1 |
The safety relevance of standardized tests for diving equipmentSilvanius, Mårten January 2020 (has links)
Vital components are more or less prone to fail in a diving apparatus. This thesis examines the performance of oxygen sensors, carbon dioxide scrubber monitoring and composite gas cylinders. A partial pressure of oxygen sensor authentication is suggested in a published patent and poster, weaknesses in carbon dioxide scrubber monitoring systems near surface are revealed in a published paper and potential harmful gas permeability properties of a composite gas cylinder, altering the gas composition and decreases the oxygen fraction, is measured and determined in a submitted paper.The importance of adequately and thoroughly performed safety tests that are standardized becomes even more relevant when managing personal protective equipment. The European Committee for Standardization have ratified relevant standard for the work in this thesis;EN-14143 Respiratory equipment – Self-contained re-breathing diving apparatus,EN-12245:2009+A1:2011 Transportable gas cylinders – Fully wrapped composite cylinders, andISO 11119-3:2013 Gas cylinders – Refillable composite gas cylinders and tubes – Design, construction and testing.These tests form a base-line for the methods, tests and result evaluations performed here and are considered safe; however improvements to the tests and standards can be made and are here suggested.
|
2 |
Establishment of an Experimental System in India to Measure the Mixing Ratio and Stable Isotopic Composition of Air CO2 & Observations from Urban and Marine EnvironmentsGuha, Tania January 2013 (has links) (PDF)
The thesis presents observations on the CO2 mixing ratio and the carbon isotopic ratio (13C/12C i.e. δ13) of atmospheric CO2 from the Indian region, for the period 2008 - 2011. An experimental system was established at the Centre for Earth Sciences, Indian Institute of Science, Bangalore. The experimental protocol involves collection of air samples, extraction of CO2 from the air samples collected, and finally the measurement of the CO2 mixing ratio and isotopic ratios of the extracted CO2 using pressure gauge readings and the dual inlet peripheral of the isotope ratio mass spectrometer, IRMS MAT 253. The isotopic ratios measured are scaled to VPDB and corrected for their N2O contribution. The experimental set up is calibrated with primary carbonate standards (NBS19) and an air CO2 reference mixture. The analytical precision (reproducibility of paired samples) obtained for the atmospheric CO2 measurement is ±7 µ mol.mol-1, ±0.05‰ and ±0.17‰ for the mixing ratio, δ 13C and δ 18Oof atmospheric CO2 respectively. The present study lays emphasis on the CO2 mixing ratio and the δ 13C of atmospheric CO2.
There are very few atmospheric CO2 monitoring stations in India. There exists only one long-term monitoring station, Cabo de Rama, on the west coast of India. Of late, a few new stations for measuring atmospheric trace gases have been in operation, with the major focus being on remote locations. Urban stations in India have never been monitored before for both the mixing ratio and the δ13C of atmospheric CO2 together. Monitoring urban stations in India is crucial today as they have become prime emitters of CO2 due to industrial activity. The emission from the sources varies seasonally and is influenced by factors like the Indian monsoon. The Indian subcontinent is surrounded by the Arabian Sea, the Indian Ocean and the Bay of Bengal which act differentially in terms of CO2 uptake or release.
There is also a differential transport of CO2 to and from the open ocean. Thus, understanding the spatial pattern of CO2 in the marine region close to the Indian subcontinent is essential to understand the oceanic uptake/release of CO2.
