Broad-scale niche models are good for examining the potential for invasive species occurrences, but can fall short in providing managers with site-specific locations for monitoring. Using Oklahoma as an example, where invasive bighead carp (Hypophthalmichthys nobilis) are established in certain reservoirs, but predicted to be widely distributed based on broad-scale niche models, we cast bighead carp reproductive ecology in a site-specific geospatial framework to determine their potential establishment in additional reservoirs. Because bighead carp require large, long free-flowing rivers with suitable hydrology for reproduction but can persist in reservoirs, we considered reservoir tributaries with mean annual daily discharge ≥8.5 cubic meters per second (m3/s) and quantified the length of their unimpeded portions. In contrast to published broad-scale niche models that identified nearly the entire state as susceptible to invasion, our site-specific models showed that few reservoirs in Oklahoma (N = 9) were suitable for bighead carp establishment. Moreover, this method was rapid and identified sites that could be prioritized for increased study or scrutiny. Our results highlight the importance of considering the environmental characteristics of individual sites, which is often the level at which management efforts are implemented when assessing susceptibility to invasion.

京都大学 / 0048 / 新制・課程博士 / 博士(地球環境学) / 甲第21236号 / 地環博第172号 / 新制||地環||35(附属図書館) / 京都大学大学院地球環境学舎地球環境学専攻 / (主査)教授 山下 洋, 教授 柴田 昌三, 教授 宮下 英明 / 学位規則第4条第1項該当 / Doctor of Global Environmental Studies / Kyoto University / DFAM

Heart failure (HF) readmissions create a financial burden for healthcare nationwide and speak to the lack of effective discharge preparation for patients to be successful with self-care at home. The 183-bed hospital where this DNP quality initiative will take place currently reports an observed-over-expected (O/E) readmission rate for HF patients (Centers for Medicare and Medicaid [CMS]). Core measures on HF developed by the Joint Commission and the Centers for Medicare and Medicaid Services do not appear to be enough to ensure successful transitions of care from hospital to home. Guided by the LOGIC model, the purpose of this quality improvement initiative was to develop a HF educational module to improve patients' readiness to learn in order to promote self-care and prevent readmission to the hospital within 30 days. The design of the educational program was supported by the evidence-based literature and incorporated best practices promoted by the Joint Commission, the Institute for Healthcare Improvement, and the Agency for Healthcare Research and Quality. Content evaluation of the newly developed HF educational program was conducted by 10 experts using a quantitative Likert-type scale and qualitative narrative feedback. Descriptive findings from the Likert scale showed a range of 3.9 to 4.0 in the content, process, and design of the program. Recommendations for improvement included more detail around pathophysiology, as well as how to initiate the process in the outpatient setting. Positive social change can result from the program which offers a relevant strategy to reduce readmissions for HF and has wide-application options for many chronic illnesses that can be better managed through effective discharge teaching.

Thesis (M.S.)--Massachusetts Institute of Technology, Dept. of Civil Engineering, 1982. / MICROFICHE COPY AVAILABLE IN ARCHIVES AND ENGINEERING. / Bibliography: leaves 134-135. / by Roscoe Dillard George III. / M.S.

No description available.

No description available.

No description available.

The construction of a reservoir lake was proposed in 2010 for George County, Mississippi, USA. The proposed reservoir would be designed to serve primarily for industrial water storage. As the preliminary portion of the reservoir project, a baseline watershed assessment was performed for the purpose of identifying a reservoir site with potential to fill a lake volume capable of providing a sufficient water supply to prevent the Pascagoula River near Graham Ferry, Mississippi from dropping below a measured 7Q10 base flow when 100 million gallons of water per day are withdrawn from the river for industrial use. The initial focus of the assessment was on three watersheds Big Creek, Big and Little Cedar Creek, and Escatawpa River. Evaluations of surface water quantity and quality measurements along with reservoir daily water storage models suggested two reservoirs were suitable for continuation of the reservoir project.

The goal of this case study was to investigate the behavior of real textile wastewater in DCMD (Direct Contact Membrane Distillation) treatment and subsequently to develop a simple and effective pretreatment for it. To this moment, this work is one of the only studies to make an in-depth analysis of the treatment while considering the complexity of this effluent, which is inherently composed of Volatile Organic Compounds (VOCs) and surfactants. After the application of pretreatment, it became clear that the main concern with textile wastewater treatment using MD is wetting, not fouling. Sedimentation and filtration alone were effective in removing suspended solids, but insufficient in stopping wetting. However, neutralization before sedimentation and filtration was proven to be a fundamental step in reducing wetting rates. This improved performance happens due to the change in pH of the wastewater sample, which increases the rejection rates by the membrane. The best experiments, neutralized to pHs 7.40 and 9.06, achieved up to 99.89% rejection by the membrane, with up to 97% conductivity decrease when compared to an experiment without neutralization, 97% removal of COD, and 98% TOC. Overall, the permeate obtained in this work after pretreatment demonstrated excellent quality, and the recovered effluent can possibly be reused in the textile industry, aiming for Zero Liquid Discharge (ZLD) processes. Thus, scaling up this technology for real industrial use is still necessary, tailoring the treatment to the effluent's characteristics to obtain the best results.

From past experiments conducted with high intensity lasers, it has been known for some time that laser matter interactions result in the emission of short, transient electromagnetic pulses. Previous investigations into laser generated electromagnetic pulses provide basic information regarding frequencies where such pulses may be present, along with the time duration of the pulses. Such investigations have also demonstrated a number of measurement techniques in which basic information on the pulses may be obtained. The purpose of this current investigation is to obtain a more thorough description and understands of electromagnetic pulses generated for laser matter interaction. To this end, spatial radiation patterns emanating from various laser excited matter sources was predicted using antenna theory for far field radiators. Experimentally, it is the intention of this investigation to gather comprehensive time and frequency domain data on laser matter generated electromagnetic pulses using a number of specific laser targets. Radiation detection techniques using broadband, calibrated EMC horn antennas were devised. A unique measurement system known as an inverse superhetereodyne receiver was designed, tested and demonstrated. An experimental setup using such instrumentation was established. Using the above instrumentation and experimental setup should yield comprehensive time and frequency domain data over a spectra range of 1-40 GHz and with a time resolution of 50 ps. Because the experimental system employed is calibrated, measurements can be corresponded to incident electromagnetic fields. Several tests were conducted to ensure the proper operation of experimental apparatus. A modulation test was conducted on the inverse superhetereodyne receiver to ensure that the experimentally observed signals appeared when and where predicted within the receiver's bandwidth. The experimental setup was used to measure radiation emitted from an electrostatic discharge source of known distance and discharge voltage. Frequency domain data from the discharges were collected and compiled using a Matlab application ultimately intended to measure laser matter interaction generated electromagnetic pulses, resulting in a compiled frequency domain description comprising 1-17 GHz. The inverse Fourier transform was used to retrieve the time domain response from the compiled data. The discharge gaps characteristics where systematically altered as to allow a parametric study of the compiled data. The discharge measurements demonstrate the measurement system's ability to analyze unknown, short duration; broadband microwave signals.