<p>QC 20120703</p>

The EC Landfill Directive (1999), which is enforced in England and Wales through the Landfill (England and Wales) Regulations (2002), has increased the technical challenge associated with the design and construction of landfill containment systems, in particular those on steep side slopes. Increased numbers of lining system components, varied configurations, and complex loading scenarios require advanced analysis tools to facilitate design. This project involved the development of advanced numerical modelling techniques, based on the FLAC finite difference modelling code. The analysis toolbox can be used to predict the behaviour of multilayered geosynthetic and soil lining systems, during and after staged construction. The model can include non-linear interface and geosynthetic axial properties, represent complex loading, including downdrag from the waste mass, whilst retaining the flexibility to represent varied geometries and include engineered support structures. Whilst numerical modelling is becoming increasingly commonplace in commercial design, there is little evidence of the validation of numerical models with field or experimental data. Validation of the analysis toolbox described in this document was conducted by back analysis of published data, modelling of landfill failure mechanisms, and comparisons to large scale laboratory testing. Design of field scale instrumentation has also been carried out as part of this project. The influence of interface shear strength variability has been assessed through the compilation of a comprehensive database, and the effect of this variability on lining system behaviour assessed through reliability based analyses. This has shown probability of failures may be higher than proposed limiting values when adopting traditional accepted factors of safety. A key area of interest identified during the project was the requirement for support, potentially through reinforcement, of the geological barrier. The inclusion of randomly reinforced fibres in bentonite enhanced soil has shown the potential for increased strength, without adverse effects on hydraulic barrier performance. ii Additionally, the influence of geomembrane seams on lining system integrity has been investigated, showing that fusion welded seams can result in stress concentration and extruded seams can cause significant stress concentration.

Microbial Induced Calcite Precipitation (MICP) is an attractive alternative for a variety geotechnical ground improvement practices commonly used today and has a variety of potential applications. This research focuses primarily on its use as a soil stabilization technique using the bacteria Sporosarcina Pasteurii and a single injection point percolation method adapted from previous research in granular soils. This method, and most published data, show an inherent variability in both physical and engineering properties due to the distribution of precipitated calcite within the specimen. The focus of this research is on the quantification of the variability in shear strength parameters induced by MICP treatment in sand. Also, on the initial development of a new treatment method which aims to reduce this inherent variability and offer a more feasible option for field applications. The MICP treated soil columns were sampled at constant intervals from the injection point and then subject to direct shear testing (DST) and calcite distribution analysis. This analysis reiterates previously documented reduction in cementation as distance from injection point increases. The reduction in cementation results in reduced shear strength parameter improvements. This research also concluded a minimum of two percent mass of calcite per total mass of treated soil for significant strength improvements.