In this dissertation, not only the antenna and antenna array design techniques for fourth-generation mobile communication system are proposed, but also the specifications related to antenna bio-compatibility are studied. At first, two dual-wideband design techniques suitable to be applied for laptop computer applications for LTE/WWAN and LTE MIMO operations are proposed. The techniques can also be applied to internal tablet computer antennas. The isolation issues of MIMO antenna array of different mobile communication devices, such as laptop computer, tablet computer, and mobile phone, are then discussed. Finally, an analysis of body SAR for tablet computer applications are given and discussed.

The research of this thesis is on the mobile TV antenna designs. There are three antenna designs proposed in this thesis. The first two designs are for portable TV sets. They are different from the traditional straight monopole antenna because the two proposed designs can be built-in with the portable TV set. The third one is for laptop applications. It can be stored inside a laptop when the antenna is not in use, and can be pulled out of the laptop when in operation. Thus the proposed antenna will not affect the appearance of the laptop.

Ultra-wideband (UWB) antennas are one of the most important elements for UWB systems. With the release of the 3.1 - 10.6 GHz band, applications for short-range and high-bandwidth handheld devices are primary research areas in UWB systems. Therefore, the realization of UWB antennas in printed-circuit technologies within relatively small substrate areas is of primary importance. This thesis focuses on the design of a new UWB antenna based on coplanar technology. Compared with microstrip circuitry, coplanar technology achieves easier fabrication and wider antenna bandwidth. Two professional full-wave field solver software packages, HFSS and MEFiSTo-3D, are used as analysis tools to obtain antenna performances. A new printed-circuit antenna in coplanar technology for UWB systems is introduced. The frequency of operation is 3.1 GHz to 10.6 GHz with a VSWR < 2. Nearly omni-directional characteristics in vertical polarization are demonstrated at selected frequencies. Relatively good group delay characteristics are obtained and compare well with other published UWB antenna designs.

Le développement de l’électronique embarquée et miniaturisée est pleinement d’actualité de nos jours, dans les domaines tels que l’armement, la médecine, et les télécommunications. La miniaturisation des antennes large-bande, opérationnelles sur plus d’une décade, présentent un défi particulier. Ces travaux de thèse proposent de travailler sur la miniaturisation d’une antenne spirale, afin d’en réduire l’encombrement, à savoir son diamètre, tout en conservant au mieux ses caractéristiques de rayonnement et polarisation intrinsèques. Cette recherche sera appliquée à la bande des Très hautes Fréquence (Very High Frequencies – VHF), allant de 30MHz à 300MHz La géométrie inédite proposée consiste à associer à une antenne spirale un ensemble d’anneaux résonnants, dont le diamètre n’excède pas celui de la spirale, et permettant de diminuer la fréquence basse de fonctionnement. Pour un ensemble de cinq anneaux associé à la spirale, la réduction de la fréquence basse de fonctionnement est de plus de 30%. Pour deux antennes spirales de même fréquence basse de fonctionnement, l’antenne miniaturisée a donc un diamètre réduit de 30%, soit une surface réduite de 50%. Les performances de l’état de l’art d’après lesquelles les réductions sur le diamètre des antennes spirales n’excèdent pas 15% sont donc dépassées. De plus, d’après cet état de l’art, les méthodes de réduction appliquées aux antennes large bande dégradent en général le gain et l’axial ratio dans les bandes basses de fréquences de fonctionnement. La méthode proposée permet de conserver l’efficacité de l’antenne, voire de l’augmenter, dans les fréquences proches de la fréquence basse de fonctionnement. Le rayonnement de l’antenne spirale miniaturisée dans la bande passante de l’antenne sans anneaux n’est pour autant pas modifiée. Ces résultats très encourageant ont été confirmés par la mesure d’antennes spirales miniaturisées, réalisées pour un diamètre de 8cm et de 1m : une réduction de 30% du diamètre sans dégradation du rayonnement a été observée. Les mesures ont par ailleurs donné lieu à l’étude de la réalisation d’une antenne en bande VHF, avec pour implication les problématiques de réalisation (masse, encombrement, résistance mécanique) et de mesure (isolation, effets parasites en VHF avec une longueur d’onde de 4m). / Miniaturizing electronic devices is a great challenge in crucial research domain such as defense, medicine, and telecommunications. Wideband antenna miniaturization operating on more than a decade is a particular issue. This thesis presents an original method for miniaturizing a spiral antenna, reducing its diameter while keeping its bandwidth, its radiating performances and its axial ratio characteristics. This method is applied to UHF spiral antenna (from 750MHz) and VHF antenna (from 75MHz). The new geometry adds stacked resonant rings to an Archimedean spiral antenna. Their diameter are the same, hence no rise of the antenna diameter. For a 5-ring spiral antenna, the lowest operating frequency reduction is higher than 30%. That is equivalent to a 30% reduction of the diameter for two antennas sharing the same lowest operating frequency, hence a 50% reduction of the area of the antenna. These reduction factors surpass the reduction factors of the state of art of 15%. Besides, according to the state of art, the miniaturizing techniques imply some degradation of the gain and axial ratio performances at the lowest operating frequencies. The new method improves on the other hand these characteristics at these frequencies. At higher frequencies, the rings do not interfere with the matching of neither the spiral antenna nor its radiation characteristics. These results were validated by fabricated antenna measurements. A 30% reduction of the diameter was obtained on a 5-ring-8cm-large antenna as well as on a 5-ring-1m-large antenna. No impairment was noticed on the radiation of the antennas, even at the lowest operating frequencies. The thesis also discusses the difficulties which came in addition for the fabrication (mass, size and mechanical resistance) and measurement (radiation interferences and measurement isolation – the wavelength being 4m) of the VHF antenna.

