Spelling suggestions: "subject:"rayleigh fading channel"" "subject:"kayleigh fading channel""
1 |
Signal Detection for Overloaded ReceiversKrause, Michael January 2009 (has links)
In this work wireless communication systems with multiple co-channel signals present at the receiver are considered. One of the major challenges in the development of such systems is the computational complexity required for the detection of the transmitted signals. This thesis addresses this problem and develops reduced complexity algorithms for the detection of multiple co-channel signals in receivers with multiple antennas. The signals are transmitted from either a single user employing multiple transmit antennas, from multiple users or in the most general case by a mixture of the two. The receiver is assumed to be overloaded in that the number of transmitted signals exceeds the number of receive antennas. Joint Maximum Likelihood (JML) is the optimum detection algorithm which has exponential complexity in the number of signals. As a result, detection of the signals of interest at the receiver is challenging and infeasible in most practical systems.
The thesis presents a framework for the detection of multiple co-channel signals in overloaded receivers. It proposes receiver structures and two list-based signal detection algorithms that allow for complexity reduction compared to the optimum detector while being able to maintain near optimum performance. Complexity savings are achieved by first employing a linear preprocessor at the receiver to reduce the effect of Co-Channel Interference (CCI) and second, by using a detection algorithm that searches only over a subspace of the transmitted symbols. Both algorithms use iterative processing to extract ordered lists of the most likely transmit symbols. Soft information can be obtained from the detector output list and can then be used by error control decoders.
The first algorithm named Parallel Detection with Interference Estimation (PD-IE) considers the Additive White Gaussian Noise (AWGN) channel. It relies on a spatially reduced search over subsets of the transmitted symbols in combination with CCI estimation. Computational complexity under overload is lower than that of JML. Performance results show that PD-IE achieves near optimum performance in receivers with Uniform Circular Array (UCA) and Uniform Linear Array (ULA) antenna geometries.
The second algorithm is referred to as List Group Search (LGS) detection. It is applied to overloaded receivers that operate in frequency-flat multipath fading channels. The List Group Search (LGS) detection algorithm forms multiple groups of the transmitted symbols over which an exhaustive search is performed. Simulation results show that LGS detection provides good complexity-performance tradeoffs under overload.
A union bound for group-wise and list-based group-wise symbol detectors is also derived. It provides an approximation to the error performance of such detectors without the need for simulation. Moreover, the bound can be used to determine some detection parameters and tradeoffs. Results show that the bound is tight in the high Signal to Interference and Noise Ratio (SINR) region.
|
2 |
Impact of Channel Estimation Errors on Space Time Trellis CodesMenon, Rekha 22 January 2004 (has links)
Space Time Trellis Coding (STTC) is a unique technique that combines the use of multiple transmit antennas with channel coding. This scheme provides capacity benefits in fading channels, and helps in improving the data rate and reliability of wireless communication. STTC schemes have been primarily designed assuming perfect channel estimates to be available at the receiver. However, in practical wireless systems, this is never the case. The noisy wireless channel precludes an exact characterization of channel coefficients. Even near-perfect channel estimates can necessitate huge overhead in terms of processing or spectral efficiency. This practical concern motivates the study of the impact of channel estimation errors on the design and performance of STTC.
The design criteria for STTC are validated in the absence of perfect channel estimates at the receiver. Analytical results are presented that model the performance of STTC systems in the presence of channel estimation errors. Training based channel estimation schemes are the most popular choice for STTC systems. The amount of training however, increases with the number of transmit antennas used, the number of multi-path components in the channel and a decrease in the channel coherence time. This dependence is shown to decrease the performance gain obtained when increasing the number of transmit antennas in STTC systems, especially in channels with a large Doppler spread (low channel coherence time). In frequency selective channels, the training overhead associated with increasing the number of antennas can be so large that no benefit is shown to be obtained by using STTC.
The amount of performance degradation due to channel estimation errors is shown to be influenced by system parameters such as the specific STTC code employed and the number of transmit and receive antennas in the system in addition to the magnitude of the estimation error. Hence inappropriate choice of system parameters is shown to significantly alter the performance pattern of STTC.
