Two steel pipe piles in place in abutments for two different bridge constructions sites were instrumented with strain gauges to measure the magnitude of negative skin friction. The piles were monitored before, during and up to 19 months after construction was completed. The load versus depth and time in each pile is discussed. Maximum observed dragloads ranged from 98 to 127 kips. A comparison with two methods for calculating dragloads is presented. Both comparison methods were found to be conservative, with the Briaud and Tucker (1997) approach more closely estimating the observed load versus depth behavior.

Frequently, deep foundations extend through potentially liquefiable soils. When liquefaction occurs in cohesionless soils surrounding a deep foundation, the skin-friction in the liquefied layer is compromised. After cyclical forces suspend and pore pressures dissipate, effective stress rebuilds and the liquefied soil consolidates. When the settlement of the soil exceeds the downward movement of the foundation, downdrag develops. To investigate the loss and redevelopment of skin-friction, strain was measured on an instrumented micropile during a blast-induced liquefaction test in Mirabello, Italy. The soil profile where the micropile was installed consisted of clay to a depth of 6m underlain by a medium to dense sand. The 25cm diameter steel reinforced concrete micropile was bored to a depth of 17m. Pore pressure transducers were placed around the pile at various depths to observe excess pore pressure generation and dissipation. Soil strain was monitored with profilometers in a linear arrangement from the center of the 10m diameter ring of buried explosives out to a 12m radius. Immediately following the blast, liquefaction developed between 6m and 12m below ground. The liquefied layer settled 14cm (~2.4% volumetric strain) while the pile toe settled 1.24cm under elastic displacement. The static neutral plane in the pile occurred at a depth of 12m. From 6m to 12m below ground, the incremental skin-friction was 50% compared to pre-liquefaction measurements. The decrease in residual skin-friction is consistent with measurements observed by Dr. Kyle Rollins from previous full-scale tests in Vancouver, BC, Canada, Christchurch, New Zealand, and Turrel, Arkansas.

Frequently, deep foundations extend through potentially liquefiable soils. When liquefaction occurs in cohesionless soils surrounding a deep foundation, the skin-friction in the liquefied layer is compromised. After cyclical forces suspend and pore pressures dissipate, effective stress rebuilds and the liquefied soil consolidates. When the settlement of the soil exceeds the downward movement of the foundation, downdrag develops. To investigate the loss and redevelopment of skin-friction, strain was measured on an instrumented micropile during a blast-induced liquefaction test in Mirabello, Italy. The soil profile where the micropile was installed consisted of clay to a depth of 6m underlain by a medium to dense sand. The 25cm diameter steel reinforced concrete micropile was bored to a depth of 17m. Pore pressure transducers were placed around the pile at various depths to observe excess pore pressure generation and dissipation. Soil strain was monitored with profilometers in a linear arrangement from the center of the 10m diameter ring of buried explosives out to a 12m radius. Immediately following the blast, liquefaction developed between 6m and 12m below ground. The liquefied layer settled 14cm (~2.4% volumetric strain) while the pile toe settled 1.24cm under elastic displacement. The static neutral plane in the pile occurred at a depth of 12m. From 6m to 12m below ground, the incremental skin-friction was 50% compared to pre-liquefaction measurements. The decrease in residual skin-friction is consistent with measurements observed by Dr. Kyle Rollins from previous full-scale tests in Vancouver, BC, Canada, Christchurch, New Zealand, and Turrel, Arkansas.