Spelling suggestions: "subject:"bilica hand"" "subject:"bilica land""
1 |
Development of Portable Undrained Ring Shear Apparatus and Its Application / ポータブル非排水リングせん断試験機の開発とその応用Maja Ostric 24 September 2013 (has links)
京都大学 / 0048 / 新制・課程博士 / 博士(工学) / 甲第17868号 / 工博第3777号 / 新制||工||1577(附属図書館) / 30688 / 京都大学大学院工学研究科社会基盤工学専攻 / (主査)教授 寶 馨, 教授 木村 亮, 准教授 立川 康人 / 学位規則第4条第1項該当 / Doctor of Philosophy (Engineering) / Kyoto University / DFAM
|
2 |
Natural gas recovery from hydrates in a silica sand matrixHaligva, Cef 05 1900 (has links)
This thesis studies methane hydrate crystal formation and decomposition at 1.0, 4.0 and 7.0°C in a new apparatus. Hydrate was formed in the interstitial space of a variable volume bed of silica sand particles with an average diameter equal to 329μm (150 to 630μm range). The initial pressure inside the reactor was 8.0MPa for all the formation experiments. Three bed sizes were employed in order to observe the effects of the silica sand bed size on the rate of methane consumption (formation) and release (decomposition). The temperature at various locations inside the silica sand bed was measured with thermocouples during formation and decomposition experiments. For the decomposition experiments, two different methods were employed to dissociate the hydrate: thermal stimulation and depressurization.
It was found that more than 74.0% of water conversion to hydrates was achieved in all hydrate formation experiments at 4.0°C and 1.0°C starting with a pressure of 8.0MPa. The dissociation of hydrate was found to occur in two stages when thermal stimulation was employed whereas three stages were found during depressurization. In both cases, the first stage was strongly affected by the changing bed size whereas it was not found to depend on the bed size afterwards.
|
3 |
Natural gas recovery from hydrates in a silica sand matrixHaligva, Cef 05 1900 (has links)
This thesis studies methane hydrate crystal formation and decomposition at 1.0, 4.0 and 7.0°C in a new apparatus. Hydrate was formed in the interstitial space of a variable volume bed of silica sand particles with an average diameter equal to 329μm (150 to 630μm range). The initial pressure inside the reactor was 8.0MPa for all the formation experiments. Three bed sizes were employed in order to observe the effects of the silica sand bed size on the rate of methane consumption (formation) and release (decomposition). The temperature at various locations inside the silica sand bed was measured with thermocouples during formation and decomposition experiments. For the decomposition experiments, two different methods were employed to dissociate the hydrate: thermal stimulation and depressurization.
It was found that more than 74.0% of water conversion to hydrates was achieved in all hydrate formation experiments at 4.0°C and 1.0°C starting with a pressure of 8.0MPa. The dissociation of hydrate was found to occur in two stages when thermal stimulation was employed whereas three stages were found during depressurization. In both cases, the first stage was strongly affected by the changing bed size whereas it was not found to depend on the bed size afterwards.
|
4 |
Natural gas recovery from hydrates in a silica sand matrixHaligva, Cef 05 1900 (has links)
This thesis studies methane hydrate crystal formation and decomposition at 1.0, 4.0 and 7.0°C in a new apparatus. Hydrate was formed in the interstitial space of a variable volume bed of silica sand particles with an average diameter equal to 329μm (150 to 630μm range). The initial pressure inside the reactor was 8.0MPa for all the formation experiments. Three bed sizes were employed in order to observe the effects of the silica sand bed size on the rate of methane consumption (formation) and release (decomposition). The temperature at various locations inside the silica sand bed was measured with thermocouples during formation and decomposition experiments. For the decomposition experiments, two different methods were employed to dissociate the hydrate: thermal stimulation and depressurization.
It was found that more than 74.0% of water conversion to hydrates was achieved in all hydrate formation experiments at 4.0°C and 1.0°C starting with a pressure of 8.0MPa. The dissociation of hydrate was found to occur in two stages when thermal stimulation was employed whereas three stages were found during depressurization. In both cases, the first stage was strongly affected by the changing bed size whereas it was not found to depend on the bed size afterwards. / Applied Science, Faculty of / Chemical and Biological Engineering, Department of / Graduate
|
5 |
KINETICS OF HYDRATE FORMATION AND DECOMPOSITION OF METHANE IN SILICA SAND.Nam, Sung Chan, Linga, Praveen, Haligva, Cef, Ripmeester, John A., Englezos, Peter 07 1900 (has links)
Kinetics of hydrate formation and decomposition of methane hydrate formed in silica sand particles were
studied in detail at three temperatures of 7.0, 4.0 and 1.0°C, respectively. A new apparatus was setup to
study the decomposition behavior of the methane hydrate formed in the bed of silica sand particles. Six
thermocouples are placed in different locations to study the temperature profiles during hydrate formation
and decomposition experiments. Gas uptake measurement curves for the formation experiments and the gas
release measurement curves for the decomposition experiment were determined from the experimental data.