As part of this thesis, an urban area was monitored during 2008 - 2011 and the marine region was observed during the southwest monsoon of 2009. The temporal variation of the CO2 mixing ratio and δ13C of atmospheric CO2 was observed over an urban station, Bangalore (12° 58′ N, 77° 38′ E, masl= 920 m), India. Since Bangalore is one of the developing urban cities in India, it is interesting to monitor Bangalore air to understand the impact of anthropogenic emissions on atmospheric CO2 variability. The region has four distinct seasons, dry summer (March – May), southwest monsoon (June – September), post monsoon (October – November) and winter (December – February). Thus, it is also an ideal location to identify the effect of different seasons on the contribution of CO2 from various sources. Air samples were collected from the Indian Institute of Science campus, Bangalore, during 2008 - 2011. Both the diurnal and seasonal variations of the mixing ratio and δ13C of CO2 were observed in Bangalore. On the diurnal scale, a higher mixing ratio with lighter carbon isotopes (negative value) of δ13C of CO2 was recorded in the air-CO2 analyzed during the early morning compared to the late afternoon samples. The observations suggest that coal combustion, biomass burning and car exhausts are possible sources for CO2 identified based on the Keeling plot method. The nocturnal boundary layer (NBL) is found to influence the buildup of CO2 concentration in the early morning. The presence of the NBL in the early morning prevents the mixing of locally produced air with the CO2 from the free atmosphere above. Thus, the free air contribution of CO2 is reduced during the early morning rather than in the afternoon. The effect of seasonal variability in the height of the NBL on the air CO2 mixing ratio and the 13C of atmospheric CO2 were documented in the present study. On a seasonal scale, the free air contribution of CO2 was
found to be higher during the southwest monsoon and winter compared to the dry hot summer and post monsoon period. On a seasonal time scale, a sinusoidal pattern in both the mixing ratio and δ13C has been recorded in the observations. While compared with nearby CO2 monitoring stations like the coastal station, Cabo de Rama, and the Open Ocean station, Seychelles, maintained by CSIRO Australia and NOAA-CMDL respectively, Bangalore recorded higher amplitudes of seasonal variation. Seasonal scale variations have revealed an additional source i.e. emission from the cement industry along with other sources identified from diurnal variations. The emission of CO2 from these different sources is not constant; rather it was found to vary with different seasons. The enhanced biomass burning during the dry season drives the δ13C of atmospheric CO2 towards more negative values, while during the southwest monsoon; the increased biosphere cover pushes the δ13C value of atmospheric CO2 towards positive values. The effect of La Nina in 2011 is also prominent in the observation.
The study also intends to identify the spatial variability of both the mixing ratio and δ 13C air-CO2 close to the urban station, Bangalore based on the simultaneous sampling of air from three locations, Bangalore and two coastal stations, Mangalore and Chennai, which are equidistant from Bangalore. Samples were collected during the southwest monsoon and winter of 2010 - 2011. The observations documented a similar source of CO2 for all the three stations irrespective of the season. The factor responsible for the variability in the mixing ratio and the δ 13C of air CO2 among these stations is the differential transport of air from the marine region and its mixing with locally produced air.
To identify the variability of atmospheric CO2 over the marine region, the atmosphere over the Bay of Bengal was monitored during the southwest monsoon of 2009 as part of the Continental Tropical Convergence Zone (CTCZ) Cruise expedition. The ocean surface water was also monitored simultaneously for the δ18O of water and the δ13C of dissolved
inorganic carbon measurement. The combined observations of both air and water have shown the transport of continental air to the marine region and its uptake by the ocean during the period.
The variability of atmospheric-CO2 is also observed during special events like the solar eclipse. During the annular solar eclipse of 15th January, 2010 an unusually depleted source value was identified for Bangalore air. The role of the boundary layer and a change in photosynthesis were identified as possible factors affecting air CO2 composition.
