Coastal areas around the world have been recognized as largely impacted by anthropogenic activities resulting in pollution of marine sediments. In Sweden, surveys conducted along the coastline of the Bothnian Bay have identified a total area of about 29 km2 as fiber rich sediments. In the Bureå sea area near Skellefteå vicinity, Västerbotten county, elevated levels of mercury (Hg), methyl-Hg, arsenic (As), copper (Cu), lead (Pb), cadmium (Cd), zinc (Zn) and polycyclic aromatic hydrocarbons (PAH) have been classified and believed to be mainly affected by emissions from a pulp and paper industry formerly active on a nearby headland.  Contaminants in sediments are of concern as continuous dispersion can adversely affect the benthic community. To isolate contaminants and reduce their bioavailability, in-situ thin-layer capping using an active material is one suitable approach. This type of remediation method, using biochar mixed with bentonite clay will be implemented on a pilot scale in the sea area outside of Bureå in the spring of 2021. However, bentonite is a relatively expensive material yielding a need to further develop the selection of capping materials suitable to aid in the deposition of biochar in an active thin-layer cap. In this thesis, biochar-based thin layer caps mixed with bentonite clay, rock dust of two grain sizes and a concrete-based slurry was evaluated on their physicochemical properties and efficiency for preventing release of trace elements from sediment to the overlying water. This was conducted by a laboratory column experiment where four set ups were performed: (1) no capping for sediment control, (2) only capping material for material control, (3) sediment mixed with biochar and (4) sediment capped with each material mixed with biochar. Three times during an 8-week test period, 60 mL of the overlying water in the columns was extracted and sent for trace element analysis.  The experimental set up revealed that the capping layers effectively prevent release of trace elements trough the sediment to the overlying water. The concrete slurry showed suitable settling properties and negligible loss of biochar in the set-up of the columns. Also, the biochar+concrete slurry thin-layer cap displayed the highest efficiency for preventing and/or delaying release of As, P, Cu, Fe, Mn and SO4.

Persistent organic pollutants (POPs) are hydrophobic substances that readily sorb to organic matter in particles and colloids instead of being freely dissolved in the water phase. This sorption affects the bio­availability and environmental transport of the POPs. The major part of this thesis concerns the role of sediments as secondary sources of POPs. As the primary emissions decrease, contaminated sediments where POPs have accumulated can become the main source of contamination. If the contaminated sediment by time becomes covered with cleaner layers, the POPs are buried and no longer in contact with the aquatic environment. Experiments in this thesis showed, however, that new invading species can alter the sediment-water dynamics as a result of their bioturbation, i.e. mixing of sediment particles and pore-water. Marenzelleria spp., invading species in the Baltic Sea that burrow deeper than native species, were found to increase the remobilization of buried contaminants. The sediment-to-water flux was inversely related to the burial depth (2-10 cm) of the POP congeners (polychlorinated biphenyls (PCBs) and polybrominated diphenyl ethers) and also inversely related to the hydrophobicity of the congener. The flux was therefore most pronounced for less hydrophobic contaminants, which was linked to the bioirrigating behaviour of these species. Marenzelleria spp. also accumulated the buried POPs and increased concentrations in surface sedi­ment. Contaminants previously considered buried at a ’safe’ depth can thus be remobilized as a result of the invasion of Marenzelleria spp. in the Baltic Sea. One method to decrease the remobilization of contaminants from sediments is ’capping’, i.e. a layer of clean material is placed as a cap on the sediment. By amending the cap with active materials, which sequester the POPs and decrease their availability, thinner layers can be used (’active capping’ or ’thin-layer capping’). Results from an experiment with thin-layer capping using different active materials (activated carbon (AC) and kraft lignin) showed that both the sediment-to-water flux and the bioaccumulation by benthic species of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs), hexachlorobenzene (HCB) and octachlorostyrene (OCS) decreased with increased thick­ness of the cap layer (0.5-5 cm). Amendments with active materials further increased the cap efficiency. AC was more efficient than kraft lignin, and a 3 cm cap with 3.3% AC reduced the flux and bioaccumulation with ~90%. The reduction of the sediment-to-water flux was inversely related to the hydrophobicity of the POP, and reductions in the flux had similar magnitudes as reductions in the concentration in deep-burrowing polychaetes, demonstrating the importance of bioturbation for sediment-to-water transport. In a one-year study on the levels of PCDD/Fs, PCBs, and HCB in a coastal area of the Baltic Sea, the correlations between the POP levels and the levels of particles and organic carbon in the water were found to differ for POPs of different structure and hydrophobicity. The levels of PCDD/Fs decreased to one third in May, which could be related to the increased sedimentation, i.e. water-to-sediment transport, during spring bloom.