The viability of STTC in practical wireless systems is thus addressed and it is shown that that channel estimation could offset benefits derived from this scheme. / Master of Science
|
3 |
Modelering av Wideband : Code Division Multiple Access / Behaviour modelling of Wideband : Code Division Multiple AccessHuynh, Jack, Gylin, Mattias January 2005 (has links)
<p>Today wireless transmission of data is becoming more and more popular and the need for faster transmission rates is increasing. Since the bandwidth is limited it is important to try to use it to the fullest. CDMA is a technology that allows multiple accesses on the same frequency and time thus making it very bandwidth efficient. The CDMA technology was first introduced in the second generation’s cellular systems but has since then been improved and is reused in today’s 3G systems as Wideband CDMA. ISY is interested in getting a behavioural model of a W-CDMA system since they had developed a DSP processor called BBP1 and were thinking about adding W-CDMA support for it. Even though our system is not implemented on the BBP1 it should provide a good base for future implementations. This thesis project will describe the construction of a behavioural model of a W-CDMA system following the standard specified by 3GPP. The system simulates W-CDMA transmission and reception and has an optional channel used to simulate real world interference. The receiver uses a rake combiner to improve the performance of the system.</p>
|
4 |
Modelering av Wideband : Code Division Multiple Access / Behaviour modelling of Wideband : Code Division Multiple AccessHuynh, Jack, Gylin, Mattias January 2005 (has links)
Today wireless transmission of data is becoming more and more popular and the need for faster transmission rates is increasing. Since the bandwidth is limited it is important to try to use it to the fullest. CDMA is a technology that allows multiple accesses on the same frequency and time thus making it very bandwidth efficient. The CDMA technology was first introduced in the second generation’s cellular systems but has since then been improved and is reused in today’s 3G systems as Wideband CDMA. ISY is interested in getting a behavioural model of a W-CDMA system since they had developed a DSP processor called BBP1 and were thinking about adding W-CDMA support for it. Even though our system is not implemented on the BBP1 it should provide a good base for future implementations. This thesis project will describe the construction of a behavioural model of a W-CDMA system following the standard specified by 3GPP. The system simulates W-CDMA transmission and reception and has an optional channel used to simulate real world interference. The receiver uses a rake combiner to improve the performance of the system.
|
5 |
Investigation, design and implementation of MIMO antennas for mobile phones : simulation and measurement of MIMO antennas for mobile handsets and investigations of channel capacity of the radiating elements using spatial and polarisation diversity strategiesʿUs̲mān, Muḥammad January 2009 (has links)
The objectives of this work were to investigate, design and implement Multiple-Input Multiple-Output (MIMO) antenna arrays for mobile phones. Several MIMO antennas were developed and tested over various wireless-communication frequency bands. The radiation performance and channel capacity of these antennas were computed and measured: the results are discussed in the context of the frequency bands of interest. A comprehensive study of MIMO antenna configurations such as 2 × 1, 3 × 1, 2 × 2 and 3 × 3, using polarisation diversity as proposed for future mobile handsets, is presented. The channel capacity is investigated and discussed, as applying to Rayleigh fading channels with different power spectrum distributions with respect to azimuth and zenith angles. The channel capacity of 2 × 2 and 3 × 3 MIMO systems using spatial polarisation diversity is presented for different antenna designs. The presented results show that the maximum channel capacity for an antenna contained within a small volume can be reached with careful selection of the orthogonal spatial fields. The results are also compared against planar array MIMO antenna systems, in which the antenna size considered was much larger. A 50% antenna size reduction method is explored by applying magnetic wall concept on the symmetry reference of the antenna structure. Using this method, a triple dual-band inverted-F antenna system is presented and considered for MIMO application. Means of achieving minimum coupling between the three antennas are investigated over the 2.45 GHz and 5.2 GHz bands. A new 2 2 MIMO dual-band balanced antenna handset, intended to minimise the coupling with the handset and human body was proposed, developed and tested. The antenna coupling with the handset and human hand is reported in terms the radiation performance and the available channel capacity. In addition, a dual-polarisation dipole antenna is proposed, intended for use as one of three collocated orthogonal antennas in a polarisation-diversity MIMO communication system. The antenna actually consists of two overlaid electric and magnetic dipoles, such that their radiation patterns are nominally identical but they are cross-polarised and hence only interact minimally.
|
6 |
MIMO and Relay Systems Based on Multi-Amplitude Minimum Shift KeyingBasharati, Sarhad January 2013 (has links)
This thesis describes the use of a multi-amplitude minimum shift keying (MAMSK) signal in various types of wireless communication system. A MAMSK signal is a bandwidth efficient modulation scheme obtained by superimposing ℳ minimum shift keying (MSK) signals with unequal amplitudes. The overall phase of a MAMSK signal is controlled by the phase of the largest component MSK signal which allows the use of a low-complexity differential detector. A closed form expression for the average bit error rate (BER) for coherent detection of an MAMSK in AWGN is derived and is shown to achieve the same BER as that of square constellation quadrature amplitude modulation (QAM) with the same average transmit power.
