The effective of additional muscle mass in a priming exercise on cardiac output (Q) and pulmonary oxygen uptake (VO2) kinetics (mean response time, s) were determined in cyclists. Outcomes were measured over four trials, each consisting of a 6-minute legs alone (UAL) or arms and legs (ULO) warm-up, 3 minute passive recovery, then 6 minutes leg cycling (PAL, PLO; respectively). Q was significantly higher preceding exercise onset with PAL compared to PLO or ULO (0.72 ± 0.13 vs. 0.58 ± 0.09, 0.43 ± 0.09 L∙min-1; respectively, P < 0.05). Q kinetics did not differ between unprimed (ULO: 38.9 ± 8.6) and primed exercise regardless of muscle mass (PLO: 38.6 ± 11.0; PAL: 40.7 ± 11.3). VO2 kinetics were faster (P < 0.05) with PAL (36.9 ± 6.0) compared to ULO (58.7 ± 10.5). Muscle mass employed during priming exercise had only slight effect on subsequent VO2 and Q responses.

No description available.

In Norway spruce there's a large natural variation in durability but knowledge about what is causing this variation is missing. In this thesis the focus were put into investigating how the water uptake ability was affected by the influence of heartwood versus sapwood and wood properties such as density and annual ring width. Liquid water permeability was checked trough a modified version of EN 927-5 and samples were also investigated trough the Mycologg Method. The wide grown wood with a coating system (a priming oil and alkyd or acrylate paint) absorbed less water than the narrow grown wood in the permeability test. The Mycologg test showed a clear difference between wide and narrow grown wood. Further research is necessary to examine the impact of wood properties when it comes to water uptake.

The feasibility of using a thyroid uptake counter, normally used to measure the uptake of radioactive iodine in thyroid treatments, to assay radioactivity deposited in a persons lungs has been investigated. Variations in radioactive material distributions in the lungs, the response of the detector system to radionuclides of interest to homeland security, and the change in detection efficiency due to the varying thicknesses of intervening tissue of the victims have been simulated using the Monte Carlo N-Particle transport code (MCNP5) developed by Los Alamos National Laboratory. Point source and homogenously distributed models were created for Co-60, I-131, Cs-137, Ir-192, and Am-241 sources to simulate radiation transport between the lungs of multiple phantom models representing children and adults and the radiation detection system. To validate the simulations undertaken, the response of the counter to radiation sources in air and behind layers of Lucite have been modeled and compared to measured results.

Although nano-sized metal colloids are used in industrial and medicinal applications, little is known about the potential liver toxicity of these materials after occupational or intentional exposures. To begin to resolve some outstanding hepatotoxicity concerns, the inflammatory response of hepatocytes after exposure to metal colloids was assessed. Four ~30-nm-sized metal colloids, including silver (nano-Ag), copper (nano-Cu) and nickel (nano-Ni) were examined in an effort to understand the induced cytokine expression in a murine liver cell line (AML12). Here we also utilized another system, co-cultures of hepatocytes, Kupffer’s cells, and lymphocytes isolated from C57BL6 mice. Cells were exposed to the materials over dose-response (0.1mg/L to 1000mg/L) and time-dependent (4 h, 48 h, and 1-week) studies. Cytotoxicity was measured via metabolism of resazurin and validated via MTT assay and cell counts. Inflammatory response was determined by cytokine profiles (TNF-a and IL-6), as well as by mRNA and protein expression of heat shock protein (Hsp70). Results from cells exposed to nano-Ag to doses of up to 100mg/L exhibited no significant changes in cytotoxicity, IL-6, or TNF-a production, or Hsp70 expression. Both nano-Cu and nano-Ni exposed cells exhibited decreased metabolism, increased Hsp70 induction, and increased inflammatory responses (IL-6 and TNF-a). Dynamic light scattering and electron microscopy were used to characterize particle size and surface charge. All three metal colloidal systems demonstrated different particle size distributions, agglomerated sizes, and surface zeta potentials. Furthermore, each metal colloid system elicited different inflammatory biomarker responses and stress protein expression.