In conclusion, the thesis has provided the first observations on air CO2 variability from an urban station in India. The observations have identified the possible sources of CO2 and have demonstrated the role of climatic phenomena like the Atmospheric Boundary Layer, Indian Monsoon, and La Nina in controlling the behaviour of sources and sinks and thus affecting the air CO2 variability over land and ocean. The seasonal scale variation based on day-to-day variability in the afternoon samples has revealed the important contribution of emissions from the cement industry whose contribution was absent in the diurnal variability. Thus, it is evident from this study that the timing of air sampling is crucial while identifying the sources. The per capita emission of individual urban stations in India is different; thus, it is essential to monitor more urban stations to identify sources and their different contributions. In future, the simultaneous monitoring of both continental and marine air over both the Arabian Sea and the Bay of Bengal will enable us to understand the long range transport of atmospheric CO2. The long term monitoring of CO2 from the Indian region can give us a better perspective on the effect of the Indian monsoon on air CO2 variability and vice versa.
|
3 |
Electrical phenomena during CO2–rock interaction under reservoir conditions : experimental investigations and their implications for electromagnetic monitoring applicationsBörner, Jana H. 12 May 2016 (has links)
Geophysical methods are essential for exploration and monitoring of subsurface formations, e.g. in carbon dioxide sequestration or enhanced geothermal energy. One of the keys to their successful application is the knowledge of how the measured physical quantities are related to the desired reservoir parameters. The work presented in this thesis shows that the presence of carbon dioxide (CO2) in pore space gives rise to multiple processes all of which contribute to the electrical rock conductivity variation. Basically, three mechanisms take place: (1) CO2 partially replaces the pore water, which is equivalent to a decrease in water saturation. (2) CO2 chemically interacts with the pore water by dissolution and dissociation. These processes change both the chemical composition and the pH of the pore filling fluid. (3) The low-pH environment can give rise to mineral dissolution and/or precipitation processes and changes the properties of the grain-water interface.
Investigations on the pore water phase show that the reactive nature of CO2 in all physical states significantly acts on the electrical conductivity of saline pore waters. The physico-chemical interaction appears in different manifestations depending mainly on the pore water composition (salinity, ion types) but also on both temperature and pressure. The complex behaviour includes a low- and a high-salinity regime originating from the conductivity increasing effect of CO2 dissociation, which is opposed by the conductivity decreasing effect of reduced ion activity caused by the enhanced mutual impediment of all solutes. These results are fundamental since the properties of the water phase significantly act on all conduction mechanisms in porous media. In order to predict the variation of pore water conductivity, both a semi-analytical formulation and an empirical relationship for correcting the pore water conductivity, which depends on salinity, pressure and temperature, are derived.
The central part of the laboratory experiments covers the spectral complex conductivity of water-bearing sand during exposure to and flow-through by CO2 at pressures up to 30MPa and temperatures up to 80°C. It is shown that the impact of CO2 on the real part of conductivity of a clean quartz sand is dominated by the low- and high-salinity regime of the pore water. The obtained data further show that chemical interaction causes a reduction of interface conductivity, which could be related to the low pH in the acidic environment. This effect is described by a correction term, which is a constant value as a first approximation. When the impact of CO2 is taken into account, a correct reconstruction of fluid saturation from electrical measurements is possible. In addition, changes of the inner surface area, which are related to mineral dissolution or precipitation processes, can be quantified.
Both the knowledge gained from the laboratory experiments and a new workflow for the description and incorporation of geological geometry models enable realistic finite element simulations. Those were conducted for three different electromagnetic methods applied in the geological scenario of a fictitious carbon dioxide sequestration site. The results show that electromagnetic methods can play an important role in monitoring CO2 sequestration. Compared to other geophysical methods, electromagnetic techniques are generally very sensitive to pore fluids. The proper configuration of sources and receivers for a suitable electromagnetic method that generates the appropriate current systems is essential.
Its reactive nature causes CO2 to interact with a water-bearing porous rock in a much more complex manner than non-reactive gases. Without knowledge of the specific interactions between CO2 and rock, a determination of saturation and, consequently, a successful monitoring are possible only to a limited extend. The presented work provides fundamental laboratory investigations for the understanding of the electrical properties of rocks when the reactive gas CO2 enters the rock-water system. All laboratory results are put in the context of potential monitoring applications. The transfer from petrophysical investigations to the planning of an operational monitoring design by means of close-to-reality 3D FE simulations
is accomplished.
|
Page generated in 0.116 seconds