>Magister Scientiae - MSc / During the course of this study iron oxide nanoparticles, which have been researched for drug-targeted delivery, were synthesised via the co-precipitation method and characterised using various methods. This study focused on the role of relevant capping agents for the inhibition of agglomeration of the particles; chitosan, polyvinyl alcohol (PVA) and poly lactic glycolic acid (PLGA) were the capping agents of interest. The study is an assessment of the effects brought about the different capping agents used for this work. The prepared particles were then capped with the different capping agents followed by the loading of the drug curcumin. Various analytical methods were used to analyse the particles such as High resolution transmission electron microscopy (HR-TEM), Superconducting quantum interference device (SQUID), Fourier Transform Infrared spectroscopy (FT-IR), X-ray diffraction (XRD), Thermogravimetric analysis (TGA) and zeta potential. PVA, chitosan and PLGA capped SPIONS were successfully prepared and verified by FT-IR spectrometry, various sizes were prepared almost ranging the same for the successfully prepared particles verified by XRD. The resultant particles were found to be spherical with an average particles size between 13- 22 nm. From the study it was concluded that the addition of the different capping agents resulted in the reduction of the intensity of the peaks in XRD, it was also found out the presence of the capping agents did not alter the crystalline phase of the particles. From the study it was also observed that higher saturation magnetization was experienced where PVA was used as the capping agents.

Due to their small size and large surface area-to-volume ratios, nanoparticles (particles with limiting dimensions smaller than 100 nm) have been widely applied as catalysts. Metal nanoparticles are typically produced in suspensions from metal ion precursors, reducing agents, and organic ligands called capping agents. Capping agents help prevent particle agglomeration, fix nanoparticle size, and promote monodispersity. However, capping agents also affect the morphology and the physico-chemical surface properties of nanoparticles, which can influence catalytic properties in unpredictable ways. While there have been extensive studies focused on examining the relationship between nanoparticle size, shape, composition and catalytic activity, relatively few have investigated the effects of capping agent properties on catalysis, and most studies involving nanoparticle catalysts have been conducted on collections, ensembles, or arrays of particles rather than single nanoparticles. Results obtained for systems composed of multiple nanoparticles dispersed on solid surfaces can be difficult to interpret due to variations in particle loading and interparticle distance, which are often challenging or impossible to control and characterize. The complexity of these unavoidable experimental variables may explain some of the seemingly inconsistent conclusions that have been drawn between nanoparticle properties and catalytic activity in recent reports. Single nanoparticle studies should help overcome limitations associated with investigations based on collections of nanoparticles by helping uncover direct relationships between nanoparticle size, surface properties, and catalytic activity that are unobscured by complex factors such as interparticle distance and particle loading. In this work, we aim to use nitrided carbon fiber ultramicroelectrodes to examine electrocatalytic properties of bare (uncapped) and capped gold nanoparticles at the single nanoparticle level.

Farmers around the world aim to use soil with adequate nutrients to produce sufficient and quality crops to the world's ever-growing population. Unbalanced use of nutrients in the soil will lead to soil deficiency, which is usually seen in South and Southeast Asian countries. This soil deficiency is often due to loss of micronutrient(s) within the soil from farming practices. Micronutrient deficiency affects not only plant growth but human health. Plants grown in nutrient deficient soil produce food with nutrient deficiencies, which affect people dependent on these foods for nutrients (Kathmandu, 2004). Nutrient deficient diseases and disorders like malnutrition are often seen in such cases. Current farming practices often involve leaching, mineralization, and bioconversion, which result in 50-70% loss of micronutrients. Smart practices from nanotechnology can lead conventional farming to more sustainable agriculture (Chhippa, 2016). This study aims to improve the dispersibility and uptake of zinc in plants different dual combination of ‘green' capping agents in zinc nanoparticles. The results of this study suggest tomato plants treated with urea coated with 3% Zn (w/w) using NAC-SAL ZnO showed a higher number of leaves and number of fruits set compared to controls.

