The Square Kilometre Array (SKA) is a multibillion and a multinational science project to build the world’s largest and most sensitive radio telescope. For a very large field of view, the combined collecting area would be one square kilometre (or 1, 000, 000 square metre) and spread over more than 3,000 km wide which will require a massive count of antennas (thousands). Each of the antennas contains hundreds of low noise amplifier (LNA) circuits. The antenna arrays are divided into low, medium and high operational frequencies and located at different positions to boost up the telescope’s scanning sensitivity.The objective of this work was to develop and fabricate fully on-chip LNA circuits to meet the stringent requirements for the mid-frequency array from 0.4 GHz to 1.4 GHz of the SKA radio astronomy telescope using Monolithic Microwave Integrated Circuit technology (MMIC). Due to the number of LNA reaching figures of millions, the fabricated circuits were designed with the consideration for low cost fabrication and high reliability in the receiver chain. Therefore, a relaxed optical lithography with Lg = 1 µm was adopted for a high yield fabrication process.Towards the fulfilment of the device’s low noise characteristics, a large number of device designs, fabrication and characterisation of InGaAs/InAlAs/InP pHEMTs were undertaken. These include optimisations at each critical fabrication steps. The device’s high breakdown and very low gate leakage characteristics were further improved by a combination of judicious epitaxial growth and manipulation of materials’ energy gaps. An attempt to increase the device breakdown voltage was also employed by incorporating Field Plate structure at the gate terminal. This yielded the devices with improvements in the breakdown voltage up to 15 V and very low gate leakage of 1 µA/mm, in addition to high transconductance (gm) characteristic. Fully integrated double stage LNA had measured NF varying from 1.2 dB to 1.6 dB from 0.4 GHz to 1.4 GHz, compared with a slightly lower NF obtained from simulation (0.8 dB to 1.1 dB) across the same frequency band.These are amongst the attractive device properties for the implementation of a fully on-chip MMIC LNA circuits demonstrated in this work. The lower circuit’s low noise characteristic has been demonstrated using large gate width geometry pHEMTs, where the system’s noise resistance (Rn) has successfully reduced to a few ohms. The work reported here should facilitate the successful implementation of rugged low noise amplifiers as required by SKA receivers.

No / A systematic identification of the degradation products of hydroxypropyl methylcellulose phthalate (HPMCP) during hot melt extrusion (HME) has been performed. A reverse phase HPLC method was developed for the extrudates of both hydroxypropyl methylcellulose acetate succinate (HPMCAS) and HPMCP polymers to quantify their thermal hydrolytic products: acetic acid (AA), succinic acid (SA) for HPMCAS and phthalic acid (PA) for HPMCP, without hydrolysing the polymers in strong alkaline solutions. The polymers were extruded in the temperature range of 160-190 degrees C at different screw rotation speeds and hydrolytic impurities were analysed. Investigation of extruded HPMCP showed an additional thermal degradation product, who is structural elucidation revealed to be phthalic anhydride (PAH). Moreover, two environmental analytical impurities, dimethyl phthalate and methyl benzoate formed in situ were recorded on GC-MS and their origin was found to be associated with PAH derivatization. Using the experimental data gathered during this study, a degradation mechanism for HPMCP is proposed.

No description available.

L'acide succinique est une molécule linéaire, bi-fonctionnelle qui possède de nombreuses applications alimentaires, chimiques et pharmaceutiques etc. Les connaissances de la régulation des voies métaboliques d’organismes d’intérêt industriel, le génie génétique et le génie des procédés ont permis à des microorganismes recombinants (C. glutamicum) de produire jusqu'à 100 g.L-1 de succinate avec des rendements intéressants. C. glutamicum est largement connu comme l'un des meilleurs producteurs industriels de nombreux acides aminés (glutamate, lysine etc.). Cependant, des études de C. glutamicum ont démontré sa capacité à produire plusieurs acides organiques (succinate, lactate, acétate, etc.). Au cours de ce travail, nous avons supprimé le gène ldhA de C. glutamicum en utilisant le plasmide pk19mobsacBΔldhA. Nous avons démontré que la délétion de ce gène n’avait pas d’incidence sur la capacité de croissance de la bactérie. Par ailleurs, nous avons étudié les effets de l’oxygénation sur la réponse physiologique de C. glutamicum 2262ΔldhA à travers des expériences de cultures en fioles en verre lisses en imposant différentes conditions de kLa. Les résultats ont montré que des faibles kLa (<33 h-1) favorisaient la production d’acides organiques tandis que les kLa élevés amélioraient surtout l’accumulation de la biomasse. Nous avons également mis en œuvre un procédé de production très efficace avec une phase de transition aérobiose-anaérobiose basée sur la régulation de la concentration en oxygène dissous. Avec ce procédé, 327 mM de succinate avec un rendement de 0,94 mole par mole de glucose ont pu être produits avec le mutant ΔldhA. En outre, nous avons vérifié l’efficacité de ce nouveau procédé en l’appliquant à la souche sauvage qui normalement produit 10 fois plus de lactate que de succinate. Ces résultats ont montré une production de 793 mM (94 g.L-1) de succinate et 785 mM (71 g.L-1) de lactate. Ils soulignent ainsi, l'importance de la phase de transition aérobiose-anaérobiose lors des procédés de production de succinate par des bactéries aérobie facultatif. Enfin, des expériences en système bi-étagé ont montré que C. glutamicum 2262 pouvait s’adapter très facilement aux gradients et hétérogénéités en oxygène dissous dans les cultures à grande échelle / Succinic acid is a linear and bi-functional molecule that has several practical applications including food, chemical and pharmaceutical industries. Thanks to increased knowledge on metabolism and pathway regulation of industrially relevant organisms, to the development of performant genetic tools and process engineering, recombinants strains (Escherichia coli, Corynebacterium glutamicum etc.) have been reported to be able to produce up to 100 g.L-1 with interesting yields (> 1.5 mole per mole glucose). C. glutamicum is well known as one of the best industrial producers of numerous amino acids (glutamate, lysine etc.). However, recent studies of C. glutamicum revealed its capability to produce several organic acids (succinate, lactate, acetate, etc.). In this work, we have deleted the ldhA gene of C. glutamicum by using a plasmid vector pk19mobsacBΔldhA. We demonstrated that the mutant and the wild type presented similar growth kinetics with maximal growth rate of about 0.7 h-1. We studied also the effects of oxygenation on C. glutamicum 2262 ΔldhA through cultures at different kLa and it appeared that lower kLa (<33 h-1) favored organic acids production wile higher favored bacterial growth. Furthermore, we designed a tri-phasic process with transition phase by regulation of dissolved oxygen concentration which resulted in the production of 327 mM of succinic acid with a yield of 0.94 mole per mole glucose. The application of the designed process to C. glutamicum 2262 wild type that normally produces lactate with a lactate to succinate production ratio up to 13.3 mol.mol-1, resulted in succinate concentration up to 793 mM (94 g.L-1) and 785 mM (71 g.L-1) of lactate. The succinate production yield was 1.1 mole per mole glucose and acetate production was negligible. These results underlined the importance of aerobic to anaerobic transition in succinate production processes of facultative aerobes and the necessity to engineer not only the microorganism but also the process. Finally, scale-down study have demonstrated the robustness of C. glutamicum against the oxygen gradients in bioreactor