Percent conversion of water to hydrates was significantly higher for the experiments conducted at 4.0 and
1.0°C compared to 7.0°C. Recovery of methane occurred in two stages during the decomposition
experiments carried out with a thermal stimulation approach at constant pressure. Methane recovery in the
range of 95 to 98% was achieved.
|
6 |
RAMAN SPECTROSCOPIC OBSERVATIONS ON THE STRUCTURAL CHARACTERISTICS AND DISSOCIATION BEHAVIOR OF METHANE HYDRATE SYNTHESIZED IN SILICA SANDS WITH VARIOUS SIZESLiu, Changling, Ye, Yuguang, Zhang, Xunhua, Lu, Hailong, Ripmeester, John A. 07 1900 (has links)
Raman spectroscopic observations of the characteristics and dissociation of methane hydrate were carried out on hydrates synthesized in silica sands with particle sizes of 53-75 μm, 90-106 μm, 106-150 μm, and 150-180 μm. The results obtained indicate that methane hydrates formed in silica sands had similar characteristics regarding cage occupancy and hydration number (5.99) to bulk hydrate, indicative of no influence of particle size on hydrate composition. During hydrate dissociation, the change in average intensity ratio of large to small cages were generally consistent with that of bulk hydrate but dropped dramatically after a certain time, and this turning point seems to be related to the particle size of silica sands.
|
7 |
Treatment of acid mine drainage using constructed wetland and UV/TiO₂ photocatalysisSeadira, Tumelo Wordsworth Poloko 05 1900 (has links)
M. Tech. (Chemical Engineering, Faculty of Engineering and Technology), Vaal University of Technology / Acid mine drainage (AMD) is a serious problem associated with mining activities, and it has the potential to contaminate surface and ground water. The aim of this study was to evaluate the performance of constructed wetland and photocatalysis in treating AMD. Three identical unvegetated upflow constructed wetlands packed with natural zeolite (clinoptilolite) and coarse silica sand were made of a cylindrical plastic pipe, and the slurry photocatalyst was prepared using quartz material. A hydro-alcohol thermal method was used to prepare an anatase core-void-shell TiO2 photocatalyst.
The results showed that the three unvegetated upflow constructed wetlands (CW) had relatively similar percentage removal of heavy metals despite their varying concentrations within the AMD. The removals were: Fe (86.54 - 90.4%); Cr (56.2 - 64.5%); Mg (56.2 - 67.88%); Ca (77.1 - 100%); and 100% removal was achieved for Be, Zn, Co, Ni, and Mn. The removal of sulphate was also 30%. Heavy metals concentration in CW packing material was significantly higher in the outlet of the constructed wetlands than in the inlet. The adsorption isotherms revealed that the experimental data fitted the Langmuir Isotherms better, which suggested a monolayer coverage of heavy metals on the surface of the adsorbents; thermodynamic studies showed that the nature of adsorption taking place was physical; the kinetics models showed that the adsorption was first order reaction. A higher photocatalytic reduction (62%) of Cr(VI) was obtained at pH 2, 30 mg/l Cr(VI) initial concentration, and three hours of irradiation time. It was also found that the presence of Fe(III) enhanced the reduction of Cr(VI). The core-void-shell TiO2 photocatalyst showed a better activity than the commercial P25 Degussa for the reduction of Cr(VI) to Cr(III). The kinetic studies showed that the reduction of Cr(VI) was first order reaction. Photocatalytic reduction of Cr(VI) in real AMD sample was achieved only for the Douglas North Discharge (DND) sample (68%), and the Fe(III) reduction was found to be 83%. Therefore it was concluded that the combination of constructed wetland and UV/ TiO2 photocatalysis employing anatase core-void-shell TiO2 as a photocatalyst has a potential to reduce the toxicity of Cr(VI)-laden acid mine drainage.
|
8 |
The Effect of Fine Flocculating Particles and Fine Inerts on Carrier Fluid ViscosityAsadi Shahmirzadi, Azadeh Unknown Date
No description available.
|
9 |
Predicting and Validating Multiple Defects in Metal Casting Processes Using an Integrated Computational Materials Engineering ApproachLu, Yan 30 September 2019 (has links)
No description available.
|
10 |
Mechanistic Study of Under Deposit Corrosion of Mild Steel in Aqueous Carbon Dioxide SolutionHuang, Jin January 2013 (has links)
No description available.
|
Page generated in 0.0577 seconds