This work is concerned with posibility of measuring a wind flow by Von Karman vortex sheed structure. The bluff body is situated in the way of air flow propagation and consequentally vortexes will be appeared. Important part of speedmeter design is measurment chamber must allow to vortex sheed propagation. The transient and the reciever are situated vertically to propagation of flow.The Ultrasonic carrier is transmitted and modulated by freqency of vortex sheeding in measurment chamber.Demodulator uses PLL to “focusing“ detection of the ultrasonic beam. This can be indicated like lock and unlock phase loop. From known value of sheed frequency can be directly calculated speed of flow.

This thesis discusses about using the worldwide satellite system GPS for time and frequency synchronization. This thesis presents study about basic principles of the GPS system, its segments and ways of using this system. Some GPS receivers suitable for receiving the time marks (pulses) used for time synchronization are described. Thesis contents designing of the circuit that will receive time marks and it will digitalize and record external signal and send it with precision time information to PC for displaying and post processing. Thesis also discusses about both hardware and software development of the synchronization module and software used in PC.

This diploma thesis deals with the influence of long fiber optic paths on the polarization state of light and their use for powering polarization sensors. The aim of the diploma thesis was to design the arrangement of optical fiber components so that the polarization properties of light at the end of the path are further usable for sensory purposes. Four partial measurements with a long path (in a laboratory setting, laying in the ground, on a curtain, under the influence of external influence) and one measurement without a path under the influence of external influence were designed. The overall measurement results demonstrate that for the functional power supply of long-distance sensor systems, an existing single-mode fiber can be used (laid by laying in the ground), into which a light source for a given sensor system would be multiplexed. In the discussion, all types of measurements are analyzed and compared with each other. Finally, the overall result is summarized and applications are described in which such a sensor system could be used.