"Uniaxial Cyclic Stretch-Stimulated Glucose Transport Is Mediated by a Ca2+-Dependent Mechanism in Cultured Skeletal Muscle Cells" Pathobiology, v.74, n.3, pp.159-168を、博士論文として提出したもの。 / 名古屋大学博士学位論文 学位の種類:博士（リハビリテーション療法学）（課程）学位授与年月日:平成19年3月23日

Heavy metals are one of the most important environmental pollutants. In recent years, many low cost stretages of bioremediation for contaminated sites by heavy metals, such as fungi, bacteria and plants have been investigated for their biosorption capacity towards heavy metals. The uses of plant species for remediate contaminated sites by heavy metals are so called phytoremediation. The purpose of the first parts of this study are to (1) evaluate bioavailability of Cadmium (Cd) in contaminated soil and phytoremediation potential by three plant species, Vetiveria zizanioides, Pteris multifida, and Alternanthera philoxeroides (Mart.), and (2) realized the influence of photosynthetic bacteria (PSB) on the uptake of Cd in the three species. The results showed that the Alternanthera philoxeroides (Mart.) could accumulate the highest concentration of Cd among the three species, in which the Cd concentration of plant tissue increased with the concentration in soil. The highest concentration of Cd (164.9 mg kg-1) was found in the below-ground parts of Alternanthera philoxeroides (Mart.) at the 8th week of culturing period. However, the species of Vetiveria zizanioides could accumulate the largest total Cd, up to 547.5 £gg/ plant, which thus extracted the greatest amounts of Cd from the soil. Therefore, in the first part of this study the species of Vetiveria zizanioides was concluded to be the best accumulator among the three plant species. In addition, the concentration of Cd in the species of Pteris multifida was found significantly increased after PSB was added into the soil, but the plants died later due to Cd stress. The experimental results also showed that PSB seemed to be not suitable for each species used in this study to accumulate Cd from Cd-contaminated soil. In the second part of this research, both pot and field experiments were conducted to (1) evaluate bioavailability of copper (Cu), lead (Pb) and zinc (Zn) in contaminated soil and phytoremediation potential by domesticated plants, Bidens pilosa and Passiflora foetida inoculated with arbuscular mycorrhizal (AM) fungi, and to (2) compare the results of pot and field experiments. The plant species of Bidens pilosa inoculated with AM fungi had significantly higher Cu concentrations in the shoots and roots than non-inoculated plants. The plant species of Passiflora foetida inoculated with AM fungi also had significantly higher Cu and Pb concentrations in the roots than non-inoculated plants. When we found that the root dry weight of Passiflora foetida inoculated with AM fungi dramatically increased, the concentrations of Cu, Pb and Zn in the root of the plant species increased by 9-14 times, comparing with the plants without inoculation of AM fungi. The AM fungi have potential either to promot plant growth or to increase heavy metal accumulation. The values of element translocation proportion from root to shoot was Zn>Cu>Pb for the plant species in both pot and field experiments. For both experiments, the results of pot test and field test were significantly different. The concentrations of pot tests were found higher than the field tests, and some values of pot tests were even found significantly greater than those in the field tests. In the third part of this study, the field experiments were conducted to test the feasibility of using domesticated vegetations for phytoremediation of the contaminated farmland. The objectives of this study were (1) to acquire information about the ability of five plant species growing wild in the polluted area to accumulate Cu, Pb and Zn, (2) to investigate the season effects on phytoremediaton of five plant species and evaluate the total uptake of heavy metal, and (3) to run both pot tests and a field trial of phytotremediation to compare their differences. The experimental results showed that three maximum toxic elements in a pot were 3020 mg kg-1 Pb, 232 mg kg-1 Cu and 1012 mg kg-1 Zn respectively. The Cu concentrations of the five plant species collected from the polluted plots ranged from 0.7 to 17.43 mg kg-1. The range of variation of Pb in plant tissues was measured varied from 2.29 to 81.65 mg kg−1, while a wide range of Zn concentrations was found from 12.84 to 192.85 mg kg-1 among the plants collected at the contaminated plots. In comparison to winter season, the Zn concentrations in Broussonetia papyrifera, Passiflora foetida and Saccharum sinensis collected in summer season was significantly higher. The higher Cu concentrations were obtained in both plant species of Bidens pilosa and Mimosa diplotricha in summer season. However, Pb concentrations in Saccharum sinensis collected in winter were significantly higher than those in the same plant species collected in summer. Bidens pilosa was also found having the highest total amount of Cu and Zn. The highest total amount of Pb was found in Mimosa diplotricha. For both plant species, both of the pot and field tests were different.

