Spelling suggestions: "subject:"retrospective"" "subject:"retroductive""
1 |
Heterodyne self-steering array characterization for mobile communicationsToh, B. Y. January 2001 (has links)
No description available.
|
2 |
Microwave and millimeter-wave rectifying circuit arrays and ultra-wideband antennas for wireless power transmission and communicationsRen, Yu-Jiun 15 May 2009 (has links)
In the future, space solar power transmission and wireless power transmission will
play an important role in gathering clean and infinite energy from space. The rectenna,
i.e., a rectifying circuit combined with an antenna, is one of the most important
components in the wireless power transmission system. To obtain high power and high
output voltage, the use of a large rectenna array is necessary.
Many novel rectennas and rectenna arrays for microwave and millimeter-wave
wireless power transmission have been developed. Unlike the traditional rectifying
circuit using a single diode, dual diodes are used to double the DC output voltage with
the same circuit layout dimensions. The rectenna components are then combined to form
rectenna arrays using different interconnections. The rectennas and the arrays are
analyzed by using a linear circuit model. Furthermore, to precisely align the mainbeams
of the transmitter and the receiver, a retrodirective array is developed to maintain high
efficiency. The retrodirective array is able to track the incident wave and resend the
signal to where it came from without any prior known information of the source location. The ultra-wideband radio has become one of the most important communication
systems because of demand for high data-rate transmission. Hence, ultra-wideband
antennas have received much attention in mobile wireless communications. Planar
monopole ultra-wideband antennas for UHF, microwave, and millimeter-wave bands are
developed, with many advantages such as simple structure, low cost, light weight, and
ease of fabrication. Due to the planar structures, the ultra-wideband antennas can be
easily integrated with other circuits. On the other hand, with an ultra-wide bandwidth,
source power can be transmitted at different frequencies dependent on power availability.
Furthermore, the ultra-wideband antenna can potentially handle wireless power
transmission and data communications simultaneously. The technologies developed can
also be applied to dual-frequency or the multi-frequency antennas.
In this dissertation, many new rectenna arrays, retrodirective rectenna arrays, and
ultra-wideband antennas are presented for microwave and millimeter-wave applications.
The technologies are not only very useful for wireless power transmission and
communication systems, but also they could have many applications in future radar,
surveillance, and remote sensing systems.
|
3 |
RETRODIRECTIVE ANTENNA SYSTEMKaiser, Julius A. 11 1900 (has links)
International Telemetering Conference Proceedings / October 30-November 02, 1995 / Riviera Hotel, Las Vegas, Nevada / Two retrodirective antenna systems that autonomously point high gain beams to a
signal source without requiring a priori knowledge of location are described. The first
is a stationary phased array requiring no phase shifters or switches for its operation.
The second is a steerable platform with a thinned receive array for signal acquisition
and platform pointing and dish(es) to satisfy the high gain function.
|
4 |
Theory and implementation of scalable, retrodirective distributed arraysPeiffer, Benjamin Michael 01 May 2017 (has links)
A Distributed Multi-Input Multi-Output (DMIMO) system consists of many transceivers coordinating themselves into a "virtual antenna array" in order to emulate MIMO capabilities. In recent years, the field of research investigating DMIMO Communications has grown substantially. DMIMO systems offer all of the same benefits of standard MIMO systems on a larger scale because arrays are not limited by the physical constraint of placing many antennas on a single transceiver. This additional benefit does come at a cost, however. Since nodes are distributed and run from independent clock signals and with unknown geometry, each one must its own obtain channel state information (CSI) to the target nodes. In existing DMIMO architectures, array nodes depend on feedback from target nodes to properly synchronize. This means that target nodes must be cooperative and are responsible for the overhead calculating and transmitting CSI feedback to each node in the array.
Within this work, we develop a set of techniques for Retrodirective Distributed Antenna Arrays. Retrodirective arrays have traditionally been used to direct a beam towards a target node, but the work in this thesis seeks to develop a more generalized definition of retrodirectivity. By our definition, a retrodirective array is one that acquires CSI to one or more intended targets simply by listening to the incoming transmissions of those targets; the array may subsequently use this information to do any number of typical MIMO tasks (i.e., beamforming, nullforming, spatial multiplexing, etc.). We explore two primary techniques: i) distributed beamforming and ii) distributed nullforming. Beamforming involves focusing transmitted power towards a specific target node and nullforming involves directing transmissions of array nodes to cancel one another at a specific target node. We focus on these techniques because they can be thought of as basic building blocks for more sophisticated DMIMO techniques.
We first develop the theory for retrodirective arrays. Then, we present an architecture for the implementation of this theory. Specifically, we focus on the pre-synchronization of the array, which involves use of a master/slave architecture and a timeslotted message exchange among the array nodes. Finally, developing algorithms to make these arrays both robust and scalable is the focus of this thesis.
|
5 |
Retrodirective phase-lock loop controlled phased array antenna for a solar power satellite systemKokel, Samuel John 12 April 2006 (has links)
This thesis proposes a novel technique using a phase-lock loop (PLL) style phase control loop to achieve retrodirective phased array antenna steering. This novel approach introduces the concept of phase scaling and frequency translation. It releases the retrodirective transmit-receive frequency ratio from integer constraints and avoids steering approximation errors.
