The Estimation of Thevenin Equivalent Parameters is useful for System Monitoring and Protection. We studied a method for estimating the Thevenin equivalent circuits. We then studied two applications including voltage stability and fault location. A study of the concepts of Voltage Stability is done in the initial part of this thesis. A Six Bus Power System Model was simulated using MATLAB SIMULINK®. Subsequently, the Thevenin Parameters were calculated. The results were then used for two purposes, to calculate the Maximum Power that can be delivered and for Fault Location.

<div>The high-frequency switching of transistors in power electronic (PE) converters is known to cause unintended common-mode (CM) current that flows through parasitically-coupled ground paths. One way to model these currents is to utilize time-domain simulations that capture switching dynamics and the corresponding parasitic response. Although potentially useful, the small time steps required can create a computational burden and limit the usefulness of the approach. In addition, access to internal hardware needed to characterize parasitic parameters is often limited.</div><div><br></div><div>In this thesis, frequency-domain Thevenin equivalent circuits (TECs) are derived to model the CM behavior of PE converters. To do so, periodic linear time-varying (PLTV) analysis is used to develop Thevenin-like models that account for switching behavior of PE circuits. Subsequently, it is shown that in many applications these PLTV TECs can be reduced to traditional linear time-invariant (LTI) forms. Methods to experimentally characterize LTI TEC parameters and couple multiple TECs together for system-level analysis are then established. Finally, the TEC approach is extended to model converters in which common- and differential-mode (CM/DM) behavior are strongly coupled. Simulation and experimental results are used to validate the proposed TEC techniques.</div>

[pt] O surgimento do fenômeno de estabilidade de tensão na operação dos sistemas elétricos motivou centenas de pesquisadores a desenvolverem métodos que permitam detectar a proximidade à instabilidade de tensão, com eficiência computacional, e tomar medidas acertadas para garantir a operação confiável e segura. Neste trabalho são analisados diferentes métodos que permitem transformar sistemas de grande porte em circuitos simples: o circuito equivalente entre geradores e cargas, baseado no cálculo de correntes de curto-circuito, na técnica de redução de rede pela eliminação de barras intermediárias e no equivalente de Thévenin. É analisada a utilização destes equivalentes na avaliação das condições de estabilidade de tensão com sistemas-testes de 3 e 4 barras. Através de diferentes testes verificou-se que o circuito equivalente entre geradores e cargas e a técnica de redução de rede não podem ser usados para o cálculo de índices de avaliação das condições de estabilidade de tensão, enquanto que, usando circuito equivalente de Thévenin encontrou-se um método que funciona corretamente para barra de carga terminal, barra não-terminal e barra de tensão controlada por gerador. / [en] The emergence of voltage stability phenomenon in the operation of power systems has motivated hundreds of researchers to develop methods to detect the proximity to voltage instability, with computational efficiency and to take all necessary and appropriate measures to ensure reliable and safe operation. In this work, different methods that allow transforming large systems into simple circuits were analyzed, such as the equivalent circuit between generators and loads, based on the calculation of short-circuit currents; the network reduction technique for eliminating intermediate buses; and the Thévenin equivalent. The application of these equivalents on voltage stability assessment of 3 and 4 bus testing systems were extensively tested. At the end, it was verified that that the equivalent circuit between the generator and load, and the network reduction technique, cannot be used for calculating the voltage stability conditions evaluation indexes. However, using Thévenin equivalent circuit, it was found a proper method, which works correctly for terminal buses, transit buses and voltage-controlled buses.

Hybrid powertrains represent the current trend on passenger cars. The purpose of thisreport is to create a basic model of a hybrid powertrain in Matlab/Simulinkenvironment and study their performance over certification driving cycle. Threecommonly used architectures are modeled and discussed in Simulink. Hence, the basiccomponents of a powertrain – battery, electric machine and combustion engine – arestudied and basic models are realized. A Thevenin equivalent circuit is used to simulatethe behavior of the battery, and the combustion engine is modeled after a Willansmodel. The electric machine model is based on a known efficiency map. Then, thearchitectures are created as well as their control strategies. The control strategies arecreated through state diagrams, and implemented into the Simulink model viaStateflow charts. A validation procedure is presented in order to study the consistencyof the models. / Hybrid drivlinor representerar en central personbilstrend. Syftet med rapporten är attpresentera en grundläggande modell för en hybrid drivlina i Matlab/Simulink. Trearkitekturer behandlas och har implementerats i Simulink. Sedan studeras degrundläggande komponenterna i ett drivaggregat (batteri, elmaskin ochförbränningsmotor). En Thevenin-ekvivalent krets används för att simulera batterietsbeteende. Förbränningsmotorn är modellerad efter en Willans-modell.Elmaskinmodellen är baserad på en känd verkningsgradsmapp. De tillhörandestyrstrategierna med hjälp av tillståndsdiagram. De implementeras i Simulinkmodellenmed hjälp av Stateflow-diagram. Ett valideringsförfarande presenteras ochvisar modellernas konsistens.

[pt] O fenômeno associado à estabilidade de tensão se caracteriza pela existência de valores máximos de potência ativa e reativa que podem ser transferidas a uma barra de carga, ou injetada na rede através dos geradores e compensadores síncronos. Sua relevância para o setor elétrico é constantemente reforçada pelo registro de ocorrências de colapsos de tensão em diversos países do mundo e, embora a instabilidade de tensão manifeste-se localmente, suas consequências se refletem na ampla deterioração do sistema. Impulsionado pelo crescente interesse a respeito dos métodos baseados em medições fasoriais sincronizadas para a detecção do máximo carregamento, este trabalho apresenta os principais modelos encontrados na literatura baseados em medições locais e no vasto monitoramento do sistema, com maior ênfase aos métodos de Corsi-Taranto e Circuito Acoplado de Porta-Simples Aprimorado (CAPS Aprimorado). Algumas contribuições são sugeridas ao modelo CAPS Aprimorado tendo em vista sua aplicação ao conjunto de barras de transferência e de geração. Explora-se a utilização dos equivalentes multi-portas como índice de avaliação das condições de estabilidade de tensão, comparando a identificação da barra crítica aos métodos da matriz D e dos autovalores e autovetores. São evidenciadas as principais limitações dos modelos mediante a um conjunto de análises estáticas e dinâmicas, considerando diferentes cenários de carregamento, a sensibilidade dos modelos ao ruído e a resposta dos métodos em face da atuação dos limitadores de sobre-excitação. / [en] The voltage stability phenomenon is characterized by the existence of a maximum active and reactive power that can be transferred to a load bus or injected into the network through the generators and synchronous compensators. Its relevance to the electric power sector is constantly reinforced by the record of occurrences of voltage collapses in several countries around the world. Although the voltage instability manifests itself locally, its consequences is reflected in the wide deterioration of the system. Driven by growing interest in methods based on synchronized phasor measurements for maximum loadability detection, this work presents the main models found in the literature based on local measurements and wide area monitoring, emphasizing the Corsi-Taranto method and Improved Coupled Single-Port Circuit (Improved CAPS). Some contributions are suggested to the Improved CAPS model considering its application to the set of transit and controlled buses. The use of the multi-port equivalents is explored as the evaluation index of voltage stability conditions, comparing the identification of the critical bus to the D matrix method and eigenvalues and eigenvalues method. The main limitations of the models are demonstrated through a static and dynamic studies, as well different loading scenarios, the sensitivity of the models to the noise and the response of the methods when the over-excitation limiters are considered.