Yes / This communication presents a single-feed ultra-wideband circularly polarized (CP) antenna with high front-to-back ratio (FBR). The antenna is composed of two orthogonally placed elliptical dipoles printed on both sides of a substrate. To realize high FBR, a novel composite cavity is also proposed and integrated with the presented crossed dipoles, which effectively reduces the backlobe of the crossed dipoles. Simulation results are in good agreement with the measured results that demonstrate an impedance bandwidth from 0.9 to 2.95 GHz (106.5%) and a 3-dB axial ratio (AR) bandwidth from 1 to 2.87 GHz (96.6%). The measured FBR is about 30 dB across the whole global navigation satellite system (GNSS) band. Compared with other reported single-feed wideband CP antennas, the antenna has advantages such as a wider CP bandwidth and lower backlobe radiation.

Yes / In this article, a novel uniplanar ultra‐wideband (UWB) stop frequency selective surface (FSS) was miniaturized to maximize the gain of a compact UWB monopole antenna for microwave imaging applications. The single‐plane FSS unit cell size was only 0.095λ × 0.095λ for a lower‐operating frequency had been introduced, which was miniaturized by combining a square‐loop with a cross‐dipole on FR4 substrate. The proposed hexagonal antenna was printed on FR4 substrate with coplanar waveguide feed, which was further backed at 21.6 mm by 3 × 3 FSS array. The unit cell was modeled with an equivalent circuit, while the measured characteristics of fabricated FSS array and the antenna prototypes were validated with the simulation outcomes. The FSS displayed transmission magnitude below −10 dB and linear reflection phase over the bandwidth of 2.6 to 11.1 GHz. The proposed antenna prototype achieved excellent gain improvement about 3.5 dBi, unidirectional radiation, and bandwidth of 3.8 to 10.6 GHz. Exceptional agreements were observed between the simulation and the measured outcomes. Hence, a new UWB baggage scanner system was developed to assess the short distance imaging of simulated small metallic objects in handbag model. The system based on the proposed antenna displayed a higher resolution image than the antenna without FSS.

No description available.

No description available.

Yes / The potentially broad application area in engineering design using Genetic Al- gorithm (GA) has been widely adopted by many researchers due to its high consistency and accuracy. Presented here is the initial design of a wideband non-dispersive wire bow-tie antenna using GA for breast cancer detection applications. The ultimate goal of this design is to achieve minimal late-time ringing but at higher frequencies such as that located from 4 to 8 GHz, in which is desire to penetrate human tissue for near field imaging. Resistively loading method to reduce minimal ringing caused by the antenna internal reflections is implemented and discussed when the antenna is located in free space and surrounded by lossy medium. Results with optimised antenna geometry and di®erent number of resistive loads are presented and compared with and without existence of scatterers.

Yes / A compact planar monopole antenna is proposed for ultra-wideband applications. The antenna has a microstrip line feed and band-rejected characteristics and consists of a ring patch and partial ground plane with a defective ground structure of rectangular shape. An annular strip is etched above the radiating element and two slots, one C-shaped and one arc-shaped, are embedded in the radiating patch. The proposed antenna has been optimized using bio-inspired algorithms, namely Particle Swarm Optimization and the Firefly Algorithm, based on a new software algorithm (Antenna Optimizer). Multi-objective optimization achieves rejection bands at 3.3 to 3.7 GHz for WiMAX, 5.15 to 5.825 GHz for the 802.11a WLAN system or HIPERLAN/2, and 7.25 to 7.745 GHz for C-band satellite communication systems. Validated results show wideband performance from 2.7 to 10.6 GHz with S11 ˂ -10 dB. The antenna has compact dimensions of 28 × 30 mm2. The radiation pattern is comparatively stable across the operating band with a relatively stable gain except in the notched bands. / This work was supported in part by the United Kingdom Engineering and Physical Science Research Council (EPSRC) under Grant EP/E022936A, TSB UK under grant application KTP008734 and the Iraqi Ministry of Higher Education and Scientific Research.