Thesis (Ph. D)--University of Washington, 2003. / Vita. Includes bibliographical references (leaves 65-78).

This dissertation focuses on two areas of garnet porphyroblast crystallization that have until now remained largely uninvestigated: epitaxial nucleation of garnet porphyroblasts and yttrium and rare earth (Y+REE) uptake in metamorphic garnet. The mechanism of epitaxial nucleation is explored as a step towards determining which aspects of interfaces are significant to interfacial energies and nucleation rates. Garnet from the aureole of the Vedrette di Ries tonalite, Eastern Alps, shows a clear case of epitaxial nucleation in which garnet nucleated on biotite with (110)grt / (001)bt with [100]grt / [100]bt. The occurrence is remarkable for the clear genetic relationships revealed by the microstructures and for its preservation of the mica substrate, which allows unambiguous determination of the coincident lattice planes and directions involved in the epitaxy. Not all epitaxial nucleation is conspicuous; to increase the ability to document epitaxial relationships between garnet and micas, I develop and apply a method for determining whether evidence for epitaxial nucleation of garnet is present in porphyroblasts containing an included fabric. Although the magnitude of uncertainties in orientation measurements for garnets from Passo del Sole (Switzerland), the Nevado Filabride Complex (Spain), and Harpswell Neck (USA) preclude definitive identification of epitaxial relationships, the method has potential to become a viable technique for creating an inventory of instances and orientations of epitaxial nucleation with appropriate sample selection. Using lattice-dynamics simulations, I explore the most commonly documented epitaxial relationship, (110)grt / (001)ms. The range of interfacial energies resulting from variations in the intracrystalline layer within garnet at the interface, the initial atomic arrangement at the interface, and the rotational orientation of the garnet structure relative to the muscovite structure shows that the intracrystalline layer within garnet has the greatest effect on interfacial energy. A complete understanding of the role of intergranular diffusion for yttrium and rare-earth-element uptake in porphyroblastic garnet is critical because the complexities of Y+REE zoning in garnets and the mechanisms of Y+REE uptake have implications for petrologic interpretations and garnet-based geochronology. Y+REE distributions in garnets from the Picuris Mountains (USA), Passo del Sole (USA), and the Franciscan Complex (USA) imply diverse origins linked to differing degrees of mobility of these elements through the intergranular medium during garnet growth. / text

An outstanding challenge in modern medicine is the safe and efficient delivery of drugs. One approach to improve drug delivery yield and increase specificity towards diseased cells, is to employ a drug carrier to facilitate transport. Promising steps towards developing such a carrier have been taken by the nascent field of nanomedicine: nanometer-sized particles designed to evade premature excretion, non-specific absorption, and the body’s immune response, can reduce undesired drug loss, while also increasing specific drug uptake into diseased cells through targeting surface modifications. However, progress is limited by incomplete knowledge of the ‘ideal’ nanoparticle design as well as a lack of appropriate high resolution construction methods for its implementation. DNA origami, a modular, nanometer-precise assembly method that would enable the rapid testing of particle properties as well as massively parallel fabrication, could provide an avenue to address these needs. In this thesis, I employed the DNA origami method to investigate how nanoscale shape and ligand functionalization affect nanoparticle uptake into cultured endothelial cells. In the first part, I evaluated the uptake yield of a series of eight shapes that ranged from 7.5 nm to 400 nm in their individual dimensions. The best performing shape of that study, a 15 × 100 nm DNA origami nanocylinder, was internalized 18-fold better than a dsDNA control of the same molecular weight. In a follow up study, I decorated this nanocylinder with integrin-targeting cyclic RGD peptides. This surface functionalization increased cellular uptake another 13-fold. In addition, uptake yield and the ratio of internalized versus surface-bound particles depended on the number of ligands present on the nanoparticle surface. This work represents a significant first step towards attaining the ability to design and implement an 'ideal' nanoparticle drug carrier. In the future, the DNA origami method can be used as a platform technology to further expand our understanding of transport properties of drug carriers and achieve safer and more efficient drug delivery.