Volatiles of peach (Prunus persica L., cultivar, Gleason Early Elberta) fruit were studied by gas-liquid chromatography, thin-layer chromatography, and infrared spectrometry. Hard mature, firm mature, soft mature, tree ripe, and artificially ripened hard mature fruit obtained from four seasons, 1964 to 1967, were used. A total of 86 peaks were observed in the chromatogram of the tree ripe peach volatiles. Major components of the volatiles identified were mainly esters, gamma and delta lactones, aldehydes, alcohols, and terpenes. In general, concentration of the volatile components were found to increase with the maturity of the fruit. However, that of the artificially ripened fruit did not reach the same level of the tree ripe fruit.

International standards establish criteria for size-selective aerosol sampling for industrial hygiene. Commercially available aerosol samplers are designed to conform to these criteria. This study uses semi-monodispersed aerosols generated in a vertically aligned test chamber to compare the performance of three commercially available respirable dust samplers, one of which can, in addition, simultaneously sample for thoracic and inhalable dust fractions. Comparison methods are used to calculate a theoretical fractional value based on the appropriate sampling conventions of the total dust concentration and size distribution of test materials. Performance of actual samplers can be conducted by comparing observed results to the theoretical value. Results show the design of the test chamber and use of fused aluminum oxide is appropriate to conduct simplified performance verification tests for inhalable and respirable dust samplers. This study showed the TSI RespiCon followed the inhalable and respirable conventions closely, but results for the thoracic fraction required the use of a correction factor. The SKC aluminum cyclone tended to undersample the respirable fraction, while the BGI CAS4 cyclone and the TSI RespiCon appear to most closely follow the convention. Improved selection of test material and characterization of particle sizes are recommended to further develop this method of performance verification.

Title from PDF of title page. / Document formatted into pages; contains 48 pages. / Thesis (M.S.P.H.)--University of South Florida, 2003. / Includes bibliographical references. / Text (Electronic thesis) in PDF format. / ABSTRACT: International standards establish criteria for size-selective aerosol sampling for industrial hygiene. Commercially available aerosol samplers are designed to conform to these criteria. This study uses semi-monodispersed aerosols generated in a vertically aligned test chamber to compare the performance of three commercially available respirable dust samplers, one of which can, in addition, simultaneously sample for thoracic and inhalable dust fractions. Comparison methods are used to calculate a theoretical fractional value based on the appropriate sampling conventions of the total dust concentration and size distribution of test materials. Performance of actual samplers can be conducted by comparing observed results to the theoretical value. Results show the design of the test chamber and use of fused aluminum oxide is appropriate to conduct simplified performance verification tests for inhalable and respirable dust samplers. / ABSTRACT: This study showed the TSI RespiCon followed the inhalable and respirable conventions closely, but results for the thoracic fraction required the use of a correction factor. The SKC aluminum cyclone tended to undersample the respirable fraction, while the BGI CAS4 cyclone and the TSI RespiCon appear to most closely follow the convention. Improved selection of test material and characterization of particle sizes are recommended to further develop this method of performance verification. / System requirements: World Wide Web browser and PDF reader. / Mode of access: World Wide Web.

Indiana University-Purdue University Indianapolis (IUPUI) / Paper spray - mass spectrometry (PS-MS) has been developed as a rapid and direct ionization method for qualitative and quantitative analysis of complex samples at trace levels. In this work, different sampling devices for PS-MS were investigated to improve the assay’s simplicity and sensitivity over traditional approaches. In particular, chapter two characterizes an alternate paper substrate to enhance drug detection on surfaces like asphalt, cloth, concrete, aluminum, and glass. Analysis occurs on a single spray ticket coated with pressure-sensitive adhesive (PSA), also known as Post-it notes to detect and quantify drug residues. A PS-MS method utilizing PSA paper was developed to detect a mixture of ten drugs off of various surfaces to evaluate the qualitative and quantitative capabilities of the aforementioned substrate. After the method development on a conventional linear ion trap mass spectrometer, the assay was translated for use on a portable mass spectrometer to evaluate the suitability of the pressure-sensitive adhesive paper substrate in the field in chapter three. Chapter four introduces a sampling device combined with a snap-in solid-phase extraction (SPE) column. The new cartridge design not only inherits the functions from the first iteration SPE cartridge, including extraction and preconcentration from complex samples, but also exhibits greater flexibility in volume control and ease of use for on-site sample collection.

Different sampling devices for paper spray - mass spectrometry (PS - MS) were investigated to improve the assay’s simplicity and sensitivity over traditional approaches. In the first one, pressure-sensitive adhesive paper was used as both sampling tool to collect drug residues on surfaces and paper substrate in PS - MS analysis. This method showed a significant improvement in drug collection on surfaces leading to low nano-gram level detection limits. Other sampling device being investigated was snap-in solid-phase extraction column, which demonstrated the ability to detect trace amounts of drugs in plasma while allowed easy transportation and the use of PS - MS automated system.