>Magister Scientiae - MSc / Tuberculosis (TB) is a disease that results from infection by Mycobacterium tuberculosis, which is regarded the most common infecting organism. TB has killed countless numbers of people particularly in underdeveloped countries. TB bacteria can remain inactive or in dormant state for years without causing symptoms or spreading to other subjects, but as soon as the immune system of the host becomes weakened, the bacteria become active and infect mainly the lungs along with other parts of body. TB cases are further aggravated by other illnesses that affect the immune system, such as human immune virus (HIV), which is very prevalent in resource-poor countries. Interferon-gamma (IFN-γ) is a TB biomarker that has found to have all the qualities that are needed to help and cure Tuberculosis disease. Early diagnosis and treatment are essential measures for effectively controlling the disease. Traditional microbial culture-based tests are the most common methodologies currently used. Usually, these methods involve cell culture, cell counts, and cell enrichment, but this process is time-consuming and laborious, especially for the slow-growing bacteria like M. tuberculosis. Sputum smear is one of the methods currently used to detect acid fast bacilli (AFB) in clinical specimens or fluorescent staining. It is a cost-effective tool for diagnosing patients with TB and to monitor the progress of treatment especially in developing countries. The traditional method of inoculating solid medium such as Lowerstein-Jensen (L-J) or 7H10/7H11 media is also used currently it is slow and takes 6-8 weeks of incubation to diagnose the infection and further more time to determine the susceptibility patterns. The microscopic observation drug susceptibility (MODS) assay they are also used currently they rely on light microscopy to visualize the characteristic cording morphology of M. tuberculosis in liquid culture. MODS has shorter time to culture positivity (average 8 days) compared with LJ medium (average ~26 days), they are very expensive. The Gen-Probe assay specific for M. tuberculosis complex is a rapid detection that is also used, nucleic acid amplification (NAA) test results can be obtained as fast as in two hours (provided if a positive culture is present); it also has a high sensitivity of 99% and specificity of 99.2%. It holds the disadvantage of needing of positive culture that can take several days. Enzyme-linked immunosorbent assay (ELISA), is a test that uses antibodies and colour change to identify a substance. ELISA is an assay that uses a solid-phase enzyme immunoassay (EIA) to detect the presence of a substance, usually an antigen, in a liquid sample or wet sample. It can be used to detection of Mycobacterium antibodies in tuberculosis. The Amplified Mycobacterium Tuberculosis Direct Test (AMTDT) is used for the detection of M. tuberculosis it enables the amplification and detection of M. tuberculosis rRNA directly from respiratory specimens. The diagnostic methods employing genetechnology based on the amplification of DNA or RNA are expected to improve the speed, sensitivity, and specificity of Mycobacterium tuberculosis detection. TB rapid cultivation detection technique, such as MB/BacT system, BactecMGIT 960 system and flow cytometry. The BACTEC MGIT960 system (Becton Dickinson, Sparks, MD) performs incubation and reading of the tubes continuously inside the machine using a predefined algorithm to interpret the fluorescent signal and giving the results as positive or negative. When performing DST, the BACTEC MGIT960 interprets the results as susceptible or resistant to the antibiotic under study. Results are available within 8 days. A recent meta-analysis of the published studies found high accuracy and high predictive values associated with the use of BACTEC MGIT960. These methods are more sensitive and rapid than the traditional microbial culture-based methods. However, they cannot provide the detection results in real-time and most of these methods are centralized in large stationary laboratories because complex instrumentation and highly qualified technical staff are required. Recently, Food and Drug Administration (FDA) approved two new assays that were introduced. These two assays detect in vitro a specific immune response to M. tuberculosis. These tests are the QuantiFERON-TB Gold In-Tube (Cellestis/Qiagen, Carnegie, Australia) and the T-SPOT.TB assay (Oxford Immunotec, Abingdon, United Kingdom). Both assays use whole blood from the patient and measure the production of interferon gamma after the whole blood is exposed to specific antigens from M. tuberculosis. These tests are based on the knowledge that IFN-γ is a product of an active cell-mediated immune response induced by M. tuberculosis. However, TB detection remains a major obstacle due to several drawbacks of these methods. To date, the number of diagnosis approaches for TB has increased as the disease continues to be a major public health problem worldwide and most conventional detection technologies present difficulties in recognizing the presence of M. tuberculosis, since they are time consuming, do not provide clinically reliable results and significantly lack of sensitivity. This thesis focusedon developing two binary and one ternary-electrochemically quantum dots, all synthesised at room temperature in aqueous media for detecting (IFN-γ). Copper telluride (CuTe) and Zinc telluride (ZnTe) was prepared to check how does the two quantum dot behave individual and also to check on how they behave when they are combined and formed ternary quantum dots (CuZnTe). The electrochemical studies of the binary CuTe quantum dots, ZnTe quantum dots and the ternary CuZnTe core-shell quantum dots reveal that ternary quantum dots were stable and showed a significant enhancement in the conductivity of CuZnTe core-shell solution compared to that of CuTe and ZnTe, all studied in solution. The three different quantum dots were capped with three different capping reagents which are tetraethyl orthosilicate (TEOS), thioglycolic acid (TGA), (3-mercaptopropyl) trimethoxysilane (MPS). In the study, a label-free electrochemical immunosensor for the detection of interferon gamma (IFN-γ) was prepared for the first time using ternary quantum dots. The biosensor consists of water-soluble silica coated Copper Zinc telluride (CuZnTe core-shell) quantum dots conjugated to a gold electrode. The antibody-antigen were then conjugated on the CuZnTe core-shell QD modified gold electrode. Results from synthesis of two different binary quantum dots are also presented in the study and compared to the results of the CuZnTe core-shell QDs. The CuTe quantum dots had a small average size which was confirmed through HRTEM, SAXS and XRD analysis