The concept was developed to achieve automatic and precise beam steering for the solar power satellite (SPS). The testing was performed using a transceiver converting a pair of received 2.9 GHz signals down to 10 MHz, and up converting two 10 MHz signals to 5.8 GHz. Phase scaling and conjugation was performed at the 10 MHz IF using linear XOR phase detectors and a PLL loop to synthesize a 10 MHz signal with conjugate phase.
A phase control loop design is presented using PLL design theory achieving a full 2π steering range. The concept of retrodirective beam steering is also presented in detail. Operational theory and techniques of the proposed method are presented. The prototype circuit is built and the fabrication details are presented. Measured performance is presented along with measurement techniques. Pilot phase detectors and PCL achieve good linearity as required. The achieved performance is benchmarked with standards derived from likely performance requirements of the SPS and beam steering of small versus large arrays are considered.
|
6 |
Signal constellations of a retrodirective array phase modulatorKoo, Gregory Andre 05 April 2011 (has links)
A quadrature phase shift keying (QPSK) retrodirective array phase modulator (RAPM) was designed and fabricated to characterize its backscatter signal constellation when placed near objects with varying conductivities and relative permittivities. The signal constellations produced when the RAPM was placed near objects were compared to a constellation in free space to determine relative magnitude and phase changes. When conductors and high permittivity dielectrics were placed close behind the RAPM, constellation points were found to shrink in magnitude by up to twenty percent and shift in phase by up to eight degrees. When conductors were placed between the RAPM and an interrogator, the signal constellation was found to collapse, shrinking by up to 95.6 percent. For materials similar to free space, minimal constellation shrinkage resulted, but signal constellation rotation by up to 68 degrees occurred. The power consumption of a RAPM was also characterized and found to decrease as the number of bits per symbol increased. This result demonstrates that in comparison to conventional backscatter tags, which implement one bit per symbol, the RAPM can implement a greater number of bits per symbol, reduce its power consumption, and increase its range in a passive backscatter communication system. To characterize the beamwidth of the RAPM's retrodirective array, a radar cross section (RCS) measurement of the RAPM was performed over a scan angle range of -90 to +90 degrees. The structural component generated by the RAPM's patch antenna ground plane was found to dominate the antenna mode of the retrodirective array. As a result, a novel homodyne receiver based RCS measurement was performed to filter out the structural RCS component and measure the pure antenna mode of the RAPM.
|
7 |
Total Border Security SurveillanceHerold, Fredrick W. 10 1900 (has links)
International Telemetering Conference Proceedings / October 18-21, 2004 / Town & Country Resort, San Diego, California / This paper describes a system of Total Border Surveillance, which is cost effective, closes existing gaps and is less manpower intensive than the current techniques. The system utilizes a fleet of commercially available aircraft converted to unmanned capability, existing GPS and surveillance systems and autonomous ground stations to provide the desired coverage.
|
8 |
Techniques de contrôle de la réflexion d’une onde plane à l’aide de l’optique de transformation et la modulation d’impédance de surface - application à l’aplatissement du réflecteur rétro-directif / Reflection control techniques of a plane wave using transformation optics and surface impedance modulation - Application to the flattening of the retro-directive reflectorHaddad, Hassan 27 November 2018 (has links)
Ces dernières années, un intérêt croissant est porté aux réflecteurs rétro-directifs aplatis dans le but de remplacer le réflecteur diédrique conventionnel, trop encombrant pour de nombreuses applications. Dans un premier temps, cette thèse étudie deux techniques différentes permettant de réduire l’épaisseur d’un réflecteur diédrique. L’Optique de transformation modifie la constitution matérielle de son volume intérieur alors que la modulation d’impédance de surface introduit une distribution d’impédance à sa surface. On examine également la possibilité de combiner ces deux techniques pour tirer le meilleur parti de chacune d’elle. La deuxième partie de cette thèse étudie l’origine des réflexions parasites pour les panneaux utilisant la modulation d’impédance de surface et propose de nouvelles règles de conception pour atténuer leurs niveaux. Finalement, une mise en oeuvre pratique est proposée pour une modulation d'impédance de surface généralisée qui utilise des impédances complexes et surpasse les performances de la modulation d’impédance classique. / In recent years, increasing interest incompact reflectors with retrodirective response is perceived since the conventional dihedral reflector is too bulky to be integrated within most applications. First, this thesis investigates two different techniques that might lead to lower profiles of the dihedral reflector. It explores the use of Transformation Optics that modifies the filling volume of such a device and Surface Impedance Modulation that introduces an impedance distribution over its surface. It also inspects the possibility of combining those two techniques to take benefit of their complementary advantages. The second part of this thesis investigates the source of parasitic lobes for surface impedance modulated panels and proposes new design rules to mitigate their levels. Finally, it also proposes a practical implementation for a specific setting of the generalized surface impedance modulation that makes use of complex impedances and outperforms a panel implementing the classical modulation.
|
Page generated in 0.0447 seconds