We describe the design and implementation of a STBC-based MIMO radio system in conjunction with MAMSK modulation. The proposed system provides high capacity data transmission by carrying information not only in the phases but also in the amplitude. Despite using a simple MAMSK differential receiver the system achieves performance within 1 dB of coherent detection. The existing MSK modems in conjunction with STBC could easily be modified to construct the proposed system.
The MAMSK modulation scheme is extended to a multiuser relaying network where two nodes cooperate in a half-duplex environment to achieve diversity gain. The cooperative scheme is based on superposition modulation using a decode-and-forward (DF) strategy. In the proposed scheme, each node simultaneously transmits its own and the relayed signals by superimposing one on the other. A MAMSK signal is an excellent choice for this type of cooperative communication due its being obtained by a superposition technique. The proposed system exploits the overall phase of a MAMSK signal which allows differential detection and as a result it provides the lowest decoding complexity and memory requirements among the existing superposition based cooperation schemes. The performance of the system is evaluated by simulation, where it is shown that the MAMSK cooperative system outperforms a conventional DF scheme in terms of both power and bandwidth efficiency.
|
7 |
Performance of Multi-Channel Medium Access Control Protocol incorporating Opportunistic Cooperative Diversity over Rayleigh Fading ChannelAhmed, Sabbir January 2006 (has links)
This thesis paper proposes a Medium Access Control (MAC) protocol for wireless networks, termed as CD-MMAC that utilizes multiple channels and incorporates opportunistic cooperative diversity dynamically to improve its performance. The IEEE 802.11b standard protocol allows the use of multiple channels available at the physical layer but its MAC protocol is designed only for a single channel. The proposed protocol utilizes multiple channels by using single interface and incorporates opportunistic cooperative diversity by using cross-layer MAC. The new protocol leverages the multi-rate capability of IEEE 802.11b and allows wireless nodes far away from destination node to transmit at a higher rate by using intermediate nodes as a relays. The protocol improves network throughput and packet delivery ratio significantly and reduces packet delay. The performance improvement is further evaluated by simulation and analysis. / sabbir@linuxmail.org
|
8 |
Simulace MIMO syst©m / Simulation of the MIMO systemsKanÄo, Vt January 2010 (has links)
MIMO systems are mainly used in application for wireless communication. Their principle is to use a large number of antennas for transmition and the reception of a signal. The core of these systems is to use space-time coding and either block or trellis space-time code. In the future, it is assumed enormous enlargement MIMO systems in many applications
|
9 |
Investigation, Design and Implementation of MIMO Antennas for Mobile Phones. Simulation and Measurement of MIMO Antennas for Mobile Handsets and Investigations of Channel Capacity of the Radiating Elements Using Spatial and Polarisation Diversity Strategies.Usman, Muhammad January 2009 (has links)
The objectives of this work were to investigate, design and implement Multiple-Input Multiple-Output (MIMO) antenna arrays for mobile phones. Several MIMO antennas were developed and tested over various wireless-communication frequency bands. The radiation performance and channel capacity of these antennas were computed and measured: the results are discussed in the context of the frequency bands of interest.
A comprehensive study of MIMO antenna configurations such as 2 × 1, 3 × 1, 2 × 2 and 3 × 3, using polarisation diversity as proposed for future mobile handsets, is presented. The channel capacity is investigated and discussed, as applying to Rayleigh fading channels with different power spectrum distributions with respect to azimuth and zenith angles. The channel capacity of 2 × 2 and 3 × 3 MIMO systems using spatial polarisation diversity is presented for different antenna designs. The presented results show that the maximum channel capacity for an antenna contained within a small volume can be reached with careful selection of the orthogonal spatial fields. The results are also compared against planar array MIMO antenna systems, in which the antenna size considered was much larger.
A 50% antenna size reduction method is explored by applying magnetic wall concept on the symmetry reference of the antenna structure. Using this method, a triple dual-band inverted-F antenna system is presented and considered for MIMO application. Means of achieving minimum coupling between the three antennas are investigated over the 2.45 GHz and 5.2 GHz bands.
A new 2 2 MIMO dual-band balanced antenna handset, intended to minimise the coupling with the handset and human body was proposed, developed and tested. The antenna coupling with the handset and human hand is reported in terms the radiation performance and the available channel capacity.
In addition, a dual-polarisation dipole antenna is proposed, intended for use as one of three collocated orthogonal antennas in a polarisation-diversity MIMO communication system. The antenna actually consists of two overlaid electric and magnetic dipoles, such that their radiation patterns are nominally identical but they are cross-polarised and hence only interact minimally.
|
Page generated in 0.0626 seconds