Philosophiae Doctor - PhD / Breast cancer is regarded as the most common cancer in South Africa and its rate of occurrence is increasing. About one in every 31 South African women are at the risk of developing breast cancer and early diagnosis and treatment guarantee 90% survival rate. Tamoxifen is the drugs of choice for the treatment of all stages of breast cancer. The drug binds with estrogen receptor (ER) to minimize the transcription of estrogen dependent genes. However, nearly 50% of ER-positive breast cancer patients either become resistant or fail to respond to tamoxifen resulting in a serious clinical challenge in breast cancer management. The Grand Health Challenges of South Africa includes the development of cost effective diagnostic systems suitable for early detection of diseases and drug resistivity for timely invention and better patient management. / 2020-08-31

Nanočástice perovskitů halogenidů kovů vykazují unikátní vlastnosti, především výjimečně vysoké hodnoty kvantových výtěžků fluorescence, které předurčují tyto materiály pro aplikace v optoelektronických a fotonických zařízeních. Tato práce popisuje přípravu nanočástic perovskitů halogenidů kovů pomocí stabilizačních činidel inspirovaných přírodou. Stabilizační činidla zde slouží nejen ke stabilizaci, ale i k modifikaci povrchu nanočástic za účelem zvýšení funkčnosti výsledných nanostruktur. Úvod práce popisuje optimalizaci přípravy nanočástic precipitační technikou za použití stabilizačních činidel; jako stabilizační činidlo byl zvolen adamantan-1-amin spolu s hexanovou kyselinou. Bylo prokázáno, že klíčový vliv na optické vlastnosti výsledných koloidních roztoků má volba rozpouštědel a teploty při precipitaci. Mimo jiné byl zkoumán vliv koncentrace prekurzorů na výslednou morfologii a optické vlastnosti nanočástic a jejich koloidních roztoků. V neposlední řadě byly nanočástice stabilizovány adamantan-1-aminem spolu s různými karboxylovými kyselinami a byly studovány optické vlastnosti a koloidní stabilita výsledných koloidních roztoků. V dalším kroku byly nanočástice perovskitů stabilizovány pomocí proetogenních aminokyselin L-lysinu and L-argininu. Takto stabilizované nanočástice vykazovaly úzká emisní spektra ve viditelné oblasti a kvantové výtěžky fluorescence dosahující hodnot téměř 100 %. Stabilizace nanočástic prostřednictvím postranních skupin aminokyselin byla prokázána navázáním chránící terc-butoxykarbonylové skupiny na -amino skupinu. Nanočástice stabilizované modifikovaným lysinem v průběhu jejich přípravy vykazovaly závislost optických vlastností na přítomnosti vody. Předpokládá se, že molekuly vody jsou schopné kontrolovat růst krystalové mřížky po navázání na prekurzory perovskitů a ovlivňovat tak výslednou velikost nanočástic, což vede k projevení kvantových jevů. Spojení nanočástic perovskitů s peptidy představuje nový typ materiálů kombinujících výjimečné optické vlastnosti se samoorganizačními a senzorickými vlastnostmi. Tento koncept byl představen přípravou nanočástic perovskitů stabilizovaných cyklo(RGDFK) pentapeptidem. Vzhledem k citlivosti peptidů na jejich byly nanočástice stabilizovány peptidovými nukleovými kyselinami, robustními analogy nukleových kyselin. Ke stabilizaci nanočástic byl připraven monomer a trimer peptidové nukleové kyseliny obsahující thymin jako dusíkatou bázi. Thymin byl na povrchu nanočástic dostupný k interakci s adeninem přes vodíkové můstky umožňující přenos náboje. Kombinace peptidových nukleových kyselin a perovskitů s unikátními optickými vlastnostmi otevírá aplikační možnosti zejména v oblasti optických senzorů.