Cracks in the concrete slab of continuous composite bridges are common due to the tensile stresses at the supports. These bridges are allowed to crack as long as the cracking is controlled and not exceeding the design crack width (according to Bro 94 the crack should be injected if they are bigger than 0.2 mm). The Ångermanälven Bridge (railway bridge part of the Bothnia line project) was designed with big edge beams of width 1.2 m, 40 % of the total area of the concrete deck cross-section. During the final inspection cracks larger than the design crack width (0.3 mm according to Bro 94) were observed over the supports.In this thesis the design and the construction procedure of the bridge is studied to clarify the causes of the cracking in the edge beam. The objectives of this thesis were addressed through a literature study of the different types of cracks and the Swedish bridge codes. The expected crack width was calculate according to the same code, using a 2-D FEM model for the moment calculation, and compared with the crack width measured at the bridge.The result of the calculations shows that tensile stress due to ballast and only restraining moment due to shrinkage is not big enough to cause the measured crack width. Shrinkage force and temperature variation effects may have contributed to the concrete cracking in the edge beams. The large cross-section area of the edge beams indicates that it should be designed as part of the slab, taking that into consideration, 1.1 % reinforcement ratio in the edge beams is believed to limit the crack width to the code limits (0.3 mm).

Environmental awareness has strongly increased these last years, especially in the developed countries where societies have become increasingly preoccupied by the natural resource depletion and environmental degradation. At the same time, the increasing mass transportation demand throughout the European Union requires the development of new infrastructures. Life Cycle Assessment is increasingly used to provide environmental information for decision-makers, when a choice is to be made about the transportation mode to be implemented on a given route. In a life-cycle perspective, not only the environmental pressure of the operation of vehicles but also the burden from the infrastructure, in particular bridges as key links of the road and railway networks, has to be assessed when comparing transportation modes. Based on an extensive literature review, a simplified quantitative LCA is implemented in order to compare the environmental performance of two railway bridge designs. It is meant to be useful at an early stage in the design process, when no detailed information about the bridge is available, and when rough environmental estimations are needed. The Excel based model covers the entire life-cycle of the bridge, from raw material extraction to construction materials recycling and disposal. Various assumptions and omissions are made to narrow the scope of the analysis. For instance, processes that are found insignificant in the literature are omitted, and only a limited set of relevant emissions and impacts to the environment is considered. The model provides fully transparent results at the inventory and impact assessment level. The streamlined approach is tested by comparing the environmental burden throughout the life-cycle of a steel-concrete composite railway bridge on a single span, equipped with either a ballasted or a fixed concrete single track. The results show that the environmental impacts of the fixed track alternative are lower than that of the ballasted track alternative, for every impact categories. In a sustainable development perspective, it would thus have been preferable to install a fixed track over the bridge to reduce its overall impact on the environment by about 77%. The raw material phase is found decisive in the life-cycle of both alternatives. The frequency of the replacement of the track is identified as a key environmental parameter, since the road traffic emissions during bridge closure nearly overwhelmed the other life-cycle stages.

Artificial ground freezing as a method to temporarily stabilize and create hydraulic sealing in urban as well as in rural areas has been used in a number of Swedish construction projects, particularly during the last decade. One problem with the freezing of soil and rock is that fine-grained clayey types of soils have showed a tendency to under certain circumstances, during the thawing process, create a pore water overpressure and to consolidate, despite a change in the external loading conditions. In certain cases, this condition can be a desired effect as the soil mass after a freeze- and thaw cycle acquires overconsolidated properties. The main objectives of this study are, to describe and review the knowledge and current state of practice of artificial ground freezing, to increase the understanding about the conceptual behaviour for prognosis of the vertical deformation concerning artificial ground freezing and to compare and discuss results from laboratory and field studies concerning vertical deformation during thawing process for Bothnia soil. The field studies and the laboratory tests in this research study have been performed with soil from the freezing of the Bothnia Line in the vicinity of Stranneberget. The Bothnia Line is the railway link between Nyland, north of Kramfors, and Umeå. This thesis relates to a part of the Bothnia Line. It deals with the behaviour of soil during thawing by means of temporary stabilization and hydraulic sealing of fine-grained soil through artificial freezing using brine as the cooling agent. However, the reason behind the problem consists of the final deformations due to the thawing process. The general conclusions of this study are; the Bothnia soil water content decreased in mean approximately 14 % after a freeze-thaw cycle, which approximately corresponds to; wth = 0.8w – 1.5 the decrease of the water content has no correlation to the depth below ground surface, in contrast, there is a strong correlation between the undisturbed soil water content and the magnitude of the decrease in water content the soil liquid limit decreases after a freeze-thaw cycle, simultaneously as the relative share of clay and fine silt grains decreases while the relative share of more coarse grains increases the coarser and denser soil created after a freeze-thaw cycle obtains an increased preconsolidation pressure and an increased undrained shear strength. / QC 20100721

With a foundation in social sustainability, and with the theoretical framework of transport justice and transport poverty, the aim of this thesis is to create a profile picture of the future potential travelers on the North Bothnia Line in Sävar, Robertsfors and Bureå. Both a quantitative and a qualitative analysis are performed. The quantitative analysis describes the population structures concerning age, gender, educational level, employment, household type, income and cars per 1000 inhabitants. The qualitative analysis consists of an interview study, conducted in Robertsfors, with 47 informants. The interview answers are analyzed through content analysis, and presented in personas for each age group. The three areas differ in population structure, which could have different implications on the future travel. In the planning for a socially sustainable travel with the North Bothnia Line, focus needs to be directed to the young travelers, in particular the high school youths. Families with children are facing constraints when trying to manage sustainable travel, therefore, how to create a socially sustainable travel for this group is important to consider in the planning. Young adults, as well as individuals that are unemployed are vulnerable groups, important to consider. The senior travelers have another travel behavior, compared to the population of working age, but still have their needs connected to travel. The informants are positive about the North Bothnia Line, positive about train as travel mode, and intend to use the future train. They expect that the train will lead to easier and faster transportation and work commuting, increased access to schools and jobs, population growth, open up for more opportunities, and that people do not have to own a car. The greatest needs are; a good timetable, with many departures, matching the work schedule. The train has to be on time, and the ticket price not too high. Both the train and the station have to be easily accessible, supplied with good car parking facilities with engine heaters, and the train has to go fast. Both the train and the station have to be clean and controlled, and there has to be clear, and digital information. / Norrbotniabanans noder 2