log-normal shadowing, which statistically describe the path loss models for a different transmitter receiver separations and scenarios, are determined. The purpose of this study is to characterize the indoor channel for 802.11 wireless local area networks at 2.4 GHz frequency. This thesis presents a channel model based on measurements conducted in commonly found scenarios in buildings. These scenarios include closed corridor, open corridor, classroom, and computer lab. Path loss equations are determined using log-distance path loss model and log-normal shadowing. The chi-square test statistic values for each access point are calculated to prove that the observed fading is a normal distribution at 5% significance level. Finally, the propagation models from the two buildings are compared to validate the generated equations.

The purpose of this research was to determine which of the commonly used wireless telecommunication site concealment materials has the least effect on signal potency. The tested materials were Tuff Span® fiberglass panels manufactured by Enduro Composite Systems, Lexan® XL-1 polycarbonate plastic manufactured by GE Corporation and Styrofoam™ polystyrene board manufactured by The Dow Chemical Company. Testing was conducted in a double electrically isolated copper mesh screen room at the University of North Texas Engineering Technology Building in Denton, Texas. Analysis of the data found no differences exist between the radio frequency transmissiveness of these products at broadband personal communication service frequencies. However, differences in the signal do exist with regards to the angle of incidence between the material and the transmitting antenna.

The National Aeronautics and Space Administration maintains a challenging schedule of planned and on-going space exploration missions that extend to the outer reaches of our galaxy. New missions represent a huge investment, in terms of actual costs for equipment and support infrastructure, and personnel training. The success of a mission is critical considering both the monetary investment, and for manned missions, the lives which are put at risk. Tragedies involving Challenger, Columbia, Apollo 7, and the near tragedy of Apollo 13 exemplify that space exploration is a dangerous endeavor, posing extreme environmental conditions on both equipment and personnel. NASA, the National Science Foundation' and numerous independent researchers indicate that predictive simulations have the potential to decrease risk and increase efficiency and effectiveness in space exploration activity. Simulations provide the capability to conduct planning and rehearsal of missions, allowing risk reducing designs and techniques to be discovered and tested. Real-time simulations may improve the quality of the response in a real-time crisis situation. The US Army developed Layered Terrain Format (LTF) database is a uniquely architected database approach that provides high fidelity representation of terrain and specialized terrain query functions that are optimized to support real-time simulations. This dissertation investigates the question; can the unique LTF database architecture be applied to the general problem of celestial body representation? And if so, what benefits might it bring for mission planners and personnel executing the mission? Due to data limitations, this research investigates these questions through a lunar analog setting iv involving S band and Earth-bound communication signals as might be needed to conduct manned and/or robotic mission on the moon. The target terrain data set includes portions of the Black Point Lava Flow in Arizona which will be used for NASA's 2010 Desert RATS analog studies. Applied Research Associates Inc, the developer of the LTF product, generated Black Point databases and made limited modifications to the LTF Viewer tool, RAVEN, which is used for visualization of the database. Through the results attained during this research it is concluded that LTF product does provide a useful simulation capability which could be used by mission personnel both in pre-mission planning and during mission execution. Additionally, LTF is shown to have application an information system, allowing geospecific data of interest to the mission to be implemented within its layers. The Florida Space Research & Education Grant Program sponsored by FSGC, Space Florida and UCF provided a grant of $31,500 to perform this research.

The purpose of this study was to determine if light detection and ranging (LiDAR) imagery could provide a significantly more accurate data set for modeling near line-of-sight (LOS) propagation at higher frequencies, specifically 27.810 GHz. than a USGS digital elevation model (DEM). In addition, the study tested for significant differences in LiDAR elevation data created at various resolutions ranging from 1 to 100 meters. Finally, this study examined the effects of various classification thresholds for transforming continuous signal strength measurements into LOS or non-LOS (NLOS) classifications used in determining prediction accuracy. The capability to transmit information via higher frequency wireless equipment requires a near LOS path between the transmitter and the antenna receiving the signal. USGS DEMs, commonly used in GIS programs to predict communication viewsheds (commsheds), represent the bare earth topography and do not reflect surface features such as vegetation and buildings. In actuality these surface features can significantly influence near LOS paths and therefore a data set that contains these features can greatly improve the ability to predict commshed areas. LiDAR is a form of active imagery that records both the bare-earth as well as these surface features, at a high resolution, making it well suited for wireless modeling applications. Results indicate that signal strength threshold classification has a direct influence on the accuracy of predicted commsheds across all resolutions. Secondly, LiDAR resolutions lower than 40m as well as bare-earth DEMs were unsuccessful in predicting an accurate commshed while LiDAR resolutions coarser than 15m provided significant predictions of equal accuracy. These results indicate that high resolution LiDAR is needed to accurately model commsheds but signal strength threshold classification determines which of these higher resolutions are significant. / Master of Science

The design of cellular wireless communication systems is influenced by the propagation characteristics of the channel and their effect on transmitted signals. The multipath propagation characteristics of a channel, except under simple transmission conditions, limits the design of emerging cellular systems. Once the propagation conditions are understood, systems can be designed more efficiently in terms of site layout and frequency planning, to reduce deployment costs and improve performance. A software tool for site specific radio propagation prediction is being developed at the Mobile and Portable Radio Group, Virginia Tech. The objective of this research is to develop re-usable program modules that can be utilized to implement several functional features of the software. This thesis describes the raster and vector programming libraries that have been developed during this research. These libraries are utilized in the database module, user interface and graphics module and propagation prediction module of the software. Significant among the capabilities that these libraries provide are the ability to store and retrieve raster and vector data from the database, import measured and predicted data available in standard data formats into the database, obtain user inputs through an interactive mechanism, display images of site specific information at various resolutions, and enable the user to view and analyze measured and predicted data. This thesis also presents the data format, that has been defined during this research, to acquire and import contour and elevation information of buildings. The SISP General Data Format (GDF), that has been developed, to facilitate import of measured and predicted data has also been described. The Hierarchical Data Format (HDF), developed by the National Center for Supercomputing Applications (NCSA), has been adopted to store measured and predicted data in the database. The programming techniques used to retrieve and display data stored in this format are also outlined in this thesis. SISP has been developed on Sun Sparc workstations. Details of the function libraries that have been developed, programming methodologies employed, and data formats that have been defined for site specific and measured and predicted RF data are included in this thesis. / Master of Science

This thesis investigates statistical correlation as a means to enhance the use of ground-based radar in analyzing satellite-path millimeter wave propagation through rain and ice crystals. The technique presented involves correlating dB values of the satellite signal attenuation and polarization isolation with dBZ values of radar backscatter from each of 128 range gates. In it, Pearson product moment correlation coefficients are calculated for attenuation and backscatter and for isolation and backscatter. When these coefficients are plotted versus radar range, one of four certain characteristic patterns usually appears. Ice-crystal depolarization produces a pattern of near zero attenuation coefficients and varying isolation coefficients. Rain produces a correlation pattern in which the attenuation coefficient pattern is nearly mirror image of the isolation coefficient pattern. A special case of the rain event occurs when the cross-polarized satellite signal is essentially constant. The correlation patterns for this case are exact mirror images. Rain attenuation and depolarization accompanied by additional depolarization from another source, produce a correlation pattern that is not symmetrical. This is due to the additional depolarization. Discussion of these expected patterns and examples of each are presented. / Master of Science

Yes / The Rician K-factor of the vehicle-to-vehicle (V2V) wireless propagation channel is estimated using a moment-based method on the envelope of measured pulse data. The measurements were carried out under vehicle-to-vehicle wireless communication channel condition with car rooftop antenna heights at one end of the link and very low antenna height at the other end. Data captured from typical urban, suburban and rural areas are analyzed and the K-factor probability density function is generated for each scenario to give an insight into the V2V channel behavior. For all three areas, the majority of K values are found to be within the range of -10 to +10 dB. The K-factor distributions are close to normal with mean values of 1.8, 2.6 and 3 dB respectively for urban, suburban and rural area.